Hoover Floormate H3000 Upright Wet/Dry Vacuum\015 Serial # 039500017182\015

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

The model and serial number are located at the bottom of the back of the cleaner body.
The 1st three numbers of your serial number will always provide your manufacture date. The 1st number is the YEAR of manufacture; the 2nd & 3rd numbers indicate the MONTH of manufacture.
Instead of using a vacuum bag, a wet and dry vacuum cleaner uses two bucket system for separating dry and wet waste. The collection chamber, and motor unit, and are the main parts of a wet and dry vacuum cleaner. The motor of the vacuum cleaner is situated on top of the collection chamber.
The FloorMate® Deluxe Hard Floor Cleaner delivers a deep clean while gently and safely scrubbing sealed hardwood, vinyl, ceramic tile, laminate and marble floor surfaces. With the Dual Tank Technology and specialty brushes for wood, tile & grout you can have a deluxe clean anywhere you need it.
The suction motor creates vacuum pressure and suction by rotating a motor fan. The impeller rotates at an incredibly high speed of about 30,000 to 35,000 RPM. A suction motor`s power is measured by multiplying the rate of air flow and the vacuum pressure, which induces air flow from the brush through the hose. Brush.
Most robotic vacuum cleaners use one or two spinning brushes along with a rolling brush. These brushes collect dirt towards the center of the room, where the electric motor creates suction. Dust, hair, and everything else collected by the vacuum cleaner is sucked and stored into a removable dust container.
It is best to use the Hoover cleaning solution in the Hoover – FloorMate SpinScrub Hard Floor Cleaner. If you decide to use another brand, just be sure not to use a solvent based cleaning concentrates in your cleaner. Also, you cannot use any type of wax in the cleaner.
However, the Crosswave can also be used to vacuum larger debris on both hard surfaces and area rugs. Hoover`s Floormate cannot be used as a vacuum. To remove the brush, simply snap off the protective cover, and then pull the brush along the side “pull” hook.
Noun. floormate (plural floormates) A person with whom one shares a floor in a building.
The three classes are `L`, `M` and `H` (Low, Medium and High Hazard).
To access the rating plate on a Hoover appliance, always open the door of the product, then follow the instructions below. The model number is 8 digits long (beginning with a 3) and the serial number is 16 digits long.
The suction power is measured in Watt (W) and is typically between 250 W and 450 W for machines with 1 motor. The suction power is to be measured at the end of the tube of a complete vacuum cleaner (i.e. with tube, hose and filters – but without nozzle).
A dry vacuum system does not use water to generate suction. A wet vacuum needs significant water flow to generate suction.
The Main Difference Between Wet Pumps and Dry Pumps

Water-based wet pumps use water to seal or lubricate. Oil-based pumps use oil. Dry pumps use PTFE dry polymer seals instead of water or oil. A dry vacuum pump may also have a diaphragm to keep the swept gas away from the mechanism that pumps.

When a dry vacuum collects water, the insides of the vac are prone to get damaged. The dry vacuum doesn`t provide as many functions as the wet vacuum as it can only suck up dry particles. The wet vacuum cleaner is used to suck up dirt, wet areas, or messy incidents like spilt stew you were going to have for lunch.
Hoover Renewal Hard Floor Cleaner for sealed hard floors, Concentrated Cleaning Solution for FloorMate Machines, 32oz Formula, AH30428, White.
The Hoover Floormate is a combination of a vacuum and a mop. It deep cleans and scrubs your floors while vacuuming all the dirt and debris leaving no trace behind. It is safe on sealed hardwood, vinyl, ceramic tile, laminate and marble floors.
The suction motor is one of the most important parts of a vacuum cleaner. It is this motor which takes the electrical power from the power source and converts it into mechanical power in the form of suction with air flow.
A manual sweeper is used to clean floors, just like a vacuum cleaner. It houses a set of rollers which, when pushed along the floor, rotate and sweep dirt into an integrated container.
Self-propelled vacuums are powered by an electric motor that drives the brush roll. These machines are very useful for people with limited mobility as they can easily maneuver around furniture and other obstacles. Browse the top-ranked list of self-propelled vacuums below along with associated reviews and opinions.
They are majorly used to remove dirt and dust from upholstery, carpets, velveteen furniture and floors made of hardwood and many varieties of floors, including laminated floors. They are also used to clean cars and stairs. Based on the uses, Vacuum cleaners are made into different types.
Mattress vacuuming can help control all those allergens, dead skin, dust mites and other yucky stuff in your bed. Just remember it`s essential to use a vacuum cleaner fitted with a HEPA filtration system like our commercial-grade vacuums and follow the tips above.
It`s a good idea to also vacuum the mattress at least once a month. Dust, dander, and dust mites build up in your mattress. Even those of us without allergies can begin to notice dust and dirt in our mattress. Vacuum your mattress using the upholstery attachment on your vacuum cleaner.
When hoovering your mattress, always start at the top and move your way down. For an extremely thorough hoover, I would recommend hoovering your mattress horizontally and then going over the top in vertical lines to ensure your entire mattress is properly cleaned.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

I own a self-propelled Hoover Wind Tunnel vacuum cleaner (Model U6425-920). I do now have an owner’s manual and was wondering how to clean the Hepa filter on this model (*this model uses a vacuum cleaner bag also).
ANSWER : Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=794479
.Generic problem for all Vacuums
.I own a self-propelled Hoover
.Posted by gohornsgo on July 17, 2008
.I own a self-propelled Hoover Wind Tunnel vacuum cleaner (Model U6425-920). I do now have an owner’s manual and was wondering how to clean the HEPA filter on this model (*this model uses a vacuum cleaner bag also).
.Hello,
I would advise you to ALWAYS to FIRST UNPLUG YOUR VACUUM before beginning any service procedure. The best way to clean the HEPA filter is to take it outside and use a blower over the trash can and blow off the dust and dirt, or use things like an old paint brush and brush it off, or you can vacuum it off with another canister vacuum or shop vac if you have an extra one. For the best filtration is to replace it, there fore the air flow will catch most of the dust and dirt and then you would have to watch how fast it gets dirty and then do the maintenance.

.So if you need further assistance, please feel free to contact your local vacuum cleaner dealer in your area or in the yellow pages, or contact the factory phone number or website to further assist you with your questions.
.http://www.hoover.com Telephone
Contact our Customer Service Department at 1.330.499.9499
Monday through Friday
8 a.m. – 7 p.m. EST

.Thanks, Don the Vac Man
Go Ahead. Use Us.

.

I purchased a brand new Eureka Pet vacuum, sorry don’t know exact name but it the one that has the self cleaning duster on it. Last night I used the vacuum on my carpet, it was working fine until I accidently sucked up the corner of a scarf that was hanging off a couch. I shut the vacuum off, pulled out the scarf and and resumed vacuuming. Much to my dismay the suction on the vacuum had ceased. Can you tell me if there is a reset button on the vacuum? The vacuum does not appear to be damage
ANSWER : If the motor is running, there should be suction. Possible problems depend on whether it’s a canister or upright and are:
.A clog in the hose, UR or canister. Detach hose. Drop small coin in one end and lift hose causing it to roll out the other. If it does, no clog in hose. Drop same coin into hose opening on power head. If it rolls out, no clog in PN.
.Broken fan blades, UR. Needs to be taken to shop for repair/replacement.
.
.A reset button is for use if the motor isn’t running, so won’t have anything to do with the suction.

Dirt devil vacuum cleaner–trouble vacuuming dirt and pet hair on carpeting –is the problem with the spinning brush which contacts the floor,  not contacting the carpeting??  I thought (when I bought this vacuum) that the aforementioned brush was adjustable to various heights of carpeting.  Sometimes, it seems like nothing is being vacuumed up –unless I have just put a new bag on the vacuum… Do I need or can I replace the spinning brush on the bottom of the vacuum so it kicks up and vacuums
ANSWER : Try replacing the belt. Rubber belts stretch out after about a year.

Hello, I just bought a Bissell Powergroom (model 92L3-W) vacuum and a Bissell Proheat Pet (model 8910-3) deep cleaner and I love them both. My problem is, when we unpacked them we somehow lost the manuals; I think I had too many helpers that night – they may have gone out to the trash with the boxes. I need replacement manuals if you would be so kind as to help me out. Could you email me a manual for each of these two machines, or tell me exactly where to find them online? I’ve been looking, but
ANSWER : Follow the link below and enter the model numbers to access the User’s Guides.
.http://www.bissell.com/customer-support/

I do not have my users manual and have never vacuumed wet with this vacuum. How do I change it from a dry to wet vacuum.
Can’t find my manual and I need to use the shop vac for water in basement, do I have to change the filter or what
lost my user manual never used it to pick up water. need to know how to puit it in wet mode i want to clean the dirty water out of my pool.
ANSWER : .Vacuuming Liquids
.1. When picking up small amounts of liquid
.the filter may be left in place.
.2. When picking up large amounts of liquid
.we recommend that the filter be
.removed. If the filter is not removed, it
.will become saturated and misting
.may appear in the exhaust.
.3. After using the vac to pick up liquids,
.the filter must be dried to reduce the
.risk of possible mildew and damage to
.the filter.
.4. When the liquid in the drum reaches a
.predetermined level, the float mechanism
.will rise automatically to cut off
.airflow. When this happens, turn off
.the vac, unplug the power cord, and
.empty the drum. You will know that the
.float has risen because vac airflow
.ceases and the motor noise will
.become higher in pitch, due to
.increased motor speed.
.IMPORTANT: To reduce the risk of damage
.to the vac do not run motor with float
.in raised position

Hoover Bagless Hello,      My Hoover bag less (Model U5280-900) is not picking up dirt like it should.  The brush roll is spinning fine, but the bristles on it are only about one quarter inch long.  I am wondering how long they should be.  The vacuum is quite a few years old.  Do you think it is time to replace the brush roll.  Could you email me at [email protected] about this topic.  The product bar below did not contain my model no.  The correct model no. is above in my message.  Thanks
ANSWER : If the belt is more than six months old then change it even if it is not broken. then replace your filters if that doesnt work than check the hoses for a clog drop a marble down them and make sure it comes out.

I have a Kirby G4 Vacuum Cleaner – MOdel G4 D. I have never had any problems or repairs done to it in the past ten plus years that I’ve had it. This is an upright vacuum. I was vacuuming the carpet floor and was not having any trouble at all. I switched the vacuum off and moved it into a different room. When I tried to turn on the vacuum, it would not turn on. I checked with different outlets, used both front attachment and hose attachment. Checked the front part of the motor/ spiral case. This
ANSWER : Hello,
.My educated guess is that it’s either the switch or the power cord. Here are a couple of guides to help with diagnosis and repair…
.
.http://reviews.ebay.com/COMMON-PROBLEMS-WITH-THE-KIRBY-VACUUM-TROUBLESHOOTING_W0QQugidZ10000000003800312
.
.http://reviews.ebay.com/REPLACING-THE-POWER-SWITCH-ON-ANY-KIRBY-G-SERIES-VACUUM_W0QQugidZ10000000003752018
.
.Hope this helps!!
.Marci

Operating manual i have lost my operating manual for my bissell Model #9500 proheat x2 cleaner. where can i get another manual? on one of the sites it shows that i can download the manual but for some reason i can not down load it. can you please help me with this problem?
ANSWER : BISSELL User’s Guides can be downloaded at www.bissell.com
.On the front page under Customer Service click on User’s Guides and enter the model number of your unit.
.User Guide will be displayed as a PDF file.