Vacuums\015 My vacuum smell burnt… I thought at first it was because the belt needed replacement so I bought a new one and replaced it but when I vacuum I can still smell burnt and notice smoke coming out of it. So, I paid close attention where its coming from and I notice that it is not coming from the same side where the belt is located but on the opposite side which look like where you switch on and off. I’m on a limited income and can’t afford a new vacuum or get it fix so I’m hoping someone can tell me how to fix it. I’m fast learner if someone can walk me through it would appreciate it. Thanks.\015

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

Several things cause a burning smell, such as a motor part is that broken or worn out, the motor is running too hot, you suck up a burning cigarette, or the rubber belt has snapped. The belt helps turn the brush roller that helps guide dirt and debris into the vacuum.
If you`re smelling rubber, the belt has either burned out and snapped or the belt has become so stretched out that the roller is not moving and the vacuum belt is getting super heated from the motors RPM.
Problems can occur when overused or clogged filters cause the vacuum motor to overheat. This not only shortens the motor life but causes a loss of suction. In some cases, total motor burn out can occur.
A clogged filter in a Dyson vacuum can create a muffled sucking sound or a high-pitched squealing during use. Additionally, as the filter fills with dirt and debris over time, all the built-up debris begins to emit a burnt-smelling odor. You may need to remove and clean out the vacuum`s filter.
A strong odor from the shellac that coats the copper coil windings is an indicator that the motor is about to or has burnt out. If the motor is still running, even if it turns on and off by itself as it is heating and cooling, you can still run the motor until it gives up for good.
If you notice a burning rubber smell from cars, it is often a sign that you have overheated the brakes or tires. Overheating usually occurs when your car`s clutch is slipping or not working properly. If you experience this smell and were using your clutch at the time, let the car cool down, and try again.
How long do vacuum cleaners last? According to Consumer Reports, vacuum cleaners last a median of eight years. But the lifespan varies wildly by not only brand but your own personal use.
If there is something that has become caught in the hose in another part of the system, the airflow will be reduced and can cause overheating and a shut down. Clear out hoses, attachments, and brushes of any hair, dirt, and debris. This will allow for restored airflow and should get things going again.
When a thermal cut off activates, it shuts the motor down. This prevents the motor from overheating to a point where it will no longer function and will need replacing.
Q: It smells like the belt is burning. What is wrong? A:It is likely the belt isn`t turning freely on the brush roll. Flip out the belt lifter handle and turn it clockwise until the green arrows line up.
If there is a strong burning smell coming from the motor area of your Dyson DC14 or DC07 then it is most likely that your motor has burnt out.
Belt is Broken or has Debris

The main reason why a vacuum may be emitting a smell of burning rubber is a broken belt or an object is suck. Excess hair or fur caught around the roller brush can also cause this issue. Turn off your vacuum and let it cool before doing anything.

Start the engine and spray

Scope out all the vacuum lines under the hood. Then start the engine and spray each connection with a light stream of water. If a connection sucks in the water, you`ve found your leak. A vacuum leak can cause a rough idle, high rpm, poor gas mileage and even trigger a check-engine light.

According to experts, a burnt plastic odor could be a sign of worn-out brake pads and is one of the most common causes of a car`s burning smell.
So, if you have just nailed several donuts in your car, then the smell of burnt rubber will linger for a few days, if not then you need to investigate and find out why your car smells like burnt rubber, To make your life easier, My Car Needs A have created this post to help you find the problem.
Burning smell can indicate motor damage

If you suspect that the motor is damaged, you should not continue to use the vacuum cleaner! The cause of motor damage is usually wear and tear or damage caused by prolonged improper use (e.g. overheating). In most cases, it is not worth repairing.

To disinfect your vacuum, remove the attachments as normal and rinse them well with hot water. Next, add 1 Tbsp. bleach to a spray bottle filled with water. Spray the solution on any pieces you want to disinfect, then let them air dry.
Rinse the filter

Any fine dust remaining in the filter can usually be removed with a gentle rinse under a cold tap – hold the filter under the running water until the water runs clear. You shouldn`t need to use any detergent – just water.

2. Vacuum: If you prefer to vacuum up your scent (as you would vacuum up everyday dust and dirt), you can simply sprinkle a teaspoon of your vacuum scent onto the floor, and vacuum up the particles directly.
The average life expectancy of a mid-range vacuum cleaner is about six years. You can fix or replace things like blocked filters, jammed brush rolls, frayed hoses, worn-out stick vac batteries and broken accessories yourself.
“We would recommend vacuuming at least once or twice a week—and more often if we have pets—with the right tools to remove dust quickly and effectively,” Patel advises.
Check the power unit reset button located above the power cord. Pressing the button should restore operation. NOTE: The reset button is located on the upper left-hand side of the unit where the low voltage wires connect to the unit.
Once all of the checks have been done allow the cleaner to cool down which is usually around 45 minutes. Once its cooled down and plugged back in it should start to work again as the cut out is designed to automatically reset.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

Dirt devil vacuum cleaner–trouble vacuuming dirt and pet hair on carpeting –is the problem with the spinning brush which contacts the floor,  not contacting the carpeting??  I thought (when I bought this vacuum) that the aforementioned brush was adjustable to various heights of carpeting.  Sometimes, it seems like nothing is being vacuumed up –unless I have just put a new bag on the vacuum… Do I need or can I replace the spinning brush on the bottom of the vacuum so it kicks up and vacuums
ANSWER : Try replacing the belt. Rubber belts stretch out after about a year.

Read Full Q/A … : Vacuums

My dirt devil vacuum cleaner is not working – Dirt Devil M130000 ''i'' Dual Cyclonic Upright Vacuum Cleaner Vacuum
ANSWER : Please specify whether the vacuum motor does not turn on when you flip the switch or it simply does not have suction.

Read Full Q/A … : Vacuums

Dirt Devil Jaguar Bagless Upright Burning Smell
ANSWER : Take the belt off again you will see burnt rubber from the old belt stuck to the motor shaft.you can take a fine piece of emery cloth and clean the shaft down to its polished finish.always good to do this after each belt.check the brush roller and see if there are any signsd of plastic melted.make sure it turns freely if not the brush roller might be siezing uo on youhave you cleaned the hepa filter?does it smell like wires burning or rubber.with it unlugged take it apart to the motor and take a fine iece of emery cloth and go over the motor armature .then try it again.you can take all the filters out and run it without the filters.that will help you narrow it down.please leave feedback

Read Full Q/A … : Vacuums

The original belt on my upright Kenmore Progressive broke and I replaced it with the spare that was in the vacuum. The vacuum and spare belt are about 10 years old. Then the spare broke after one vacuuming session and there was a burning smell coming from the vacuum. I ordered new belts and replaced it with the new belt. It seems to be working fine with no smell. I checked the belt after I vacuumed the family room and although it was in tact, the belt was very hot. Is that normal? Should t
ANSWER : The belt heats up due to the friction, as well as being in contact with the shaft of a hot motor. It is normal.

Read Full Q/A … : Vacuums

The Dirt Devil Featherlite vacuum cleaner throws up the dirt back out. Sometimes the vacuum cleaner doesn’t pick up any dirt
ANSWER : You have a blocked vacuum hose take hose off and out side. Push the garden hose from one end to the other, this will push out the blockage

Read Full Q/A … : Vacuums

I have a Kirby G4 Vacuum Cleaner – MOdel G4 D. I have never had any problems or repairs done to it in the past ten plus years that I’ve had it. This is an upright vacuum. I was vacuuming the carpet floor and was not having any trouble at all. I switched the vacuum off and moved it into a different room. When I tried to turn on the vacuum, it would not turn on. I checked with different outlets, used both front attachment and hose attachment. Checked the front part of the motor/ spiral case. This
ANSWER : Hello,
.My educated guess is that it’s either the switch or the power cord. Here are a couple of guides to help with diagnosis and repair…
.
.http://reviews.ebay.com/COMMON-PROBLEMS-WITH-THE-KIRBY-VACUUM-TROUBLESHOOTING_W0QQugidZ10000000003800312
.
.http://reviews.ebay.com/REPLACING-THE-POWER-SWITCH-ON-ANY-KIRBY-G-SERIES-VACUUM_W0QQugidZ10000000003752018
.
.Hope this helps!!
.Marci

Read Full Q/A … : Vacuums

I have a Kenmore canister vacuum – model 25614506. Some time ago, I was not able to turn the vacuum off with the on/off switch, but could still use the vacuum. Turned if off/on by pulling the plug. The other day when I went to plug it in, I heard a pop. Now the sweeper runs but the vacuum cleaner does not **** – no air flow. What could be the problem. The cleaner is only 4 years old.
ANSWER : The motor has an inline fuse

Read Full Q/A … : Vacuums

DIRT DEVIL VACUUM 4 MONTH OLD AND HOSE SPLIT TOOK BACK TO ARGOS TRIED TO INFER IT WAS MY FAULT ENYONE HAD THIS PROBLEM ? THE STRETCH HOSE SPLIT AND I HAVE NOT HAD THIS HAPPEN WITH ENY OTHER CLEANER THE SALES GIRL IN ARGOS SAYS THIS WAS MY FAULT . DIRT DEVIL VACUUM DDCYLBG5 BAGGED CYLINDER G TABERN.
ANSWER : From the Argos website… they must repair or replace or refund, up to 1 year. The squeaky wheel gets the grease, go over her head.. .If there’s a fault with the product…
.We’ve made it easier!
.

    .

  • If you bring it back to us within 30 days with your proof of purchase*, we’ll give you a
    replacement or a refund. .
  • If you’ve had the product for up to 1 year, we’ll repair the product or, if that’s not possible, give you a replacement or, if that’s not possible, a refund. .
  • Please note that all large kitchen appliances are excluded from our 30 day guarantee, but if your item develops a fault within 30 days, call us on 0845 640 0800 and one of our agents will assist you with your problem. If faulty and if it cannot be repaired we will arrange a replacement free of charge or you can opt for a refund. .
  • This does not affect your statutory rights.

Read Full Q/A … : Vacuums