Hoover Vacuums\015 Brush not turning\015
How to Identify and Fix Common Vacuum Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :
The Hoover® WindTunnel Whole House Rewind is ideal for Whole Home Cleaning from floor to ceiling and delivers powerful performance on every surface. WindTunnel technology and Multi-Cyclonic filtration lifts and removes surface debris and deep down embedded dirt with no loss of suction.
What is the weight of the vacuum? The full weight of the vacuum is 14 lbs.
The suction motor creates vacuum pressure and suction by rotating a motor fan. The impeller rotates at an incredibly high speed of about 30,000 to 35,000 RPM. A suction motor`s power is measured by multiplying the rate of air flow and the vacuum pressure, which induces air flow from the brush through the hose. Brush.
Vacuum systems consist of vacuum pumps and tanks mounted on a skid or truck. The vacuum pump creates a vacuum in the tank and the oil moves directly through a hose or pipe to the tank from the skimmer or the source of the oil. The oil does not go through the pump, but moves directly from its source into the tank.
For the electrical appliance that cleans surfaces through suction, North Americans tend to use vacuum cleaner, or just vacuum, and Britons tend to use hoover. Both words also function as verbs, inflected vacuumed, vacuuming, hoovered, and hoovering. By metaphorical extension, hoover also means to consume completely.
The HEPA filter is located under the dirt cup and under where it says HEPA. Twist the top counterclockwise to unlock the cap.
Suction Power
This is an indication of how good the vacuum cleaner is to clean – i.e. the work to be done. The suction power is measured in Watt (W) and is typically between 250 W and 450 W for machines with 1 motor.
Check that the brush bar is clean and not damaged
If the cleaner becomes noisy or starts vibrating, it may be because some debris has got tangled around the brush roll or agitator situated in the bottom of the cleaner.
How Many Watts Does a Vacuum Cleaner Use? A vacuum cleaner gets power from a regular electrical socket, with the average upright design requiring between 450 and 3000 watts. However, the most often used versions use around 1400 watts, equivalent to approximately 1.4 kilowatt-hours (kWh) of electricity each hour.
The two main indicators to determine vacuum power performance are water lift and airflow. The water lift is measured in mmH2O, mbar or kPa. It represents the suction force and is the reference parameter for vacuuming liquids and heavy materials. The airflow is measured in m3/h or in l/s.
Next, you need to consider suction power. Typically expressed in Pa (pascals), this is a measurement of how powerful the motor is inside a robot vacuum. A good number to look for here is around 2,000Pa or above for an effective clean.
Perfect vacuum has a pressure of 0.0000 mbar absolute. In vacuum technology, the absolute pressure is always indicated, so that, in general, the index “abs” can be dropped.
Vacuum Pump Basics
The pressure ranges are placed into several groups: Rough/Low Vacuum: 1000 to 1 mbar / 760 to 0.75 Torr. Fine/ Medium Vacuum: 1 to 10–3 mbar / 0.75 to 7.5–3 Torr. High Vacuum: 10–3 to 10–7 mbar / 7.5–3 to 7.5–7 Torr.
The suction motor is one of the most important parts of a vacuum cleaner. It is this motor which takes the electrical power from the power source and converts it into mechanical power in the form of suction with air flow.
Airflow. Vacuum airflow is by far the most important specification in terms of determining the cleaning ability of a vacuum cleaner. Measured in cubic feet per minute (CFM), it is the force of this airflow across a surface that picks up the dirt and moves it to the dust bag or container.
Twist the lid until the arrows line up and open up the container to get to the hepa filter. Take the filter out and brush the dirt out, once a month wash the filter in warm water. Please make sure it is thoroughly dry before popping it back in – this may take around 24 hours.
Evidence shows that a HEPA vacuum with properly designed seals does a better job of collecting contaminants than the average non-HEPA vacuum. This will be particularly helpful for allergy sufferers, as a HEPA vacuum traps dust, dust mites and pet dander better than non-HEPA vacuums.
When you use a vacuum cleaner without a HEPA filter, these particles are stirred up and put back out into the air through your vacuum`s exhaust. Regular filters can`t remove these harmful particulates and this puts the people in your home at risk.
Max(4000 PA): It can deeply clean the place that needs cleaning, dust cleaning is up 80%, garbage collection is up 30%, and the cleaning times are up to 80 minutes.
The minimum suction power (12,000 Pa) is engineered for routine cleaning and removing small particles. The 5-layer HEPA filtration system captures up to 99.99% of ultrafine particles, be it pet fur/dander, long human hair, pollen, dust mites and other allergens.
Power. Most people should only require a 3.5 to 5 peak horsepower motor for their wet/dry vac. If it can suction up water and sawdust, you`re probably good to go.
The Hoover WindTunnel Air was a bit quieter at just over 70 decibels when the brush bar was not on.
If your vacuum cleaner has lost suction power, it`s time to empty the container. Vacuum cleaners come with various foam or mesh filters. These might get clogged over time if not cleaned or replaced properly. This will cause your vacuum to lose suction.
A regular sized household vacuum cleaner will use between 500 and 3000 watts of energy, an average best selling model will use around 1400 watts.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
Hetty hoover not working. It was working ok until I opened it up to search the bag for a missing jigsaw piece and I put it all back and I hoovered the mess on the floor, then switched off and switched on and hoover would not work? Is there a cut off button on Hetty hoovers?
ANSWER : Know cut off switch, its just not getting power ? 2 things its ether at the wall plug or in side the unit. I have never found a fuse in side them , so it may be just a lose wire did you try other plugs in the house . good luck DFD
Read Full Q/A … : Hoover Vacuums
How do I replace a hoover windtunnel belt – Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
ANSWER : Here is a link to the manual and to the belts you need.
..\011\011\011\011\011\011U6439-900 Manual
.\011\011\011\011\011
U6439-900 Belts
Read Full Q/A … : Hoover Vacuums
Hoover Windtunnel My Hoover Windtunnel is 3 years old. It worked great until yesterday when it lost all suction. I have followed the manual to trouble shoot any possible clogs and could find none. Then I noticed that when I remove the dirt collection cup and held my hand over the vent the suction is fine and strong. So… I replaced the hepa filter thinking that might be the problem. That didnt’ work. The motor runs fine. The suction without the dirt cup inserted is strong. As soon as you insert
ANSWER : Either the hose has a clog, or the inlet down by the belt is clogged. Is there suction at the end of the hose, if not then it is clogged. If there is suction, then it has to be clogged down below by the brush roll, check that inlet. There also is a filter at the bottom where the dirt cup (and bag) is, check it also.
Read Full Q/A … : Hoover Vacuums
Hoover Windtunnel My Hoover Windtunnel is 3 years old. It worked great until yesterday when it lost all suction. I have followed the manual to trouble shoot any possible clogs and could find none. Then I noticed that when I remove the dirt collection cup and held my hand over the vent the suction is fine and strong. So… I replaced the hepa filter thinking that might be the problem. That didnt’ work. The motor runs fine. The suction without the dirt cup inserted is strong. As soon as you insert
ANSWER : Mine does the same thing. There is no suction. I found that there is a door that opens when you tilt the handle in the down possition. I think there should be a spring in place so it can open. Until I find a replacement spring I have to open the door manually throught the opening under the light.
Read Full Q/A … : Hoover Vacuums
Final Filter-Hoover U5399-900 WindTunnel Lite Upright Vacuum
ANSWER : Hi you could try these people who deal with hoover parts their number is 0845 230 6 230.
.they are called www.espares.co.uk.
.hope this helps if they dont have your part they should be able to get one or direct you to another supplier..
.they are called www.espares.co.uk.
.hope this helps if they dont have your part they should be able to get one or direct you to another supplier..
Read Full Q/A … : Hoover Vacuums
How to replace power cord on Hoover WindTunnel upright vacuum
ANSWER : The aforementioned solutions probably never even attempted this fix on this model. The handle does NOT need to come off. but the 5 screws on the front housing DO: 2 above the light and 3 below it. Then to get the colored housing off you need to access 2 screws on the underside that are beneath the agitator roller. To do that, obviously the 4 screws holding the bottom plate need to come off too. Here’s a link to a schematic that might help as you attempt to do this, (assuming that you still do!) http://www.elkypro.com/hoops2005/vacuum_parts/hoover/U5461-900.html
Once you have the main body housing cover off, then you can access the 2 screws atop of each trunnion cover that holds the motor assembly cover halves together. If you’ve made it this far, then gently pry apart the motor halves keeping even as yo do. Now you can see all the wiring necessary to cut and splice. Happy cord replacing! As for me, I am headed for the store, as I am not so sure I can remember how to get the darn thing put back together. But it was fun taking it apart!
Read Full Q/A … : Hoover Vacuums
Parts replacement We have a Hoover Steam Vac that has a broken part #10 in your picture or Part # 37271035. Does this part cover the whole top section of the Vac? Is it hard to replace? Where can you get the best prices on Hoover parts? I have been on Hoovers website and they don’t even recognize this Steam Vac. which is hard to believe they don’t even recognize their own unit? Thanks Ray
ANSWER : This the hood or top cover. There some screws on the bottom as well as on the top, then it comes off.
Read Full Q/A … : Hoover Vacuums
Dusty smell i buy loads of hoovers and always same prob .when i hoover its a dusty smell and it stays around bag not full and check filter the hoover is ok f couple days then this happens
ANSWER : Http://geeksquad.fixya.com/ThreadView.aspx?prdid=41018&thid=618510
.Dusty smell
.Posted by chekle on May 23, 2008
.I buy loads of Hoovers and always same problem. When I Hoover its a dusty smell and it stays around bag not full and check filter the Hoover is ok f couple days then this happens.
.
.Hello,
I would advise you to ALWAYS to FIRST UNPLUG YOUR VACUUM before beginning any service procedure. Hoover F5881-900 Vacuum. It sounds to me that if you have a clean bag and filter, it sounds like you have dust in the motor section and it needs to be cleaned and or take a good blower and blow out the dirt or you may have a clog or dirt build up in the suction line and that might be causing the dusty smell. Please feel free to contact your local vacuum cleaner dealer in your area or call the Hoover factory and ask for tech support. So if you need further assistance, please feel free to contact your local vacuum cleaner dealer in your area or in the yellow pages, or contact the factory phone number or website to further assist you with your questions.
.http://www.hoover.com Telephone
Contact our Customer Service Department at 1.330.499.9499
Monday through Friday
8 a.m. – 7 p.m. EST
.Thanks, Don the Vac Man
Go Ahead. Use Us.
.Dusty smell
.Posted by chekle on May 23, 2008
.I buy loads of Hoovers and always same problem. When I Hoover its a dusty smell and it stays around bag not full and check filter the Hoover is ok f couple days then this happens.
.
.Hello,
I would advise you to ALWAYS to FIRST UNPLUG YOUR VACUUM before beginning any service procedure. Hoover F5881-900 Vacuum. It sounds to me that if you have a clean bag and filter, it sounds like you have dust in the motor section and it needs to be cleaned and or take a good blower and blow out the dirt or you may have a clog or dirt build up in the suction line and that might be causing the dusty smell. Please feel free to contact your local vacuum cleaner dealer in your area or call the Hoover factory and ask for tech support. So if you need further assistance, please feel free to contact your local vacuum cleaner dealer in your area or in the yellow pages, or contact the factory phone number or website to further assist you with your questions.
.http://www.hoover.com Telephone
Contact our Customer Service Department at 1.330.499.9499
Monday through Friday
8 a.m. – 7 p.m. EST
.Thanks, Don the Vac Man
Go Ahead. Use Us.
Read Full Q/A … : Hoover Vacuums
