Samsung Vacuums

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

When the red light on the display part of the Jet cleaner lights up, it is recommended to check the condition of the dust bag and filters. You can easily remove the filter to check the assembly or clean it to resolve the problem.
The most common problems found in vacuum cleaners are low suction force, excessive noise, burning smell, vacuum not turn on, and overheating. These issues can be fixed by either cleaning the device or replacing some parts of the device. At times, it is best to seek a professional to fix the cleaner effectively.
Pulsing red:

The battery needs to be charged. Leave the robot on the base. If it`s still not fully charged after 3 hours visit Why does my Roomba® or Braava® not turn on or charge properly?

The easiest way to fix the red light flashing on your Samsung TV is to reset it. All you have to do is unplug the TV and wait 60 seconds. Press and hold the power button for 30 seconds while the TV is unplugged. Try turning it on, it works all the time.
You can check the battery level indicator displayed whilst charging. *The battery level indicator blinks while charging. When charging is complete, the blinking stops and the light level dims.
Check that the vacuum cleaner is plugged into a working power outlet and that fuses and breakers don`t need resetting. An activated thermal cut-out due to a blockage is the next most likely cause of the problem. Check for blockages in the hose and filters, and remove any obstructions that you find.
The average life expectancy of a mid-range vacuum cleaner is about six years. You can fix or replace things like blocked filters, jammed brush rolls, frayed hoses, worn-out stick vac batteries and broken accessories yourself.
Start the engine and spray

Scope out all the vacuum lines under the hood. Then start the engine and spray each connection with a light stream of water. If a connection sucks in the water, you`ve found your leak. A vacuum leak can cause a rough idle, high rpm, poor gas mileage and even trigger a check-engine light.

As a general rule, if the repair is going to cost less than half the cost of a new vacuum cleaner, it`s best to go ahead and get it repaired. When the service tops half the price of a new machine, it`s probably best to invest in a newer model.
Short answer, the manufacture decides to either to add or not add a light. A light does help in showing if the carpet is clean or not. Most older vacuums and many higher priced vacuums have lights.
Light Ring While Idle

Solid white: Fully charged. Pulsing white: Charging. Pulsing red: Charging, too low to start cleaning. Solid red: Error (tap Button for details).

With the Accessibility Shortcut feature, you can triple-click the Side, Home, or Top button on your iPhone or iPad to switch between the standard screen and red tint. To set it up, go to the “Accessibility Shortcut” menu at the bottom of the Accessibility settings. Choose “Color Filters” from the list, and you`re done.
a) Using a blow dryer to heat up and expand all of the outside of the housing until it becomes noticeably warm to the touch. Then knock it with a hammer and remove with the filter housing wrench. b) Use two filter housing wrenches together, one for each hand and twist the housing with both wrenches.
If you cannot remove the filter, you have objects jammed inside and may need a service engineer to come and remove them.
This clogging will reduce the effectiveness of the vacuum and make it less able to pick up debris and dirt, and if the filter is not replaced regularly, it can release dust and other allergens back into the air, creating an unhealthy environment for asthma and allergy sufferers,” explains Mathew Morris, owner of Go …
Your filters get clogged with bacteria, dust, smoke, mold, and other particles. These can all affect the air quality in your home as well as the performance of your vacuum`s cleaning abilities, if the filter is clogged you will find the suction and general performance of your vacuum will be minimized.
Malfunctioning Alternator

As a result, you will likely see the battery light flashing on your dashboard. One of the most apparent signs of a failing alternator is when the output voltage drops on your car battery when you start the engine.

Fast flashing indicates a poor connection between the battery and charger or a problem with the battery pack. Refer to the rechargeable battery does not charge properly using the supplied battery charger article for details. Afterwards, try charging the battery again.
A strong odor from the shellac that coats the copper coil windings is an indicator that the motor is about to or has burnt out. If the motor is still running, even if it turns on and off by itself as it is heating and cooling, you can still run the motor until it gives up for good.
There are varying degrees of quality and value when it comes to vacuums; if you paid a lot for the appliance, repairs are likely worth it, but we recommend that you don`t spend more than half of the original price for any repairs.
The most common problem with a vacuum cleaner is also the easiest to remedy: clogs in the hose or attachments. Also the electrical cord, motor, switch, fan, brushes, and motor bearings can all need repair or replacement. The drive belt may need replacing; and the attachments, hoses, and filters may need unclogging.
On average, a well-maintained robotic vacuum cleaner can last up to 4-6 years, but some models may last even longer.
Vacuuming every day, or even a few times a day, is not going to create any long term problems. `But,` you might be thinking, `doesn`t the brushes spinning over the carpet on a beater bar wear it out? ` Sure, but a very small amount.
If you don`t vacuum your carpet, the dirt will break down carpet fibers and create a breeding ground for dust mites and bacteria. In addition, your home will begin to smell musty from the dirt, mites, and other organisms settling into the fibers.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

I have a Z345 Electrolux cylinder vacuum cleaner, from the 1970s probably, but not used much. I have lost the guide. I forgot to change the bag before it was full. Smoke started to come out – smelling of burnt paper, not rubber. So switched off. It did not blow the fuse, and may be OK. I wish to inspect it. How do I open it up?

Alos I have an air filter and a motor filter for it. I have often changed the air filter on the top. How do I get at the motor filter, if there is one?

Than

ANSWER : Good day!

OK you have to is replaced the bag and that’s it.

And don’t forget to change the bag again to avoid that problem.

Thank you

Read Full Q/A … : Samsung Vacuums

I just received my Hepa filter in the mail today. Product #XSH621 – Hepa filter for EP619 & EP621 :005-04 When bought my vacumn, I was told that the filters were free and all I do is pay Postage. Today I received one filter and it lookes like I got charged the postage for two filters. The packages slips: One stated order #11152282 The other order # 1151940 If I get charged for two I expect to receive two. Can you help me with this matter or where can I go to get resolution. Catherine Fantini e-
ANSWER : This isn’t really a problem that can be fixed here on Fixya rather than advise you as a buyer. You’d have to contact the people/company you have purchased the filters from and take it up with them regarding the postage. Hope you get a decent reply.

Read Full Q/A … : Samsung Vacuums

Miele Cat & Dog vacuum gets VERY hot and is VERY loud. Hose has no restrictions and I have changed the dust compartment (motor) filter and the exhaust filter. It still gets hot when I run it with the top open and all filters removed, so I’m guessing the problem is with the motor. Should I be going into the motor compartment? If so, what am I looking for?
ANSWER : Hi
.
.The fact that it gets very hot could be due to a number of issues.,but the fact that it started making a very loud noise at the same time suggests that there might be more problems maybe brushes etc.
.
.If you could describe the sound it makes like a squeeling or electrical buzzing I know this might be difficult ,but it would help in the diagnosis.
.
.I will try to get more information on the unit ,meanwhile here is the user manual pdf if you don’t have it: http://www.miele.co.uk/Resources/OperatingInstructions/S%205001%20series%20S%205211_5781.pdf

Read Full Q/A … : Samsung Vacuums

I had used Dyson DC08 to **** out a wet car carpet. A few days later when using the V/C, there was a burning smell. Subsequently I washed the flexible hose, changed the pre-filter and post filter , but I wrongly put the pre-filter in the spot for the post filter. When the V/C was next used, there was again a burning smell and sparks. The filters were switched, but the V/C would not re-start.
What shall I do?
ANSWER : Hi there,

We’d strongly recommend against using your Dyson to pick up water. If you haven’t already got in contact with us directly, I’d encourage you to do so. One of our experts will be happy to recommend the best course of action. You can call us free on 08002980298 – our Helpline is open from 7am until 10pm, 7 days a week. We’ll look forward to hearing from you.

Kind regards,

Jack
Dyson Online Customer Support

Read Full Q/A … : Samsung Vacuums

HEPA Filter My vacuum came with a sponge over the filter and the directions said I could wash the filter. Do the directions mean to wash the black sponge or the actual filter? Is the sponge part of the filter or is it trash? Filter F27 Dirt Devil Purpose Cleaner for Pets Upright Bagless Vacuum Model #1LY2108-000
ANSWER : Http://geeksquad.fixya.com/ThreadView.aspx?prdid=618630&thid=730623
.HEPA Filter
.Posted by jenski66 on Jul 02, 2008
.My vacuum came with a sponge over the filter and the directions said I could wash the filter. Do the directions mean to wash the black sponge or the actual filter? Is the sponge part of the filter or is it trash?
Filter F27
Dirt Devil Purpose Cleaner for Pets
Upright Bagless Vacuum
Model #1LY2108-000

.
.Hello,
I would advise you to ALWAYS to FIRST UNPLUG YOUR VACUUM before beginning any service procedure. Typically the top filter of which is the sponge is washable but the HEPA filter is not, it can be brushed off and vacuum off with another vacuum, but the best filtration is to replace the HEPA filter and to wash the sponge filter, if the sponge filter get to bad then replace the sponge filter as well. Or, you can check with your local vacuum cleaner dealer in your area or to contact the manufacturer’s website and or phone #. So if you need further assistance, please feel free to contact your local vacuum cleaner dealer in your area or in the yellow pages, or contact the factory phone number or website to further assist you with your questions.

.http://royalvacuums.com/ Customer Service 1-800-321-1134
.Hours are: 8:00 AM to 7:00 PM (EST)
.Thanks, Don the Vac Man
Go Ahead. Use Us.

Read Full Q/A … : Samsung Vacuums

My electrolux oxygen cannister has the “bag change” light on when there is a new bag. The light stays on when the suction power is high (to pick up small particles) and it won’t pick up, but the ight goes off when the suction power is low (to pick up big objects). I changed the hepa filter, cleaned the motor filter and changed bags, but all that didn’t help.
ANSWER : You may have a clog in the hose, and/or the inlet by the brush roll. A clog will turn on that light as well as a full bag.

Read Full Q/A … : Samsung Vacuums

Bad Motor I have purchased two of the Kenmore direct drive beltless systems with Progressive systems. The first died after a year, the vacuum motor start making a grinding noies. I pulled the side HEPA filter and could see a fine coating of graphite like dust. Took it to a vacuum repair shop. They said the brushes were going and thus the motor was shot. I liked the vacuum and bought a second, 1 year later the motor is making a slight noise that and removing the HEPA filter I find a slight metall
ANSWER : That dust is from the carbon brushes on the motor. You may need to check them, and also clean out the motor compartment. A slight noise could be a motor bearing starting to go. Does the smell like rubber or electrical. If rubber, then the belt has stretched and needs to replaced. If electrical, then something is causing the motor to run hot, like a clogged filter, or it could be a motor going bad.

Read Full Q/A … : Samsung Vacuums

Filter queen masjestic vacuum cleaner has a light that should light up when the filter needs changing, it doesnt want to light up. I dont think its burnt.
ANSWER : That is a overhead light not a filter light. If your waiting for the light to come on before changing your filter or haveing the vacuum serviced your going to kill it. Every time you empty the container you should replace your white filter come and ONLY use genuine filter queen cones the aftermarket cheap-os will burn up your vacuum.

Read Full Q/A … : Samsung Vacuums