Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

A possible cause might be that the tank is not properly seated. To assure the tank is seated properly, pick it up and re-seat is so it sits snugly on the unit. If this doesn`t fix the problem, make sure the tank is assembled properly. To make sure they are both latched properly, pick the tank up by its handle.
A: Yes it can be used as a vacuum without water.
But you might be a little disappointed if you expect this tool to heat up its own water. Despite its name being the Bissell ProHeat, this carpet cleaner doesn`t actually heat up the water it uses to clean your floors.
Check your hose for any cracks or holes that can cause loss of suction. You may also have a clog in the lower hose. Pull down and at an angle to disconnect. A clog in the main hose could also be the problem.
Unwrap the power cord and plug into an outlet. Once plugged in, allow the unit to heat up for 30 seconds or until the Steam Ready Light illmuniates. When the Steam Ready Light is on, press the ON button to turn on the machine and then proceed to choose your level of steam.
If the power light is on, make sure a steam setting is selected and there is water in the tank. If the power light is not on, the first thing to check is to make sure your unit is plugged into a working outlet. Next, check the entire length of the power cord for damage.
So, you`ve decided to buy a Bissell Power Steam Pro Carpet Cleaner and are wondering what other cleaning solutions you can use in it. Well, you can use Baking soda, Vinegar, Castile soap, or even Warm Water. However, you must keep in mind that you should leave the carpets to dry after you use them.
Fill up with warm water.

Hot water loosens and softens dirt more quickly, making it easier to remove, and it also helps to kill bacteria. That`s why we recommend filling up your carpet cleaner`s tank with warm water.

Bissell Proheat Deep Cleaner

It features a patented hot water heater that provides maximum steam cleaning effectiveness via continuously heated cleaning action. The unit`s 12 amp cleaning system is quite powerful, removing tough and ground in dirt and stains from carpeting, upholstery, and other fabrics.

Yes, you should keep cleaning the carpet until the water is clear. This will ensure that your carpets are clean and free of dirt, dust, and other allergens. However, you should be careful not to scrub too hard or use too much water. Doing so can damage the carpet and lead to more stains in the future.
Step 5: Rinse Your Carpets (Optional)

An optional step that we recommend if you have time is to go back over the cleaned carpet again with only hot tap water in the tank (no formula this time). This will remove any leftover formula and give your carpets an extra clean.

This machine uses HeatWave Technology™ which helps maintain consistent water temperature throughout the cleaning process by redirecting the heat of the motor to help maintain the temperature of the water.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

My carpet cleaner (bissell proheat plus) is not steaming, dispensing cleaner. Seems like there’s a little thingy that should be spinning or turning….. When I work a small area of carpet, it just leaves behind dry blobs of carpet gunk like pet hair. I had to use a carpet sweeper to clean up. FYI – I filled the cleaning fluid container and after trying to clean the carpet, it did empty out but the carpet isn’t wet. Any tips? The manual doesn’t help.
ANSWER : You need to replace the pump belt. Here is the belt you need:

Bissell ProHeat Belt

We have a Bissell Proheat Cleanshot 2X Model 9500 Steam carpet cleaner. The first time we used it things were great. The second time we used it it left tracks in the carpet. We have no idea what caused this. We tried using the machine on an entirely different carpet and it did the same thing. After vacuuming the carpet about 10 or 12 times, the tracks are still embedded in the carpet – HELP!!!! We’re read and reread the manual and contacted customer service and received no help.
ANSWER : First things first. It’s only the second time you have used the machine, so it must be fairly new. If you have a receipt and the unit is less than a year old you should take it to an authorized Bissell repair center and have the machine inspected under warranty.
.
.Otherwise, The jets on this unit clog easily, there are two of them and you can locate them under the recovery tank towards the front of the machine, and blow them out with an air compressor. To prevent the jets from clogging in the future make sure to flush all shampoo out of the machine with clean water when done using it. That is most likely your problem.
.
.If it is leaving black streaks on your carpet it could be coming from a burnt belt or melted brushroller part, in which case inspect the belts and brushrollers and replace the damaged pieces.
.
.I hope this helped
.
.Good Luck

I purchased my Bissel PowerSteamer Clearview a few years or so ago, and cannot find where I filed the manuals. If I find the actual seriel number on the Bissel PowerSteamer Clearview, Is there a way that I can purchase another manual? I really do not have any problem with my Bissel, but being I am 75 years of age and do not use it myself anymore, I want to give it to a daughter of mine (but I would like to have the manuals that go with it to give to her also).
ANSWER : No need my friend. Go here. All documentation is here…and….it’s free! Hope this helps : )

http://www.bissell.com/user-guides/?searchtext=1699%2520pro%2520heat&searchType=search&mode=228

Repair manual for Bissell 2X ProHeat 9200 Carpet cleaner

No problem I just need a manual. I bought the bissell from lowes and it was a floor model. They did not have the manual with the directions on how to use the machine. They told me I could go online and get the directions or have a manual sent to me. I would rather have a manual sent Thanks. My address is B. Carothers 5969 walker rd. walker Wv. 26180
ANSWER : Http://www.bissell.com/DownloadAsset.aspx?id=647

Hello, I just bought a Bissell Powergroom (model 92L3-W) vacuum and a Bissell Proheat Pet (model 8910-3) deep cleaner and I love them both. My problem is, when we unpacked them we somehow lost the manuals; I think I had too many helpers that night – they may have gone out to the trash with the boxes. I need replacement manuals if you would be so kind as to help me out. Could you email me a manual for each of these two machines, or tell me exactly where to find them online? I’ve been looking, but
ANSWER : Follow the link below and enter the model numbers to access the User’s Guides.
.http://www.bissell.com/customer-support/

Operating manual i have lost my operating manual for my bissell Model #9500 proheat x2 cleaner. where can i get another manual? on one of the sites it shows that i can download the manual but for some reason i can not down load it. can you please help me with this problem?
ANSWER : BISSELL User’s Guides can be downloaded at www.bissell.com
.On the front page under Customer Service click on User’s Guides and enter the model number of your unit.
.User Guide will be displayed as a PDF file.

Carpet stained recently cleaned my cream coloured carpet in my entrance hall with a carpet cleaning product, wet foamy spray type, ran out of this and found a part bottle of a different brand in my cupboard, used this to finish off however must be some sort of reaction and carpet gone a greenish colour i think (colour blind sorry ) any idea’s of any product that might restore my carpet, will try anything, nothing to loose. thank you Peter McGurk Goole East Yorks
ANSWER : Ok in the future try to have carpet cleaned only by a pro. For spot cleaning use white paper towels or dish towels and warm water. (ONLY WHITE) 99% of fabric is white and then dyed to color and if you use a color cloth you might pull the dye from the cloth into the carpet. Now what you can try is your basic dishwashing detergent like electrosal with warm water and a dishtowel. little at a time try to blot not rub. try AFTA if that doesnt work. wet the rag first with warm water. pour the afta on the wet rag not on the carpet.