Dyson DC07 Bagless Upright Cyclonic Vacuum\015 I have a dyson upright bagless vacuum and cannot find the manual. It is about 4 years old, and I have not used it often. It needs a good cleaning, (which I assume is why is has very little power) and I cannot figure out how to get the filter off so I can clean it? Also any other cleaning suggestions?\015

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

The DC07, released in 2001 was the first implementation of Root Cyclone technology into a cleaner.
Rinse under a cold tap until the water runs clear – you don`t need any detergents. Leave to dry fully (at least 24 hours) before refitting.
There are two filters on a DC07, the first is the pre-motor filter, which are washable and is recommended by Dyson to be washed at least every 6 months. The pre motor filter also acts as a protection to the motor, trapping the smallest of dirt or debris from travelling to the motor.
A Dyson vacuum cleaner has a lifespan of around 10 years. This is considerably longer than most other vacuums. So, if you`re looking for a high-quality vacuum cleaner that will last you for a long time, a Dyson could be a good choice. However, remember that Dyson vacuums are expensive.
The Dyson V7 and the Dyson Cyclone V10 are similar stick/handheld vacuums with a few differences. Thanks to its more powerful suction motor, the Cyclone V10 does a significantly better job on bare floors, and it`s a bit better on low-pile carpet.
Filters in Dyson air purifiers have been designed to last up to a full year, based on 12 hours of daily use. However, the filter may need replacing earlier depending on environmental conditions. If you live in a highly polluted city, you may find it needs changing sooner.
The Dyson DC-07 was introduced back in 2001, and was the first with “Root Cyclone” technology, which is still the basis of the company`s designs.
Dyson DC07™ Upright vacuum cleaner (Clutchless)
Depending on your Dyson model, you may be surprised by the amount of dust and debris you`ll find inside it. So, `detach the hose from the wand, then clean its insides using a cloth pushed inside with the help of a broomstick or anything similar. `
I would not use with filter off. This must be a feature of the newer models. This one blows air even with the filter removed. The suction is reduced by a considerable amount.
Most problems arise because of a blockage – if not a dirty filter or cyclone unit, then something could be caught in the wand or the brush bar. Once again, the lack of suction could be caused by a dirty filter or a blockage somewhere in the vacuum`s system.
Give it a break

By letting the battery run down to empty at least once a month, you`ll help to prolong its life. If you have a spare battery, we recommend you swap them out from time to time, so that they both have time to naturally discharge.

The best Dyson vacuum we`ve tested is the Dyson V15 Detect. This cordless stick/handheld vacuum`s headlining feature is its built-in dirt sensor, which counts and measures the size of particles sucked into the vacuum. You can see this information on the LED display at the back of its body.
Which Dyson vacuum is the most powerful? In terms of sheer suction power, the Dyson Ball Animal 3 Extra is the most powerful option in Dyson`s current lineup, offering 290 AW, or air watts, of suction power. Among the brand`s cordless stick vacuums, the Dyson V15 Detect is the most powerful, with a rating of 230 AW.
We recommend replacing your air purifier filter every 12 months. That`s because over time, filters can get clogged with pollutants, and even let unpleasant odors back into the room.
We engineer vacuums that are simple to use and easy to look after. We suggest you clean your filter at least once a month to keep your machine running at maximum efficiency.
Vacuuming can release and re-introduce pollutants back into your air, while washing the filters could potentially cause mold to grow if the filters are not dried fully. The only way to keep your filters fresh is to replace them regularly.
While some machines use one HEPA filter, most Dyson vacuums use two filters; the pre-motor filter and the post-motor filter.
Dyson was designed and patented by a British, had it made in Malaysia (Johor Bahru), – as it is cheaper to make here.
There`s an additional model category sold by Dyson labeled “Outsize.” This is the most expensive kind of Dyson vacuum, with a price tag of $800 or more. Dyson`s Outsize vacuums offer a bit more suction power and a larger dust bin.
If there is a strong burning smell coming from the motor area of your Dyson DC14 or DC07 then it is most likely that your motor has burnt out.
Pet hair removal in every space

Dyson cordless vacuums can transform into a handheld device for vacuuming pet hair in all areas. Tools attach directly to the wand or machine to target coarse carpets as well as high and low spaces. Pet hair, dander, pet allergens and dirt have nowhere to hide.

Firstly take it outside, as far away from the door and path as you can, or near or into the wheelie bin. Empty the contents into a plastic bag. Dispose in the outside bin. Use a soft brush of any kind and clean the cylinder casing inside and out.
The cleaner head housing is not washable and should only be wiped over with a damp lint-free cloth. To maintain optimum performance, check and wash your brush bar regularly. Make sure your machine is disconnected from the charger and take care not to touch the trigger.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

I have a dyson upright bagless that needs a good cleaning
ANSWER : Dyson DC07 Manual

everything you need should be available in the manual

I have the same problem as steve967 The dyson dc16 is fully charged, runs well for 5-10 seconds and shuts down. I wait for a second or 2 and it runs again for 5-10 seconds. This will continue for numerous cycles, until I am finished cleaning. I have cleaned all the filters, and the power is good, The system will just not stay on. It is just over 2 years old. A friend of mine had the same problem with his Dyson DC16 after just a couple of months and has replaced his Dyson with a Black N De
ANSWER : Dear Michael_Stad,

I am going to sound like a broken record but here is my same answer to another person with the same problem.

I have I had the same problem with my Dyson DC16, where it only runs for a few.seconds at a time with each trigger pull. My husband called Dyson.(Canada) and without hassle they shipped us a replacement part which I.just received this morning. The replacement part sent to us is: DC16.Main Body with Rating Plate. It is also under warranty for 1 year. The.great customer service makes up for the flaw in the machine. Also,.Dyson is aware of the problem. Hope this helps.

Roomba keeps saying clean brushes yet are clean!
ANSWER : Make sure you take off the little cap at the end (the one that spins — just grab it and pull it straight off) and clean under it too. The rest of the brush may look perfectly clean but what happens is that hair gets stuck under spinning cap and, like a slowly growing washer, it pushes the whole brush toward the gear box. When it gets pushed over enough, the large yellow ring starts to rub against the side of the brush deck making it harder for the motor to turn the brush and you get that “remove and clean brushes” message.

I need to change my fan belt on my dyson – Dyson DC07 Bagless Upright Cyclonic Vacuum

How do you clean hepa filter on dyson dc05 – Dyson DC07 Bagless Upright Cyclonic Vacuum
ANSWER : You can use compressed air to blow it out

How to clean filter on dyson vaccums – Dyson DC07 Bagless Upright Cyclonic Vacuum
ANSWER : The filter on the side of the of the unit can be washed out with warm soapy water leave for 24hours to dry somewhere warm do not tumble dry the filter under the bin just replace as the cannot be washed.

My older Dyson DC14 (the purple one) early model with a clutch on the beater bar belt needs a clutch replacement. The bar has been cleaned and there are no worn or damaged parts so I conclude that the clutch at the motor end of the belt needs to be replaced. I can find the part online but no instructions on how to disassemble the vacuum to get to and replace it. Dysons only advice is to give me the address and phone of the nearest service center. Can you help me?
ANSWER : Have a look at www.dysonmedic.com which has some very useful info on dismantling and repairing Dysons.
.
.Although this site doesnt actually cover the DC14 yet, the DC14 is very similar to the DC07 so as regards dissassembling the machine, and replacing the clutch, my experience is that the DC07 info will enable you to do the job.

Cant undoe the Dyson in order to clean it – Dyson DC07 Bagless Upright Cyclonic Vacuum
ANSWER : To clean the brush bar area: Lie the machine on its back, look for the three plastic screws under there. Turn them anti-clockwise using a 2p coin (or a quarter if American) and the sole plate comes off that way. This gives you access to the brush bar to clean it.