How to Identify and Fix Common Vacuum Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :
Check the hoses, the filters, and throughout the vacuum, and clean out any blockages or clogs. Vacuums will likely also have a recommended cooldown time to ensure that the vacuum won`t overheat. You will need to wait for that time before you turn the vacuum back on.
Should the floor nozzle indicator light turn red it is a warning that the brush has become jammed and not turning. Switch the appliance off and disconnect the floor nozzle. Remove the brush by unclipping the release catch on the side and lifting the brush roll out.
The exhaust filter can also get clogged, causing a problem with the motor cooling. Therefore, you should also check the exhaust filter if the vacuum cleaner smells burnt. It is usually located on the top or back of the unit, right where the exhaust air comes out.
e Series Robots: Press and Hold the Home and Spot Clean and CLEAN button down for 20 seconds then release. 900 Series Robots: Press and Hold the Dock and Spot Clean and CLEAN button down until all LEDs illuminate.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
.Generic problem for all Vacuums
.I own a self-propelled Hoover
.Posted by gohornsgo on July 17, 2008
.I own a self-propelled Hoover Wind Tunnel vacuum cleaner (Model U6425-920). I do now have an owner’s manual and was wondering how to clean the HEPA filter on this model (*this model uses a vacuum cleaner bag also).
I would advise you to ALWAYS to FIRST UNPLUG YOUR VACUUM before beginning any service procedure. The best way to clean the HEPA filter is to take it outside and use a blower over the trash can and blow off the dust and dirt, or use things like an old paint brush and brush it off, or you can vacuum it off with another canister vacuum or shop vac if you have an extra one. For the best filtration is to replace it, there fore the air flow will catch most of the dust and dirt and then you would have to watch how fast it gets dirty and then do the maintenance.
.So if you need further assistance, please feel free to contact your local vacuum cleaner dealer in your area or in the yellow pages, or contact the factory phone number or website to further assist you with your questions.
Contact our Customer Service Department at 1.330.499.9499
Monday through Friday
8 a.m. – 7 p.m. EST
.Thanks, Don the Vac Man
Go Ahead. Use Us.
.My educated guess is that it’s either the switch or the power cord. Here are a couple of guides to help with diagnosis and repair…
.Hope this helps!!
.A clog in the hose, UR or canister. Detach hose. Drop small coin in one end and lift hose causing it to roll out the other. If it does, no clog in hose. Drop same coin into hose opening on power head. If it rolls out, no clog in PN.
.Broken fan blades, UR. Needs to be taken to shop for repair/replacement.
.A reset button is for use if the motor isn’t running, so won’t have anything to do with the suction.
.When you get the belt on the the brush and the brush back in place, turn the brush a few times by hand to make sure it’s not catching on anything. After you get the powerhead put back together, do this again. It’s a common problem if the powerhead isn’t assembled correctly.
.Here’s a video clip from the Bissell site demonstrating changing the belt.