Dirt Devil SwivelGlide Bagged Upright Vacuum\015 My dirt devil bagged upright(swivel glide) was running and then turned off. it was on and plugged in. now the little light on the bottom back comes on when I turn it on but it wont actuall “turn on”\015

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

Check the main fuse or circuit breaker at the main power supply panel of your home. Reset breaker or replace fuse if necessary. 2. Check the power unit reset button located above the power cord.
If the brushroll is sticking, it will cause too much friction and put too much strain on the belt. Remove the brushroll and clean all hair, string, and lint from the brushroll bearings. If the vacuum cleaner brush still doesn`t spin after you clean the brushroll, consider replacing the brushroll.
The brush roll or its bearings may be clogged with hair, threads or dirt. Make sure they are clean and the roll spins. The belt may also have slipped because it was loose. Check the fit of the new belt when it is installed.
If your vacuum cleaner has lost suction power, it`s time to empty the container. Vacuum cleaners come with various foam or mesh filters. These might get clogged over time if not cleaned or replaced properly. This will cause your vacuum to lose suction.
Consumer Reviews On Dirt Devil Vacuum Cleaners

Consumers give high marks to some Dirt Devil models like the Breeze canister and the Featherlite bagged vacuum – where both get on average 4 out 5 stars based on over 200 ratings. That means that Dirt Devil has designed the perfect vacuum for the majority of home users.

Easy-empty dirt cup. 4 hour charge time.
The most common problems found in vacuum cleaners are low suction force, excessive noise, burning smell, vacuum not turn on, and overheating. These issues can be fixed by either cleaning the device or replacing some parts of the device. At times, it is best to seek a professional to fix the cleaner effectively.
Some vacuums have an in-line thermal fuse (often located between the switch lead and the motor coil). If the fuse is blown it will need to be replaced. – Check your home circuit breaker – it may have tripped. – Some vacuums have a brushroll on/off control.
Factory reset on a Wi-Fi Connected Roomba® and Braava jet®

e Series Robots: Press and Hold the Home and Spot Clean and CLEAN button down for 20 seconds then release. 900 Series Robots: Press and Hold the Dock and Spot Clean and CLEAN button down until all LEDs illuminate.

If all you hear from the vacuum unit is a click at the when you try to start the vacuum motor from inside the house, then the motor in the unit is dead and has to be replaced. A strong odor from the shellac, which coats the copper coil windings, is an indicator that the motor is about to or has burnt out.
`Tripped` reset systems are the most common reasons for a brushbar not turning, but there are some other less common reasons too. These include: If the bearings on the end of the brushbar have seized, you won`t be able to turn it at all. This will often result in a broken belt as well, so be aware of this.
Almost every time that the brush stops turning, it is because of hair wrapped around the brush roller. You will burn out the belt if you use it too long in this mode. Your only fix is to take it apart and and clean it (and cut any hair stuck in it in the process).
Roller brush is not spinning

Check to make sure the vacuum is switched to the correct mode. The switch should be in the Power and Brushroll mode to make the roller spin. If it is in just the power mode the roller will not move. The brushroll indicator light should be green when working.

The powerful airflow from the vacuum can help shake dirt and debris loose and pull them into the vacuum. Without the fan, a vacuum couldn`t work at all. But the roller brush is critical, too. It`s necessary in dislodging deep dirt and stuck debris, and it helps clear a path for air to carry dirt into the vacuum.
1. Motorized Brush Head. Sometimes called the “power nozzle,” this large attachment has a rotating brush to clean carpets more like an upright.
The Dirt Devil (Dæmonium terra) is an evil incarnate spawned from the ground itself.
The exhaust filter traps particles as the air travels through the vacuum cleaner. If the filter is clogged, the vacuum cleaner will not have proper suction. If your vacuum filter is clogged, refer to your owner`s manual for cleaning instructions.
Soil and Plant Debris

Soil and plant debris can clog a vacuum, and damp or wet leaves can lead to mold in the bag or canister, so it`s best to use a broom or your hands to pick those up.

If your Dirt Devil Gator (Model Number: BD10100) isn`t starting or staying on for more than 15 seconds, you may need to replace the battery. Follow this guide to replace the battery to keep your Dirt Devil Gator in use! However before using this guide, you may not need to full replace the battery, just charge it!
A: Charger indicator light is lit (solid) while charging, it starts blinking when fully charged.
Any fine dust remaining in the filter can usually be removed with a gentle rinse under a cold tap – hold the filter under the running water until the water runs clear. You shouldn`t need to use any detergent – just water.
Most pleated filters have a replacement schedule and are considered disposable by manufacturers. Paper filters should never be soaked or rinsed in water. However, some filters are made from a non-woven synthetic material (similar to a dryer sheet) that can be rinsed with water a few times to remove dust.
Magic Vac® PowerBrush can be used as a lightweight and powerful stick vacuum for quick pickups of messes across multiple surfaces, including carpet, area-rugs, and hard floors.
Inspect the belt to see if it is broken, stretched out, or out of place. If the vacuum cleaner belt is broken or stretched out, replace it. Need help finding your model number? Inspect the belt to see if it is broken, stretched out, or out of place.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

My dirt devil bagged upright(swivel glide) wont turn on..light on
ANSWER :

    .

  • its clogged that is what the light shows is that if your vacuum is clogged then that light will come on and it will shut off, i have the same vacuum and mine does not come on cause its not clogged
  • .

Electrolux Epic 6500SR Full Bag sensor working, Does not Reset properly
ANSWER : The problem was a sticking switch that was not being reset. The vacuum on/off switch mechanism is comprised of two switches. One is the main switch that turns the vacuum on and off. The second is a shut off switch that gets tripped when the full bag sensor is engaged. This second switch is supposed to get reset when you push the on/off switch on the outside of the machine. The full bag shutoff switch was stiff and it, therefore, was taking a couple of presses of the on/off switch to move the shutoff switch back into the running position.

How do I repalce the belt on Dirt Devil Swivel Glide upright vac?
ANSWER : Four screws hold the bottom plate in place. Turn the vac upside down and remove the screws that hold the cover(bottom plate) over the brush roll in place. Remove the plate and you are there.

Dirt devil swivel glide – no suction
ANSWER : Check the filter gauze on the unsud of vack where bag is if this is blocke you will not have vacuum as there will not be ventilation thro this filter should be able to feel blow of air from this vent when vacuuming up hope this helps good luck from uk !

I have a Kenmore Elegance Vacuum with Dirt Sensor, Model # 116.30750400C, Serial number M41901532. When vacuuming the carpet the power head will work for 3-6 mins then automatically shut off, power is still there and lights work but the power head motor turns off and the suction stops. I will turn it off and on, check the outlet, flick the on off buttons…nothing. I will turn it off for a couple minutes and it turns back on and runs like normal. I’ve check the bags, filters, cleaned the hos
ANSWER : It is an electrical problem in the handle, if you can or know somebody that has any fix it ability it can be fixed in about ten minutes. Oh, and Sears SUCKS!!

Dirt Devil R088100. Cloth Was Sucked Into Hole Below Dirt Holder
ANSWER : Brad, Hopefully it is the belt that you smell burning. I would start by removing the underneath side of the vacuum head. Normally just a few screws that are meant to be remove for general maintanence and circumstances such as this. After removing the screws this should reveal the dirty side of life to you. You may need to remove the roller brush, and inspect the ends to make sure the brush rolls freely while holding the ends. If not the ends may need to be cleaned of hair and strings: ends should pop of and a shaft runs through the middle connecting them. Clean and replace. Move on up the path the dirt travels. The neck where the head and vacuum come together is the next jamming point, if this is where the cloth is lodged chances are the motor may have over heated due to clogging. Your vacuum may have a automatic shut off. You will need to contact Dirt Devil to see if there is a reset for the motor. There are propellers / fan blades at the end of the neck just before the motor housing. This is most likely where the clothe has logged itself causing the brushes on the electric motor to emit the burning smell, if you can remove all obstructions and the unit still does not turn on, check with dirt devil about the reset, Hope this helps.

Roller on Dirt Devil hand vac won’t turn
ANSWER : Usually the ends will pull off so you can clean them. If not, then you will have to replace it.

DIRT DEVIL VACUUM 4 MONTH OLD AND HOSE SPLIT TOOK BACK TO ARGOS TRIED TO INFER IT WAS MY FAULT ENYONE HAD THIS PROBLEM ? THE STRETCH HOSE SPLIT AND I HAVE NOT HAD THIS HAPPEN WITH ENY OTHER CLEANER THE SALES GIRL IN ARGOS SAYS THIS WAS MY FAULT . DIRT DEVIL VACUUM DDCYLBG5 BAGGED CYLINDER G TABERN.
ANSWER : From the Argos website… they must repair or replace or refund, up to 1 year. The squeaky wheel gets the grease, go over her head.. .If there’s a fault with the product…
.We’ve made it easier!
.

    .

  • If you bring it back to us within 30 days with your proof of purchase*, we’ll give you a
    replacement or a refund. .
  • If you’ve had the product for up to 1 year, we’ll repair the product or, if that’s not possible, give you a replacement or, if that’s not possible, a refund. .
  • Please note that all large kitchen appliances are excluded from our 30 day guarantee, but if your item develops a fault within 30 days, call us on 0845 640 0800 and one of our agents will assist you with your problem. If faulty and if it cannot be repaired we will arrange a replacement free of charge or you can opt for a refund. .
  • This does not affect your statutory rights.