Vacuums
How to Identify and Fix Common Vacuum Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :
Oil filled radiators are low-maintenance radiators. However, a common problem associated with these radiators is that of oil leakage. This oil leakage can happen due to several reasons. Some of the common causes include a fractured oil gasket, broken weld joints, and damage due to improper storage and handling.
Allowing Oil to Leak From the Oil Heater
Electric oil heaters contain oil within sealed tubes that reduce the risk of the oil coming into contact with sparks or open flames. However, if the heater is cracked or has tipped over so that oil can leak out, the hot oil could catch fire.
Sometimes an oil-filled heater will develop a leak. If you notice a viscous liquid coming from your unit, disconnect it from the power and cease using it immediately. The oil is sealed inside the heater at the factory, and leaks cannot be repaired or replenished.
Development Of Leaks Could Be A Problem
In some situations, it is possible that the oil filled heater might develop a leak. You could see some viscous liquid oozing out from the unit. If it happens you must immediately disconnect the unit from the power source. You also must stop using the unit immediately.
While it might seem easy to ignore a few drops of oil on your driveway, it`s always a bad idea. Left unaddressed, a small oil leak can grow into a larger, much more expensive repair. Plus, if the leak worsens while a vehicle is in operation, it can cause the engine to seize.
Cracked Gasket: The Core Culprit in Most Engine Oil Leaks
More often than not, a sudden oil leak after oil change is caused by a malformed or cracked gasket. Gaskets are usually made of urethane or rubber, and they can harden over time.
Are Oil-Filled Radiators safe to leave On Overnight? Yes, you can leave an oil heater “ON” overnight. Oil heaters are designed to be very safe, modern electric oil-filled heater comes with lots of additional advanced security features such as built-in-timers, tip-over protection, thermostat, and more.
How Long Do Oil Heaters Last? Despite the appliance remaining on for quite some time, oil heaters can last up to 20 years. The life expectancy of an oil-filled heater is directly proportional to the internal temperature of the heating element.
Oil is a combustible material, so no matter where your heating oil tank is located, you`ll have to contact your local fire department immediately. If it`s inside your home, open your windows to ventilate the area. Make sure you prevent anyone from coming near the leak before the fire officials arrive.
The oil filled radiators are filled with diathermic heat transfer fluid. This will not need replacing within the product lifetime.
In the vast majority of cases, the reason there is a wet patch underneath your radiator is because you have a faulty radiator valve. If the internal workings of the valve start to wear out, the valve will not be watertight and water will start to leak out.
If left unattended, a leaking radiator could cause damage to the flooring and furniture within your home, as well as posing a slip hazard. As such, a leaking radiator should be repaired as soon as possible.
Urgency of action required: A large leak on a radiator system will stop once the radiators and heating system have emptied themselves of water and will empty gradually by gravity action, with the speed dependent on the size of the hole.
A car radiator leak can reduce the effectiveness of your entire cooling system. If you don`t get it repaired, it could cause your entire engine to overheat — and that can cost a pretty penny to fix.
The only permanent fix for a radiator leak is to take your vehicle into a repair shop for car maintenance. A trained technician at Thompson Sales will examine the radiator itself, the reservoir, hose, clamps, and any nearby engine components to check for leaking fluid, corrosion, and wear.
If you ignore that oil leak (we`ve all done it – hoping, wishing and praying it will magically disappear), your car will keep running until the oil runs dry. Without it, the engine will be damaged and may seize up. The key is to check the level of your oil. It is the only way to determine if your car is safe to drive.
Will Oil Spilled On My Engine Catch Fire? Straight to the point, the answer is yes. Even though motor oil isn`t flammable, it is combustible.
Light brown to black: Engine oil
If you see a spot that is amber to dark brown or black in color, it`s likely motor oil, says Cars.com. Oil that is older will likely look dark brown or black, says Angie`s List — adding that you`ll typically notice oil leaks directly under where the engine was.
Small oil leak is no cause for concern.
An oil filled radiator is incredibly efficient as it can be moved from room to room; even after it has warmed up. You simply plug it in again and it will continue pushing out heat! You do not need to refill the oil; the heater is powered by electricity.
Oil filled radiators are more economical to run because they retain heat longer and power demand through the temperature control is called upon less frequently. Electric heaters heat only the room you are in and not the entire house, providing extra heat only where required and helping to optimise energy consumption.
A green puddle of coolant under your car is usually the first sign of a radiator leak. In most cases, this leak is small enough that you can add coolant until a replacement radiator can be obtained. Modern radiators typically have aluminum cores (the finned part) and plastic side tanks.
According to Which?, a standard 2,000 watt oil filled radiator uses around 2 kilowatt hours (kWh) of energy for every hour it`s in use.
A green puddle of coolant under your car is usually the first sign of a radiator leak. In most cases, this leak is small enough that you can add coolant until a replacement radiator can be obtained. Modern radiators typically have aluminum cores (the finned part) and plastic side tanks.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
Bathroom oil filled radiator is leaking oil fromthe bottom
ANSWER : Time for replacement. there is no repair for this issue.
Read Full Q/A … : Vacuums
Hoover steamvac when I use it it leaks out of bottom. when it off an water in tank leaks out of bottom,when its off an I pull the triggar it flows big time out of bottom. tank doesnt leak when off sitting with water in it
ANSWER : Let me start out with an apology. I did not ask my question very well – and you did not answer it as I needed.
.If you wish, we MAY be able to communicate in your native language. We can do most indian languages, Turkish, Ukranian and some Russian – as well as Spanish. If any of those are easier for you – please feel free to use any of them.
.
.The Machine storage tanks are 2 – one clean water, one dirty water.
.I understand that, when OFF, no leaks happen.
.I understand that when on a leak comes from “the side”. Also, water comes from the bottom.
.
.So, water comes out near the bottom brushes (even without trigger). Then, with trigger, MUCH water comes out near bottom brushes. Am I correct so far?
.
.Water out the side concerns me. I am guessing that the bottom of the clean storage tank may have a small leak.
.I am also guessing that the trigger valve (located in the small opening behind the black rubber seal that the clean water tank rests on) is not closing all of the way – or is broken (cracked).
.
.Can you please remove the clean water tank and inspect the trigger valve with a torch (flash light). Can you see it open/close as you operate the trigger? Is it broken, cracked, or dirty?
.If yes then it must be replaced. If no, the the storage tank is bad and must be repaired.
.
.You inspect all of these things and you should be able to determine the failure. THEN, I an help you repair the failed item.
.-Jim (Raleigh, NC – USA)
.If you wish, we MAY be able to communicate in your native language. We can do most indian languages, Turkish, Ukranian and some Russian – as well as Spanish. If any of those are easier for you – please feel free to use any of them.
.
.The Machine storage tanks are 2 – one clean water, one dirty water.
.I understand that, when OFF, no leaks happen.
.I understand that when on a leak comes from “the side”. Also, water comes from the bottom.
.
.So, water comes out near the bottom brushes (even without trigger). Then, with trigger, MUCH water comes out near bottom brushes. Am I correct so far?
.
.Water out the side concerns me. I am guessing that the bottom of the clean storage tank may have a small leak.
.I am also guessing that the trigger valve (located in the small opening behind the black rubber seal that the clean water tank rests on) is not closing all of the way – or is broken (cracked).
.
.Can you please remove the clean water tank and inspect the trigger valve with a torch (flash light). Can you see it open/close as you operate the trigger? Is it broken, cracked, or dirty?
.If yes then it must be replaced. If no, the the storage tank is bad and must be repaired.
.
.You inspect all of these things and you should be able to determine the failure. THEN, I an help you repair the failed item.
.-Jim (Raleigh, NC – USA)
Read Full Q/A … : Vacuums
Water leaking out from bottom of 7901
ANSWER : That part can go bad, but I have found more often the a water line came loose. Take out the 6 screw and the flow indictor cap, remove the top, then inspect that area. If you find what the problem is, fix it then when you put the top back on, make sure the piston is on the bottom of the smart mix valve and that the knob is in the water only spot, then push the top back on. If you need to replace the auto-load receiver, the part # is 2140710 and you can order from a local repair shop.
Read Full Q/A … : Vacuums
Bissell spotbot: leaking the dirty water from bottom. I took the bottom plate off and there is a really crappy rubber seal. I think it is leaking from there.
ANSWER : I had the same issue. After some research, I determined I was missing a black “duckbill” gasket on the bottom of the dirty water collection tank.
.
.This caused reduced suction, and for the water to pool at the botom of the spotbot, thus leaking.
.
.I purchased the gasket at Bissell for 1.39. The part number is 203-6646.
.
.I purchased my SpotBot new from Target, and never remember seeing this black gasket, but the difference is night and day.
.
.This caused reduced suction, and for the water to pool at the botom of the spotbot, thus leaking.
.
.I purchased the gasket at Bissell for 1.39. The part number is 203-6646.
.
.I purchased my SpotBot new from Target, and never remember seeing this black gasket, but the difference is night and day.
Read Full Q/A … : Vacuums
Leaking My new hoover steamvac with clean surge is leaking. As soon as I fill liquid into vaccum cleaner, it leaks withing 2-3 minutes. It makes my whole carpet wet…
Sangeet
ANSWER : My machine leaked badly BUT it was my own fault. There is a one-time.only setup procedure where you squeeze the trigger and push the.Clean-Surge button to lock a rod into place. Push the Clean-Surge.button VERY HARD. There will be a loud SNAP which sounds like you broke.something, but you didn’t. I didn’t push hard enough initially, all I.got was a click which I thought was enough. My machine leaked so I.called the help line. They told me to push the button harder, and sure.enough, they were right. Until you get that snap, the Clean-Surge.(which releases a little extra water-cleaner solution) is on all the.time, hence the leaking
Read Full Q/A … : Vacuums
Water leaking When I fill the canister portion with hot water and put it in my machine it immediately begins to leak out the bottom. It has just started doing this. Do I need to take it in for repair?
ANSWER : The water tanks on this unit have had a very bad history of leaks. Most of the repair people had never heard of this unit, but one did, and had a spare set of tanks. If the unit is still under warranty, it is worth your while to get a replacement unit. Call Eureka, and ask them how to get a replacement unit, especially if you are having more than one issue with the unit (such as leaking, no heat, broken upholstery nozzle, etc.). I had success in sending back the serial number plate and a detailed list of my problems. They sent me a new unit, and I was able to get at least one unit working properly. Some repair men may be able to fix leaks in the seals on the tank. Hold the tank up and if it leaks, well you got your problem! Eureka will not solve your problem, I’ve discovered they like to let their service depots handle their junk. Most service depots can give you a solution if they are worth their salt. If the service depot can still get tanks, go that direction. If no replacement tanks are available, call Eureka for a whole unit.
Read Full Q/A … : Vacuums
Hoover steamvac F7226900. Bottom of clean fill tank cracked, how do I take off the black plastic piece around the bottom of the tank without breaking it? Thanks!
ANSWER : Try this link below
http://www.ereplacementparts.com/hoover-f7226900-steamvac-parts-c-37315_37419_202371.html
http://www.ereplacementparts.com/hoover-f7226900-steamvac-parts-c-37315_37419_202371.html
Read Full Q/A … : Vacuums
Clean solution leaking out the bottom
ANSWER : If you don’t put back the tie-wraps that secure the hoses, it will leak.
Read Full Q/A … : Vacuums
