the carpets. I believe it is a SEB 212-2 Power Brush. The vacuum (canister) is Black. Any help is appreciated. There is no power to it at all. I’ve unplugged it, smacked it around a little too (mostly kidding) but still nothing.
Miele S514 Solaris Electro Plus Vacuum
How to Identify and Fix Common Vacuum Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :
Miele S514 Solaris Electro Plus Vacuum Cleaner Introduction
Sitting elegantly among their more deluxe midsize vacuum cleaners is the Miele S514 Solaris Electro Plus Power Team with its beautiful royal black finish.
There are three main causes for your Miele to not power on: The power switch has failed. The cord reel is damaged. Your motor has gone bad.
If this happens, check if the motor protection filter and exhaust filters need to be replaced. If so, replace them and reset the indicator. To do this, turn on the vacuum and press the reset button. The service indicator light will turn off and then be reset to its original position.
Should you ever need have your Miele vacuum cleaner repaired, simply stop by a Miele Vacuum Repair Centre. Regardless of whether your vacuum cleaner is still covered by Miele warranty or not, you can expect outstanding service at one of our conveniently located Vacuum Repair Centres.
Miele Washing Machines are vigorously tested to last the equivalent of 20 years use. Miele Washing Machines are ecological and consume only the amount of water and electricity needed for excellent cleaning and rinsing results.
Where do I find the serial number / model number of my Miele appliance? The serial number / model number of your Miele appliance can be found on the data plate.
Durability & Warranty – If you`re looking for a vacuum cleaner with durability and longevity, look no further than Miele. Miele vacuum cleaners are designed and tested to last for 20 years. Miele vacuum cleaners come with a 7-year warranty on the motor and a 1-year warranty on parts and labor.
The brush roll or its bearings may be clogged with hair, threads or dirt. Make sure they are clean and the roll spins. The belt may also have slipped because it was loose. Check the fit of the new belt when it is installed.
For a cordless miele stick vacuum cleaner, a temperature limiter switch automatically turns off the vacuum cleaner if it gets too hot. (Some models have a temperature warning light.) Overheating may be caused by a blockage in the vacuum, or due to a full dustbag and/or filters.
The average life expectancy of a mid-range vacuum cleaner is about six years. You can fix or replace things like blocked filters, jammed brush rolls, frayed hoses, worn-out stick vac batteries and broken accessories yourself.
As a general rule, if the repair is going to cost less than half the cost of a new vacuum cleaner, it`s best to go ahead and get it repaired. When the service tops half the price of a new machine, it`s probably best to invest in a newer model.
Typically users get about 50-60 hours of use from the filter before they need to replace it. Every new Miele filter and vacuum cleaner now comes with this Timestrip. To activate the Timestrip, simply push/crush the small green button, and when the bar is full red, it`s time to replace.
The prices for their equipment are high, and it`s not hard to see why. Nearly all of their manufacturing is in Germany, and every component is produced directly by Miele in one of its 12 factories. In one year their Euskirchen factory produces six million motors.
Miele. Founded in 1899, Miele is one of the most popular high-end appliance manufacturers in their home country of Germany and internationally.
Bosch and Miele offer similar cutting-edge dishwashing technologies, but Bosch provides a more affordable solution. Both brands promise a decade or more years of reliable performance with sensor wash technology, flexible loading options, and high-quality materials for long-term use.
The bag is reusable. It needs better instructions though. For instance, it`s washable but if you put it in the machine you`ll ruin it as the plastic part is fragile. It clogs with dust so every other use or so you do need to wash it to keep your suction and other filters from clogging.
The two main indicators to determine vacuum power performance are water lift and airflow. The water lift is measured in mmH2O, mbar or kPa. It represents the suction force and is the reference parameter for vacuuming liquids and heavy materials. The airflow is measured in m3/h or in l/s.
If all you hear from the vacuum unit is a click at the when you try to start the vacuum motor from inside the house, then the motor in the unit is dead and has to be replaced. A strong odor from the shellac, which coats the copper coil windings, is an indicator that the motor is about to or has burnt out.
Excellent Longevity
Most dishwashers will have an average lifespan of around 5 – 10 years but a Miele could last up to 20 years.
If you don`t vacuum your carpet, the dirt will break down carpet fibers and create a breeding ground for dust mites and bacteria. In addition, your home will begin to smell musty from the dirt, mites, and other organisms settling into the fibers.
A washable HEPA filter should be cleaned by rinsing it under cold water. You should be careful not to touch the filter material, only allowing it to come in contact with water. Allow the filter to completely dry before reinstalling it.
Clog located in the vacuum hose
Turn the unit on and feel the suction at the end of the hose handle. If there is no or low suction, then the clog is in the hose. You can remove the clog by running a long, stiff object through the hose, such as a butter knife, starting at the wall end.
Burning smell can indicate motor damage
If you suspect that the motor is damaged, you should not continue to use the vacuum cleaner! The cause of motor damage is usually wear and tear or damage caused by prolonged improper use (e.g. overheating). In most cases, it is not worth repairing.
The Miele Pre-Motor Filter can be found in the dust compartment chamber behind the bag. It should be changed once every three months, or every four bags.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
Dirt devil vacuum cleaner–trouble vacuuming dirt and pet hair on carpeting –is the problem with the spinning brush which contacts the floor, not contacting the carpeting?? I thought (when I bought this vacuum) that the aforementioned brush was adjustable to various heights of carpeting. Sometimes, it seems like nothing is being vacuumed up –unless I have just put a new bag on the vacuum… Do I need or can I replace the spinning brush on the bottom of the vacuum so it kicks up and vacuums
ANSWER : Try replacing the belt. Rubber belts stretch out after about a year.
Read Full Q/A … : Miele S514 Solaris Electro Plus Vacuum
Electrolux vacuum brush not turning problem:
was vacuuming and rug got caught auto shut off kicked off power to brush. instead of hitting red button to restart brush I disconnected brush to vacuum some hair in Conner. after i reconnected the brush and hit the red button but no power to brush. Light won’t even switch on. Hope you can help
ANSWER : Under the vacuum, there is a guard..remove the guard , either by 2 screws or by 2 clips..there is a belt under the guard..that is connected to the brush..the belt need to be replaced.
Read Full Q/A … : Miele S514 Solaris Electro Plus Vacuum
I had the vacuum cleaner question about the canister and the wand/powerhead… the Kenmore Progressive Vacuum canister model 116.25812 and the canister not powering off without unplugging the vacuum. The solution I received that they both run on their own switch so it is normal makes sense. However, is there a power switch on the canister anywhere? The only way for the canister to be turned off is by unplugging it. Any ideas? One would think there would be a switch. I am new to fixya and hope
ANSWER : Hi. On some models, one switch controls all of the power. Your issue, which is no working switch is almost certainly a blown triac on the circuit board in the canister – kenmore part number KC86WBZRZ000
.Take it to your local vacuum repair shop and they should be able to fix it for a nominal fee.
Looks like a common fault with this particular model judging by the number of complaints on the web.
.Take it to your local vacuum repair shop and they should be able to fix it for a nominal fee.
Read Full Q/A … : Miele S514 Solaris Electro Plus Vacuum
The power brush floor rug attachment on my Eureka 6997 A Oxygen Canister Vacuum goes on an off as I use it. I replaced the The power cord from the handle has 2 plug in connections:
1 at the handle / upper wand
1 at the lower wand top of the power brush attachment
1 at the handle / upper wand
1 at the lower wand top of the power brush attachment
I replaced the entire wand assembly and it worked great for a year or so and now it’s doing the same thing again. I was told to keep the power switch on the handle set to off when connecting the power brush attachment or it will bu
ANSWER : This is from the prongs not making a good connection causing an arch inside the plugg causing what looks like rust on the plugg. I would try snugging up the connection by squeezing the female section to get a better connection on the prongs when it is plugged in together.
Read Full Q/A … : Miele S514 Solaris Electro Plus Vacuum
Power cord can not find replacement power cord for power brush attachment on kenmore canister vacuum, model #2491290 power brush attachment model # 5491290. i can not even find those model #’s anywhere online, not even partsdirect.com. any help would be great. thanks, david
ANSWER : Call 1-800-948-1358 ask for Buck mon.-fri. 9am-5pm est sat.9am-1pm est
Read Full Q/A … : Miele S514 Solaris Electro Plus Vacuum
Stopped running My mother’s Oreck vacuum sound as if there was something bogging the rotating brush down. I pulled the bottom cover off and found nothing wrapped around or restricting the brush. I tried to finish vacuuming with the problem then I turned it off to move a chair and turned it back on it would do nothing. Any suggestions as to what could be causing the vacuum to sound as if the rotating brush is being restricted from turning. There was not odor of burning as if the motor was in a bi
ANSWER : Orecks have a plastic fan inside and everything you pick up hits it, sometimes things can get stuck in there or break the fan locking up the motor. With the machine off, poke around where the dirt goes into the motor, behind the roller and see if you can pull anything out.
Read Full Q/A … : Miele S514 Solaris Electro Plus Vacuum
Vacuum My vacuum is loosing it’s suction power. I’ve checked the belt and it’s in perfect shape…I’ve bought a new filter cup…I’ve checked for clogs and there aren’t any…I’ve cleaned the entire machine…and I still can’t find the source of the problem.
ANSWER : You checked the belt, but I bet it has stretched and won’t drive the brush roll under load like it should. Belts only last a few months the stretch and should be replaced. Iff you have suction at the hose, then it has to be down below, either belt/brush roll, or the inlet by the brush roll is clogged.
Read Full Q/A … : Miele S514 Solaris Electro Plus Vacuum
We have a Bissell Proheat Cleanshot 2X Model 9500 Steam carpet cleaner. The first time we used it things were great. The second time we used it it left tracks in the carpet. We have no idea what caused this. We tried using the machine on an entirely different carpet and it did the same thing. After vacuuming the carpet about 10 or 12 times, the tracks are still embedded in the carpet – HELP!!!! We’re read and reread the manual and contacted customer service and received no help.
ANSWER : First things first. It’s only the second time you have used the machine, so it must be fairly new. If you have a receipt and the unit is less than a year old you should take it to an authorized Bissell repair center and have the machine inspected under warranty.
.
.Otherwise, The jets on this unit clog easily, there are two of them and you can locate them under the recovery tank towards the front of the machine, and blow them out with an air compressor. To prevent the jets from clogging in the future make sure to flush all shampoo out of the machine with clean water when done using it. That is most likely your problem.
.
.If it is leaving black streaks on your carpet it could be coming from a burnt belt or melted brushroller part, in which case inspect the belts and brushrollers and replace the damaged pieces.
.
.I hope this helped
.
.Good Luck
.
.Otherwise, The jets on this unit clog easily, there are two of them and you can locate them under the recovery tank towards the front of the machine, and blow them out with an air compressor. To prevent the jets from clogging in the future make sure to flush all shampoo out of the machine with clean water when done using it. That is most likely your problem.
.
.If it is leaving black streaks on your carpet it could be coming from a burnt belt or melted brushroller part, in which case inspect the belts and brushrollers and replace the damaged pieces.
.
.I hope this helped
.
.Good Luck
Read Full Q/A … : Miele S514 Solaris Electro Plus Vacuum
