Eureka Oxygen s 6992 Bagged Canister Vacuum\015 The plug connection between lower wand and the motorized nozzle seems to be partially burned out and does not maintain contact. Therefore, the nozzle works for a few seconds and stops. Can I purchase the cords I need? Is it possible to replace the cord on the motorized nozzle? I don’t see the cords on the list of parts available to purchase. Our local vacuum shop would not fix it. Thank you.\015

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

To reset the thermostat, press the vacuum`s power button into off position and unplug the vacuum. Check the vacuum for potential causes of overheating, such as clogs or a full dust cup, and allow the vacuum to set and cool off for 30 minutes before turning it back on.
You will find your model number on a metallic silver sticker. It`s usually located on the back or bottom of the vacuum cleaner.
Eureka upright vacuum cleaners come in bagged and bagless designs to suit the needs of all homeowners. Each of these vacuum cleaner styles require regular filter maintenance in order to keep filtration levels at their max, and consistently remove allergens from in-home air quality.
Wipe the inside of the canister with a dry microfiber cloth. Wash the canister in the sink with warm soapy water. Rinse away all soap suds. Let the canister dry completely before replacing it.
First, test the power switch for continuity to ensure that the brushroll motor is getting power. If the power switch has continuity, ensure that the motor turns freely and is clear of obstructions. If power is getting to the motor, and the motor turns freely, but the motor still won`t run the motor is likely defective.
The Dyson is slightly easier to maintain and has no recurring costs, while the Eureka has a HEPA filter that needs replacing on occasion. The Dyson is a bit more maneuverable overall, but its strong suction force can make it harder to move around on carpets.
Founded in 1909 in Detroit, Michigan Eureka vacuums have been in American`s homes for more than a century. Now we`re building on that experience with innovative cleaning technology to help you clean for years to come.
Any fine dust remaining in the filter can usually be removed with a gentle rinse under a cold tap – hold the filter under the running water until the water runs clear. You shouldn`t need to use any detergent – just water.
Locate the filters on your Eureka Power Speed vacuum. There may be a HEPA filter and a foam filter. Remove the filters and tap them gently on the side of a trash can to remove any excess debris. Rinse the filters in warm water and gently squeeze out any excess water.
Clog located in the vacuum hose

Turn the unit on and feel the suction at the end of the hose handle. If there is no or low suction, then the clog is in the hose. You can remove the clog by running a long, stiff object through the hose, such as a butter knife, starting at the wall end.

Simple: the bag or canister is full and the vacuum has nowhere to store the dust it is collecting. Empty the canister or bag. If that doesn`t fix it, the vacuum filter needs to be cleaned or changed.
A canister vacuum will last you eight or more years. Most vacuums in this category are a bit like upright models but feature a larger, more robust body at the lower portion of the machine.
According to the Eureka wiki (https://github.com/Netflix/eureka/wiki), the Eureka 2.0 has been discontinued. The open source work on eureka 2.0 has been discontinued. The code base and artifacts that were released as part of the existing repository of work on the 2. x branch is considered use at your own risk.
Inspect the belt to see if it is broken, stretched out, or out of place. If the drive belt is broken or stretched out, replace it. If the brushroll is sticking, it will cause too much friction and put too much strain on the belt. Remove the brushroll and clean all hair, string, and lint from the brushroll bearings.
Introduction. This guide walks you through removing the Eureka SuctionSeal 2.0 Pet vacuum`s thermal fuse. You may find this guide useful if your vacuum isn`t starting and you have already tried resetting the thermal fuse.
There are varying degrees of quality and value when it comes to vacuums; if you paid a lot for the appliance, repairs are likely worth it, but we recommend that you don`t spend more than half of the original price for any repairs.
A strong odor from the shellac that coats the copper coil windings is an indicator that the motor is about to or has burnt out. If the motor is still running, even if it turns on and off by itself as it is heating and cooling, you can still run the motor until it gives up for good.
One of the easiest ways to increase vacuum cleaner suction is to empty the dust bag or container. Dust containers need to have enough space for airflow, otherwise, they could get clogged and have less suction power. Regularly check your dust compartment and empty or change it when it`s already 70-80% full.
Whether you`re cleaning carpets, rugs, or hardwood floors, this floor vacuum gets the job done, and with the included crevice tool, dusting brush, and upholstery tool, pet owners can easily tackle pet hair and dander on any surface.
Dyson`s competitors

Electrolux is a manufacturer and distributor of home appliances. The Bosch Group is a global supplier of technology and services that operates in four business sectors: Mobility Solutions, Industrial Technology, Consumer Goods, and Energy and Building Technology.

Eureka products are made available from our Wuxi, China; Gothenburg, Sweden; and Ohio, USA stock. Our packing and boxes has been carefully designed for best product identification and to minimize logistic and retail handling costs.
The best vacuum ever constructed on Earth was done at CERN at reported to achieve a density of about 1000 atoms per cubic centimeter. While this is astonishingly low, it is still over 2 million times more dense than interstellar space!
A reasonable cost of living

This is due to the city`s proximity to large agricultural areas and its relatively inexpensive housing. The city`s median home price is $362,600, which is way lesser than California`s median home price of $600,000.

Eureka rose to prominence competing on the ninth and tenth seasons of RuPaul`s Drag Race. She was removed from the ninth season due to a knee injury, becoming the first contestant in the history of the show to be sent home due to injury; she was then given an automatic berth to season 10, where she placed as runner-up.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

Cords for an Eureka Oxygen 6992A
ANSWER : Yes, that short cord in the power nozzle can be replaced and BOTH wands should also be replaced, not just the one that appears burnt. If your locan vac shop won’t fix it, contact Eureka at the customer service number on the bottom of your vacuum. They will most likely set you up with the correct parts.

Bosch canister vac BSG81313. Took cover off to remove lots of hair, dirt etc from running without bag in place. Everything went back together OK, but cord reel spring went zip when cover was removed. How do I rewind the spring so there is tension when the cord is pulled out ? Wound cord back onto reel, but reel just clicks ever revolution etc…no tension when cord is pulled out of vac.

Bob

ANSWER : The spring inside the hub of the cord wheel has escaped from the locking tab. You must completely dismantle the vacuum to access the cord wheel – take it out, reattach the spring and reassemble the unit. All you need is a phillips screwdriver, a pair of pliers and some patience.

I own an Oreck 2310RS upright vacuum cleaner. The cord is too short for my needs. The cord I need is a two wire 25 to 30 foot cord. Where can I buy this vacuum cord and how do I connect it? Thanks, Don
ANSWER : You can buy one at a oreck store but i would tell you to use an extention cord

Cord rewind The power cord is jammed and won’t go in or out. I can’t find a way to get the cover off to have a look at it. Any suggestions please?
Power cord jammed won’t go in or out. Can comeone tell me how to undo the casing to get to the power cord?
ANSWER : Which model do you have..

How to wind cord onto spring loaded retractable cord reel for a Kenmore canister vacuum. There is a metal ‘U’ shaped, spring loaded, piece that fits over the outer aspect of the wheel. If cord needs to get wound on under this metal band I can’t figure it out and the band is like factory sealed onto the wheel. Also. I don’t know which direction to feed the cord onto the wheel
ANSWER : What is the exact model # please?

Thanks!!

Miele Red Star model S314. Cord reel is stuck. About three feet of cord is out. The rest of cord is jammed inside machine? How do I get to where the cord reel is?
ANSWER : It is actually simple when I tell you, Here we go…
.
.First, open the lid and take the bag, and hepa filter out of the machine.
.
.With a slot screwdriver, pry the hinges of the bag door out a little and take the bag door off.
.
.You should see one screw holding the black black panel, remove that. When that is out, you can pull the black panel off. It will give a little resistance to you, do not be afraid of breaking it, it will come off.
.
.Next you will see 4 or 5 screws down the holes there, remove all of them and the final remaining red piece will come off. When you pull this off, it will have both the cord rewinder and the motor assembly attached to it. It will be heavy becasue of the motor. Before you pull out the cord rewinder, just have a look at it closely and you may be able to just fix it without removing anything else.
.
.good luck with it.

I have a hoover upright bagless – turbo power 6500 The cord has been run over and I just noticed white stuff on the cord where it is tattered. My husband said he saw it 6 months ago and never said anything! Anyway, what is that white stuff in the cord? Is it dangerous in any way? Is it insulation? What is that usually made of? Just concerned since the cord is dragged over the floor and my little boy constantly has his hands and face on the floor. Thanks. Worried mom
ANSWER : It can be potentially dangerous. What you see is the cord insulation, if you move that a little you can see the power wires. They are coated and cannot hurt you if not damaged. If i were you i would wrap it in electrical tape or best thing would to get it replaced. You can replace it your self. Order the cable from Sears Parts store(link to your model)then your husband can install it. But not to sound rude if he didnt say anthing about that damaged power cord he may not be the right person for the job. He should have known it could be dangerous and thankfully your child wasn’t hurt or you two either.
Here is the part number (Part# 46383334) and it will cost you about $20 plus shipping. The cord is item number 63. Let me know if you have further questions./

Have an older model Electrolux canister model. The electric plug is broken so I got a new plug to put on. When I cut the cord to replace the plug, the dang cord retracted into the unit. So how do I get access to the cord area so i can find the end to the cord!
ANSWER : Hi,.
.You have to open the vacuum cleaner and look for the wire..
.It is located inside the circular wheel, where it wind itself up..
.Don’t be afraid to open it, unless your willing to pay somebody just to install a 1$ part..
.Just always remember when taking the screws off and make sure you don’t lose any of them..
.
.Hope that helps you out!.
.
.Thanks for using Fixya!