Dirt Devil Easy Steamer Upright Wet/Dry Vacuum

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

Fill a carpet shampooer with warm water and cleaner. Slowly pull the shampooer across your room while holding the button down to wash the carpet. Run the shampooer with cold water and soap to rinse out the soap. Let your carpet dry for 6–10 hours before moving your furniture back.
If the device is not creating sufficient suction or powering on, the motor could be obstructed. Unscrew the screws from the side of the Dirt Devil Gator. Once removed, notice the motor device (the largest one) and inspect to ensure no dirt or debris is obstructing or damaging the motor or its fans!
Replace filter every 3 to 6 months.
Remove the filter and gently tap it on the inside of the dirt canister to remove the loose dirt and debris. The filter should be replaced at least once a year.
1. The dirt canister may need emptied or the bag/filter may need to be replaced – follow the instructions in your Owner`s Manual based on your power unit type. 2. The hose may be clogged.
When something in your home looks dirty, your natural instinct is probably to clean that item ASAP. But when it comes to air filters, soap and water don`t always do the trick. HEPA filters, commonly found in portable air purifiers, are one item that experts recommend replacing rather than trying to clean.
Handling a Filter Can Damage Its Integrity

Instead of cleaning a disposable air filter, throw it away and replace it with a new one. Alternatively, consider reusable filters that last years with regular cleaning.

Cleaning with soap and water is generally recommended for cloth and carbon filters. You need to be careful while washing with water since it can damage your filters. Water should not be used to wash paper filters. First, use a vacuum cleaner to get rid of the dust, dirt and debris.
Quite simply, cleaning with steam does not require any chemicals – the combination of steam power and temperature alone is enough to break up stubborn dirt. This means it`s good for the environment and your household budget.
Yes, it does! And it`s actually a very effective way to clean a wide range of surfaces. Dirt, grime and similar substances possess an adhesive-like quality that allows them to stick to worktops, floors and other surfaces — and in some cases, they can prove to be challenging (and frustrating) to get rid of.
The Dirt Devil (Dæmonium terra) is an evil incarnate spawned from the ground itself.
Dark beige and browns carpets are good at hiding dirt. If you want something a bit more exciting darker shades of greens and blues do well at hiding dirt. Another option here is to go for a pattern with various colours.
While carpet cleaners are designed to work optimally with carpet shampoos, they will also do the job with a laundry detergent. In fact, this is one of the safest substitutes you can use. Using laundry detergent in a carpet cleaner will provide you with effective results and you won`t even have to use a lot of it.
Steam cleaners and shampooers are commonly used for cleaning carpets. In these laundry detergents can be used. These are often required to be used with strict instructions. This is because in some cleaners you can use only liquid detergents while in some you can use even powder form of the detergents.
If the device isn`t producing steam, please try the following: Check for any debris or blockages in the head and main body. Empty and refill the tank. Check for any limescale/debris in the tank itself and descale if necessary.
Check for a plugged hose:

Plugged vacuum hoses are sometimes the reason for a loss in suction. Hoses can get clogged with hair, dust bunnies, string, or anything else that can`t pass through the other end of the hose. Airways inside the machine should be looked at as well. Wherever there is an air passage, check it.

Dirt Devil is here for you to get rid all of your dirt and dog hair before your friends get to the door. The brand has introduced numerous technologies and features to its products, such as cyclonic filtration, HEPA filters, and powerful motors.
Most manufacturers recommend you change your filter on average every 3-6 months. However, it is recommended to change your filter even earlier depending on usage and allergy care.
This clogging will reduce the effectiveness of the vacuum and make it less able to pick up debris and dirt, and if the filter is not replaced regularly, it can release dust and other allergens back into the air, creating an unhealthy environment for asthma and allergy sufferers,” explains Mathew Morris, owner of Go …
If the filter isn`t clean, it can impact the performance of the vacuum. Dirty vacuum filters can restrict airflow so the suction won`t be as strong.
You vacuum too quickly

Vacuuming slowly will allow your machine to suck up more dirt and dust, and ultimately get your rugs and carpets much cleaner. Slow vacuuming allows the brush to agitate the carpet properly and suck up the unclean bits that emerge.

Vacuum up Liquids

Regular vacuum cleaners are not designed to pick up water and other liquids. If you are ever tempted to run the vacuum cleaner over a puddle of water, remember that you run the risk of electrocution and serious damage to the machine.

Water is known as “the universal solvent” because it can dissolve a wide variety of substances, including dirt, grime, and many chemicals. Indeed, water is the cleanser of choice for most surfaces in and around the house.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

How much soap do i use in the unit – Dirt Devil Easy Steamer Upright Wet/Dry Vacuum
ANSWER : The cap on the tank is a cup fill it and the rest water

I have a hoover 3000 i have not used in awhile, and since I removed a large rug, I would like to use it again on my slate floor. HOWEVER, I cannot get it to pick up ANY water in the water recovery unit……it is dry, dry, dry. I have put in a new filter, cleaned the nozzle unit, the scrubber , and reconnected both the recovery unit and the water unit several times, but to no avail. I would like to get a graut attachment a well as replacement part, but since I can’t get the basic unit to work, I
ANSWER : Have you made sure the plastic filter cover with the round hole in it that covers the filter is in place ( part # 59177096 ). This piece seems to get lost, and without it there is no pick-up. The other common problem is that the wheel assembly has been damaged. Look at the bottom of the Floormate. You will see a black plastic wheel assembly. There are two pegs at the rear attaching it to the base. If this piece has a crack in it where it attaches to the base, there will be no pick-up.

Dirt devil vacuum cleaner–trouble vacuuming dirt and pet hair on carpeting –is the problem with the spinning brush which contacts the floor,  not contacting the carpeting??  I thought (when I bought this vacuum) that the aforementioned brush was adjustable to various heights of carpeting.  Sometimes, it seems like nothing is being vacuumed up –unless I have just put a new bag on the vacuum… Do I need or can I replace the spinning brush on the bottom of the vacuum so it kicks up and vacuums
ANSWER : Try replacing the belt. Rubber belts stretch out after about a year.

I do not have my users manual and have never vacuumed wet with this vacuum. How do I change it from a dry to wet vacuum.
Can’t find my manual and I need to use the shop vac for water in basement, do I have to change the filter or what
lost my user manual never used it to pick up water. need to know how to puit it in wet mode i want to clean the dirty water out of my pool.
ANSWER : .Vacuuming Liquids
.1. When picking up small amounts of liquid
.the filter may be left in place.
.2. When picking up large amounts of liquid
.we recommend that the filter be
.removed. If the filter is not removed, it
.will become saturated and misting
.may appear in the exhaust.
.3. After using the vac to pick up liquids,
.the filter must be dried to reduce the
.risk of possible mildew and damage to
.the filter.
.4. When the liquid in the drum reaches a
.predetermined level, the float mechanism
.will rise automatically to cut off
.airflow. When this happens, turn off
.the vac, unplug the power cord, and
.empty the drum. You will know that the
.float has risen because vac airflow
.ceases and the motor noise will
.become higher in pitch, due to
.increased motor speed.
.IMPORTANT: To reduce the risk of damage
.to the vac do not run motor with float
.in raised position

I purchased a brand new Eureka Pet vacuum, sorry don’t know exact name but it the one that has the self cleaning duster on it. Last night I used the vacuum on my carpet, it was working fine until I accidently sucked up the corner of a scarf that was hanging off a couch. I shut the vacuum off, pulled out the scarf and and resumed vacuuming. Much to my dismay the suction on the vacuum had ceased. Can you tell me if there is a reset button on the vacuum? The vacuum does not appear to be damage
ANSWER : If the motor is running, there should be suction. Possible problems depend on whether it’s a canister or upright and are:
.A clog in the hose, UR or canister. Detach hose. Drop small coin in one end and lift hose causing it to roll out the other. If it does, no clog in hose. Drop same coin into hose opening on power head. If it rolls out, no clog in PN.
.Broken fan blades, UR. Needs to be taken to shop for repair/replacement.
.
.A reset button is for use if the motor isn’t running, so won’t have anything to do with the suction.

My dirt devil vacuum cleaner is not working – Dirt Devil M130000 ''i'' Dual Cyclonic Upright Vacuum Cleaner Vacuum
ANSWER : Please specify whether the vacuum motor does not turn on when you flip the switch or it simply does not have suction.

Problem with my dirt devil bagles upright
ANSWER : Sounds like you have a clog. Either in the hose, and down below where the inlet is. I assume your brush roll is working, if not you may need a new belt.

I have a DC 17. In the middle of vacuuming the vacuum stopped working when it was in the upright position. It only works when the head is down and i am using the bar. I can not use the extension bar, becasue when I put the vacuum upright it shuts off. Where is the problem?
ANSWER : Hi there, it’s Jack at Dyson.
.
. Like most Dyson vacuums, DC17’s main suction motor is protected by a thermostat which shuts the machine down if it starts to overheat. This could be due to a blockage, and the filter may also need a wash. If this occurs, the separate brush bar motor will still run if you recline the vacuum, and shut off when you stand the vacuum upright.
.
. The vacuum should reset itself automatically after it’s cooled down for around 2 hours. To prevent this from reoccurring, please wash the filter as shown in our video guide – in normal use this should be done at least once every 3 months. Use cold water without detergent, and allow the filter to dry completely for at least 24 hours before replacing it.
.
..Once you’ve done this it’s important to check the vacuum for any blockages – our Support guide will walk you through each checkpoint to make sure nothing is missed: http://www.dyson.com/support/dc17/dc17-allfloors/diagnosis-root-menu/dc17filterwashvid/flo-dc17-wand-suction
.
.This should resolve the issue. However if the issue reoccurs when the filter is clean and there are no obstructions in the airways, there could be an issue with the cyclone pack itself. If this is the point please contact us directly, as we’d appreciate the opportunity to provide further assistance. You can reach our experts by calling 0800 298 0298 (UK), 1-866-693-9766 (US), 1-877-397-6622 (CA) or 1800 239 766 (AU).