Roomba Robotic Floor Bagless Vacuum\015 Roomba does not charge. Lights on charger do not light ,but power is going to charger battery cannot be dead..roomba ia barely 2 months old!! MH\015
How to Identify and Fix Common Vacuum Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :
Dirt or built-up debris may be preventing your robot from charging. Please unplug the base and grab a clean, lightly dampened melamine foam, such as a Magic Eraser to clean the contacts on the robot and base. Watch the following video outlining steps for cleaning the charging contacts.
Solid white: Fully charged. Pulsing white: Charging. Pulsing red: Charging, too low to start cleaning. Solid red: Error (tap Button for details).
If the charging dock light turns off, it indicates that Roomba is docked and charging rightly. The turning off the dock light will not stay longer. So, there is nothing to worry about it. If you feel or think that something is unusual, you can check the charging status of Roomba through the I-robot app.
Roomba® should charge in the following manner: If you are using a charger, the charger should have a solid green power indicator when it is plugged into an outlet. If you are using a Home Base®, the power indicator should blink approximately once every four (4) seconds when plugged into the charger or outlet.
Charging time under normal conditions is at least 2 hours. For best results, use only the battery type compatible with your robot and ensure that it is an authentic iRobot Lithium Ion/NiMH battery that comes with Roomba or purchased from iRobot authorized dealers.
Verify there is no debris build-up on the charging contacts. If found, clean the charging contacts on both the Roomba® and the Home Base® with lightly dampened melamine foam. Examine Home Base®/Clean Base® line cord and check for any damage such as cuts, or fraying. Ensure the plug is securely inserted into the outlet.
If your Roomba is making noise while charging, it could be because of the battery. The rechargeable batteries in all Roombas are designed to last for about two years and will need to replace if you don`t want your device to start making noises and stop working properly.
If your Roomba® i Series Robot Vacuum is not turning on or is not able to charge, rebooting your robot tends to solve most related issues. To reboot your Roomba: Press and hold the CLEAN button for 20 seconds. After you release the button, the light ring will show a white clockwise swirl while it reboots.
Electrical tape is one of the easiest and most affordable fixes for a broken charger cable. You probably won`t even have to buy it because you have it sitting in your DIY drawer. That said, neatly wrap the tape around the damaged part several times to keep it immobile and prevent further damage.
Usually, we suggest customers put device on dock all the time if it is used every week. After battery is fully charged, only mother board of device is charged and customers don`t need worry battery is fully charged for a long time and may decrease the lifespan.
Wi-Fi Connected 600 & 800 Series Robots: Press and Hold the Dock and Spot Clean and CLEAN button down until the robot makes a beep tone, then release. Roomba Combo: Open the lid and locate the recessed Reset button to the left of the On/Off switch. Press and hold the Reset button for ten seconds.
The suction power is to be measured at the end of the tube of a complete vacuum cleaner (i.e. with tube, hose and filters – but without nozzle). Some manufacturers show the results from measurements made at the suction of the actual vacuum cleaner.
Wi-Fi Connected 600 & 800 Series Robots: Press and Hold the Dock and Spot Clean and CLEAN button down until the robot makes a beep tone, then release. Roomba Combo: Open the lid and locate the recessed Reset button to the left of the On/Off switch. Press and hold the Reset button for ten seconds.
You can easily check the status of the battery in the iRobot® HOME App. A battery icon will be displayed in the top-right corner, indicating the current status of the battery.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
I have a Roomba 560 (it’s still in warranty !!) and, after my summer vacation, it has a problem.
When I’m charging Roomba, the orange light blinks (and this is normal!) but this orange blinking continues forever…. the light doesn’t change to green.
If I detach Roomba from the charger, the light become green and it works normally until the light changes to red and I have to charge it again.
WHY, DURING THE CHARGING PHASE, THE LIGHT DOESN’T CHANGE FROM ORANGE-BLINKING TO GREEN?
HAVE I
ANSWER : The problem is not with the charger itself but it is with the battery inside the Roomba. It sunds like one or more of the cells has gone bad so its not holding the same charge as it did. I would recomend sending it in while the warranty is still valid so they will replace it. Your charger and the Roomba itself should be fine.
A few tips to keep the battery working longer:
Only charge the battery when it is drained all the way to zero. It will help keep the battery active.
Only charge the battery until it is full and then disconect it from the power source. It will keep it active longer plus it will help keep your electric bill down.
Lights on charger do not light and therfore do not charge roomba.
ANSWER : If the charger doesn’t light up, it’s broken.
.
.Call customer support at 1-877-855-8593. Be sure to have the Roomba and charger with you when you call– you’ll need them.
Roomba Charging? Flashing Lights
ANSWER : Call iRobot. Your charger is broken.
I have iRobot Roomba 4210 and I have a problem with charge battery. The battery is new. When I charging a battery in other iRobot Roomba the battery was full charged. When I charging in my iRobot Roomba the battery was empty. My fast charger is OK.
ANSWER : The charging circuit on the main board is fried. This is a common issue. You need some good electronic repair skills, and equipment, to replace the problem components
I purchased a brand new P113 Ryobi charger about 2 years ago. It has never worked. If I put a P104 battery in for a charge, it looks like it works correctly. I push the battery tester on the battery itself, and it says full charge, but when I go to use the bateery, it dies right away. I have tried three new P104 batteries. The batteries charge on my charger at work with no problem. The funny thing is, I don't need a battery in the charger and the charger does the same thing, It runs the test
ANSWER : If you have your receipt, check with Ryobi to see if it is still under warranty. It comes with either a 2 or 3 year warranty, depending on when it was purchased. If it is still covered, get it replaced/repaired. If it is not, buy the P117 charger. $30 at Home Depot. It has a 90 day satisfaction guarantee. If it charges your batteries properly, you’re good. If not, bring it back if you don’t like/want it. My P113 won’t get out of test mode now, or charge Lithium batteries anymore. So I bought the P117 yesterday. Works great, and it’s a lot cheaper than new batteries! And it has a 3 year warranty.
Battery charge I just purchased a new battery pack insert for my Roomba, Replacement
was a breeze and it now works great. My question is; The last battery I
bought ( not from you) was a full cased roomba battery pack that didn’t
last a year. Roomba says leave the r Roomba charging all the time so
it’s ready when you need it, and that’s nice but I feel that leaving it
charging like that it will kill the battery faster as it is always warm
to the touch. These battery’s should last at least 5
ANSWER : Dave you are correct. You should never over-charge anything like a Roomba, Cel Phone, etc. That will kill a bettery very quickly.
Roomba scheduler Roomba goes to charger, charges, then looses charge before it can be run again. The charge also takes six or more hours. The unit has only been used 4 times. Any help? Thank you, Cynthia Murphy.
ANSWER : Probably have a bad battery pack, your owner manual should tell you how to replace it.
Roomba Discovery My Roomba turns on and moves but the brushes won’t turn. Someone told me that I had forgotten to put in the yellow and black end bearings, but I did. Help, I miss my Roomba
I have a Roomba 530, I have had it for 2 weeks and really loved it. I have followed all the cleaning instructions etc.. Then the Roomba wanted it’s brushes cleaning “please clean Roombas brushes” So thinking that something was stuck I removed and cleaned the brushes, (yellow tabs on and in place by the way)
ANSWER : I read somewhere that you need to clear the software in case there is a glitch. To do this, take the battery out and then, simultaneously hold down the “spot” and “clean” buttons for 30 seconds. Replace battery. This has worked for my Discovery model.