Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum\015 My Hoover Steam Vac clean water tank valve leaks as soon as I fill the clean water tank up. I can hold the tank in the air over the sink and see a stream of water running out the valve. The rubber seal looks in great shape and still very pliable, but my guess is that it’s leaking inside the tank where the valve must have a rubber seal I can’t see from the outside. I’ve activated the valve by hand many times and it springs down into the shut position nicely. I opened the valve and shook the tank with warm water in it with the hope of dislodging anything that might be stuck in the valve. None of this has helped. Is there a way to take the valve out of the tank and clean or replace it? Thanks.\015

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

If the tank is full then water will start to leak out. Place the cleaner over a sink and pull the drainage cap out underneath the tank to drain out the water. If the tank is full then water will start to leak out. Place the cleaner over a sink and pull the drainage cap out underneath the tank to drain out the water.
Description. The Hoover SteamVac Carpet Cleaner features high velocity suction that removes dirty water and detergent, leaving carpet revitalized.
Pressure relief and safety relief valves will leak if the valve isn`t fully closed. This is a common problem in industrial settings where environments are often dusty or dirty. If there is any debris in the valve, it can obstruct the valve from fully closing, causing it to leak.
If the pump is leaking water, then either the oil is the wrong type and is leaking out, or the pump has a mass vacuum leak and is sucking in moisture causing the pressure to blow out water through the back valve.
Steam cleaners are particularly helpful for allergy sufferers, because not only do they clean surfaces of dust and other allergens and debris, but they also disinfect and deodorize without the use of harsh chemicals that could trigger allergies, asthma, and multiple chemical sensitivity.
Steam Cleaning

Using carpet extraction is probably the best deep-cleaning method you can use on your carpets. Because it combines hot water with chemicals, it cleans much more than just the surface of your carpet-it can remove dirt and debris that have sunk deep into your carpet.

I boil the water and pour it in carefully—boiling hot. Most home cleaners do not use the power of boiling water, but I do. I have done this for 14 years now, and without any problem.
A first common step to drying carpet is using a wet-dry vacuum to remove as much water as possible. Remember to empty the wet tank before use and remove any dry dust bags if possible. Most wet-dry vacuums will indicate when they`re full and need to be empty again.
A: Yes, you can just rinse your carpet with plain water when using the Hoover SmartWash Automatic Carpet Cleaner. Helpful?
Mix a cleaning solution of 1 part bleach to 4 parts of hot water in a clean bucket. Clean all tools that will come into contact with the water inside the tank. Collect 2-5 gallon pails of hot water for use in cleaning and rinsing your tank.
Part of that`s due to the eventual breakdown of gaskets and hoses. Vacuum leaks come with that breakdown and are just one thing that will start popping up at some point. Dealing with the vacuum leak isn`t usually the problem, they`re fairly easy to fix even for novice wrenches.
Typically, a vacuum leak will cause situations like hard starting, rough idle, excessive fuel consumption, and engine codes. You might even be able to hear a leak – sometimes a whooshing or whistling sound can be heard with the engine running.
There are a few disadvantages to using steam cleaners. One is that they can be expensive. Another downside is that they require a lot of water, which means you will need to empty and refill the tank often. Finally, steam cleaners can take longer to clean than other methods.
When choosing between steam cleaning and shampooing your carpet, you really can`t go wrong with both, but steam cleaning would be the better option. It removes more unseen pests and dirt, and can handle heavy-duty cleaning without making you wait long for drying.
Vacuuming carpets every day is OK. Some households might not need to vacuum as frequently. Still, it depends on the living arrangements, the carpet`s traffic daily, and the possibility of pets and kids treading the carpets. With the appropriate vacuum, you won`t damage your rugs.
Most carpets typically need 6-10 hours to dry completely. However, it could take up to 24 hours to dry depending on the time of year your carpets are cleaned, and the air circulation, humidity and temperature in your home.
Upholstery cleaning generally refers to the cleaning of fabric furniture, while steam cleaning can refer to the cleaning of many different surfaces such as curtains as well. Upholstery cleaning typically uses a detergent or solvent to clean the surface, while steam cleaning uses heat and water to clean the surface.
According to new research, the best steamers (also known as “steam cleaners” or “garment steamers”) can go a long way towards eliminating household germs and bacteria, while helping to refresh clothing, bedding, furniture and everyday accessories too.
It`s an effective way to clean carpets, and it`s also safe for most carpets. Hot water extraction is also great for sanitizing carpets, as the hot water kills germs and bacteria. So if you`re looking for a safe, effective way to clean your carpets, hot water extraction is the way.
The short answer is that you should not use vinegar for carpet cleaning. There is truth to the idea you can use vinegar as a natural disinfectant for cleaning but it cannot remove dirt or soil from a surface or from carpet.
Heat: To effectively sanitize, the steam cleaner must heat the water to 200 degrees. The hotter it gets, the drier the steam, resulting in a lower probability of damaging certain surfaces with excess water.
Does baking soda absorb moisture in carpet? Well, it does! Baking soda is effective in drying wet carpet because it removes moisture. Sprinkling it over the carpet and allowing it to sit for a minimum of 30 minutes will deodorize and dry up your carpet.
Wet/dry vacuum cleaners: Upholstery cleaning

With the wet function of the Einhell wet/dry vacuum cleaner you can effortlessly remove these stains. Simply place the special upholstery nozzle from the accessories on the vacuum cleaner, fill it up to the mark with water and add a suitable cleaning detergent.

When finished shampooing, run a tank of clear water over the heavy cleaned areas (e.g. entrances and walkways). This will help remove excess shampoo and keep those areas cleaner for longer. It also helps to rinse out the shampoo from inside in the machine!

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

Hoover Steam Vac clean water tank valve leaks
ANSWER : A) make sure that there is not a place for a stair attachment. If
.there is make sure air is not leaking through where the attachment goes
.on because of damaged or misplaced fitting.
.
.b) some steam vacs leave water behind them and **** up in front of
.them. If you just walked forwad with the steam vac nothing would be
.sucked into the tank.
.
.c) try taking your finger off the trigger and using the steam vac. If
.the tank still empties the trigger is stuck open.
.
.d) try putting clean water in the dirty water tank only and using it on
.a dry rug. If water goes somewhere from the dirty water tank you have
.a leak.
.
.e) take apart what you can and look at the parts. A good visual
.inspection can solve many of these types of problem if you are careful
.not to miss anything.

My Hoover steam vac dual v clean water and detergent tank leaks water before attached to the vac and during cleaning
ANSWER : This is a common problem with the earlier models which had a separate soap tank glued to the clean water tank. The plastic was too thin beneath the valve on the clean water side and would develop cracks. You most likely will need a new one piece tank. ( Part # 42272104)

Need instructions how to use Hoover Steam Vac Spin Scrub. I borrowed it from my Sister and she left it with no instruction book or letting me know how to operate it. I put water & cleaner in top tank. That’s all I know to do. Do I put any water in bottom tank? I figured not, since that is probably where the water goes when sucked up by vac. Do I leave lid on bottom tank? I usually use a commercial cleaner, and this is very different. I need to know NOW, as I must return it to her today, and I’m
ANSWER : I did have a solution in just a few minutes. Someone responded with a solution that gave me the website where I could go and print the manual in pdf, so did that, and checking instructions I was able to clean my carpets and get the shampooer back to my sister later the same day. I really appreciated your site and help I got for my problem. I found it on google. Thanks again!
.
.[email protected]

I have a Bissell Proheat 2XTurbo carpet cleaner. No water will come out when I squeeze the trigger. I have filled the solution tank and the water tank. I read the troubleshooting in the manual and have tried turning it off for a minute and restarting and nothing. I took out both tanks and reseated them and nothing. It has sat for over a year but did not have any water in the water tank. Some solution was left in the solution tank. How can I make the water come out? HELP!
ANSWER :

Call BISSELL Consumer Services.
.

1-800-237-7691
.

Mon-Fri: 8am to 10pm ET
.

Sat: 9am to 8pm ET

Hoover Steam Vac V2 Deep Cleaner leaking clean water
ANSWER : Fill the tank and determine if the plastic is leaking, or if the valves are leaking. if the tank is cracked, it would need replaced. There is an improved design now available.
.
.You may cycle the valves on the bottom with the eraser end of a pencil.

The Hoover Steamvac Widepath will NOT pick up water. The dispenser with cleaner DOES have water. The TANK that would receive the dirty water is NOT full. All tanks are on properly and the machine will still not pick up the used water. I found a tear in the interior hose leading to the receiving tank and repaired throughly with electrical tape. Still will not pick up the water. Any suggestions?
ANSWER : Sounds like a clogged air path (no vacuum action) from the floor pick-up to the collection tank. Take the tanks off and deal with the vacuum problem alone. The collection tank should have a air exit vent–is it clear? Check the interior hose that you repaired–is it clogged? Remove the bottom plate and inspect the air path from it. Because this machine deals with water, clogs can become like concrete! Hope this helps!

I have a bissell quickwash 1950-e. I bought it Jan. 2006, and have only used it 8-10 times, I live in a very hard water area, so I though if I put some vinegar in with the cleaning solution it would get rid of any hard water deposits, unfortunatly the solution went lumpy in the tank and stoped spraying out water, I have opened it, hose clean, sprayer not blocked, x at bottom of water container when depresed water trickles out, component that opens the x when water container placed, also ran wate
ANSWER : Hard to say what is causing your problem, replacing the cap and insert on the water tank may help, part #2041111, even tho it may trickle out water when depressed, they can still be bad. The other thing would be the rod not relesing the water like it should. The big draw back to this model is Bissell has obsoleted all of its parts and most are no longer available. Might be wiser to buy new.

I have a Hoover Platinum carpet cleaner, and it has stopped dispensing cleaning agent and water. This model has a separate tank for water and separate tank for shampoo dispensing. It also has a power hand unit that dispenses shampoo. All along the hand unit has continued to dispense shampoo. Symptom #1, the water tank seemed to be taking on shampoo, as it was getting sudsy. Symptom #2 – On wash mode, nothing would come out, on Rinse mode, sudsy water would come out. Later, symptom #3 – not
ANSWER : Somewhere on the outlet is a control tap thats driven by a rubber band and something is up with this control ,best advice here is put it in the boot of the car and take iot to a hoover dealer ,they will do it seconds for you