Euro-Pro S3325 Handheld Steam Vacuum
How to Identify and Fix Common Vacuum Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :
Check to see if there is water in the water tank. If there isn`t, unscrew the water tank cap and use the filling flask to pour distilled water into the tank until it reaches the fill line. Replace the water tank cap and tighten. Power the device on, wait about 30 seconds for the water to heat up, and then try again.
Shark Pocket will not make steam
Check that your water tank is full, if you find it is empty, add water. Also check that the tank is free of any cracks or holes that could cause water to leak, and that the tank is properly seated in the device`s housing.
How hot does it get? We used a hi-tech thermometer that registered the Shark`s steam at 217 degrees. We also tested on wood floors with no problems. “Does It Work?” We give the Shark Steam Mop a yes.
First, check to make sure the unit is plugged in and is in a working outlet. Next, check to make sure there is water in the tank. It is very important to make sure you are ONLY using water to fill the tank. Other solutions may cause breakdown of the gasket and/or other parts of the machine.
A common cause to your cleaner not producing steam can be a failed heating element. As the heater is used to heat up the water, if that has ruptured or burnt out your steam cleaner will not produce any steam. With the water tank filled and switched on the steamer should sound like a boiling kettle.
Plug the mop in to turn it on.
The mop only takes about 30 seconds to fully heat up.
Not Plugged In
You will notice a blinking blue light on the front of the device when plugged in correctly. If the light fails to come on then try to plug into a different outlet.
To prolong the life of your steam mop, we recommend using distilled water in the tank. Make sure you only add water to the tank – chemicals or cleaning solutions (including vinegar) may damage the steam mop and could be unsafe.
The Shark Floor Steamer, also known as the Euro-Pro Shark Steam Mop, is a device for cleaning tile, wood and other hard surface floors that uses heat to lift off stains. It can also be used on carpet with an extra attachment.
Residential units heat water up to temperatures between 150° and 300° Fahrenheit (66-149° Celsius). For example, Reliable steam cleaners typically have a steam tip temperature of 245° F. The hot steam kills dust mites, mold, mildew, viruses, and other allergens on contact as well as loosening most dirt and grime.
Many people think you need to mop with boiling water to thoroughly clean your floors. This, however, is a myth – rather than always giving you a better clean, the temperature of the water can actually have a negative effect.
Applicable on SC505, SC505a & SC505N — The Shark Professional Portable Steam Cleaner takes approximately 6 minutes to reach its working temperature and is ready for use when the red light on the side of the unit turns green.
Soap only lifts dirt and oil into water, making them suspend in water. Therefore, the more soap you use, the more your mop gets saturated with dirt. So, if you do not remove all the soapy water from the floor, the dirt remains, forming streaks on the floor.
Applicable on SC505, SC505a & SC505N — The Shark Professional Portable Steam Cleaner takes approximately 6 minutes to reach its working temperature and is ready for use when the red light on the side of the unit turns green.
To use the Shark steam mop, plug it in and wait 30 seconds for the water to heat up. There is no power button. To activate the steam, pump the handle about ten times or until you see and hear the steam.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
I can’t get my shark steam blaster model EP95 to create steam?
ANSWER : Pull the (3) coasters/feet out and unscrew the 3 screws. take off the one end of the steam”boiler” (two clamps). tilt open end up and pour white vinegar [carefully] in there, prop up so it does not fall over, and soak overnight. dump out lime and water scale and rinse out a couple of times. Be very careful to not get water on electrical parts.
Take an air pig and blow out the line (Black) from where you disattached it to where the steam comes out [at the handle]. Be sure to mark electrical connections [4 on one, 2 on the other] so you don’t blow a breaker switch like I did.
Take an air pig and blow out the line (Black) from where you disattached it to where the steam comes out [at the handle]. Be sure to mark electrical connections [4 on one, 2 on the other] so you don’t blow a breaker switch like I did.
Read Full Q/A … : Euro-Pro S3325 Handheld Steam Vacuum
For some reason, our shark steam mop stop working. Usually after I plug the steam mop, the power light would light up then you would hear & see steam coming out of the mop’s head but all of
ANSWER : HEATING ELEMENTS BURNT OUT. WILL COST OVER $100. TOFIX. SHARK NOW HAS A NEW MODEL “SHARK 3” MUCH BETTER
Read Full Q/A … : Euro-Pro S3325 Handheld Steam Vacuum
Shark Steam Mop – Gray/ Purple Vacuum: shark steam mop has water, but there is no steam….
ANSWER : I tried running vinegar through as you would a coffee pot to get rid of hard water scales. This did not work. Then I noticed that the light behind the shark decal on the front of the machine was going off and on. And sure enough as I moved the cord around the light would come off and on. Looking closer I could see the the heat had melted thru some of the cord.I bought mine at Target before xmas last year, throwing away the sales slip after several months so I guess there is nothing I can do about it.
Read Full Q/A … : Euro-Pro S3325 Handheld Steam Vacuum
Need operator manual for ultra steam shark – Euro-Pro Shark Steam Mop – Gray/ Purple Vacuum
ANSWER :
.Hi,
.
Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it may not be getting steam to the head…
.Hi,
.
Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it may not be getting steam to the head…
Euro-Pro Shark Steam Mop Problem
.
.Here also is a link to get any of the Shark Manuals that you need.
.
heatman101
Read Full Q/A … : Euro-Pro S3325 Handheld Steam Vacuum
Replacement parts where can i find replacement steam pocket towels online for the shark ultra steam blaster hard surface cleaner? I went online to www.sharkcompany.com & www.sharkvac.com and when I enter my model number S3325 search comes back with 0. Thanks
ANSWER : You can found them on amazon, take a look here: Amazon com Euro Pro S3325. I hope this was helpful. Cheers
Read Full Q/A … : Euro-Pro S3325 Handheld Steam Vacuum
I have the euro steam blaster s3325 when I turn it on, the steam ready **** comes on right away not heating can the heating element be replaced? thanks
ANSWER : There is a device attach to the heating element called a thermo fuse, this devise brakes down when it get to hot.
open the machine and replace it with the same value. it is written on it..
open the machine and replace it with the same value. it is written on it..
Read Full Q/A … : Euro-Pro S3325 Handheld Steam Vacuum
My Europro shark steam mop won’t steam, light on but no steam.
ANSWER : Hard water deposits. I ran some white vinegar through mine, like a coffee maker, and it worked for a while, but clogged again. So I unplugged it, let it cool and turned it over in the bathtub and squirted a small amount of Lime-Away into the hole where the steam comes out. Let it soak for 5- 10 minutes and it is working like is is brand new.
Read Full Q/A … : Euro-Pro S3325 Handheld Steam Vacuum
Shark steam blaster jr. makes steam but has no pressure
ANSWER : Yes no vinegar please. Try a product called scale clean or tablets for de-scaling coffee machines. Available from coffee machine retailers
Read Full Q/A … : Euro-Pro S3325 Handheld Steam Vacuum
