Dyson DC07 Bagless Upright Cyclonic Vacuum
How to Identify and Fix Common Vacuum Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :
“Most Dysons can be repaired,” says James Gunter, founder of The Vacuum Wizard , independent specialists in Dyson handheld vacuum cleaners and spare parts, in Keynsham, Somerset.
This is an indication of how good the vacuum cleaner is to clean – i.e. the work to be done. The suction power is measured in Watt (W) and is typically between 250 W and 450 W for machines with 1 motor.
(don`t use detergent or wash in a dishwasher or washing machine). Rinsing under the water supply then gently squeezing the water out of the filter. Repeat until the water runs clear.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
.I have made a video of the two most likely causes for lack of suction in the handle of your dyson DC07. Watch the video and see if it helps. The other thing to check is your washable filter, this can cause a big resuction in suction if dirty. If this is helpful take a moment to leave a testimonial or a thumbs up please.
.Hope your back to full suction soon. 🙂
Assuming if you leave it for an hour and come back to it that it works again you have an airflow issue. This machine will cut out if the motor gets too hot. The likely causes are 1. Filters – take them out and give a good clean once dry you can try them again. 2. Blockage – Remove your u-bend and the blockage removal access check for an obstruction.3. Radix assembly is blocked. I will post a link to a YouTube video showing how to address this as it is a bit more difficult.
If your machine wont turn back on after a rest then your options are 1. Cord problem (most likely)2. Switch (unlikely)3. Motor
I have a video for just about all these problems on my youtube channel under VacuumSpot or VacuumSmart. If this is a step in the right direction please lay a thumbs up on the videos 🙂
If you need parts for your dyson in Australia check out VacuumSpot
I suspect the belt you are to refering to is the one from the clutch to the brush bar. Unfortuenately the other belt is hidden under a plastic cover, so you cant see if it is okay or not without some dismantling. This cover is not easy to remove and requires a Torx driver to under the securing screws.
Have a look at www.dysonmedic.com, but unless you have access to such a tool, probably time to call Dyson or a Vacuum repairer.
If you are experiencing a drop in performance, please follow the full diagnostics outlined in the support section on our website at www.dyson.com.
If this does not resolve the issue, please contact our Helpline on 0800 298 0298 (UK) or 1866MYDYSON (US).
Dyson Customer Service