dirt devil jaguar pet it spins and no clogs just no suction

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

The exhaust filter traps particles as the air travels through the vacuum cleaner. If the filter is clogged, the vacuum cleaner will not have proper suction. If your vacuum filter is clogged, refer to your owner`s manual for cleaning instructions.
What`s happening with your vacuum cleaner is that a clog has built up and debris being agitated by the roller is spitting out or stirring up dust without sucking it in.
It uses light sensing technology to measure the amount of dirt picked up and can thus be used to glean which parts of the house are dirtier than the others. The signals can also potentially be used to understand the size of the dirt picked up by the robotic vacuum cleaner.
Putting in the incorrect amount of oil, putting in the wrong type of oil, and oil contamination can all cause the pump to not reach full vacuum. For this reason, you must check the oil regularly to ensure that it is not only clean, but also properly filled.
One of the easiest ways to increase vacuum cleaner suction is to empty the dust bag or container. Dust containers need to have enough space for airflow, otherwise, they could get clogged and have less suction power. Regularly check your dust compartment and empty or change it when it`s already 70-80% full.
If the brushroll is sticking, it will cause too much friction and put too much strain on the belt. Remove the brushroll and clean all hair, string, and lint from the brushroll bearings. If the vacuum cleaner brush still doesn`t spin after you clean the brushroll, consider replacing the brushroll.
Soil and Plant Debris

Soil and plant debris can clog a vacuum, and damp or wet leaves can lead to mold in the bag or canister, so it`s best to use a broom or your hands to pick those up.

Vacuum Sensors are electrical devices that provide switch output signals for set points to monitor vacuum pressure in machine automation, leak testing equipment, and pick and place applications. They are also installed in process gas and liquid applications for the semiconductor and food processing industries.
The Smart Dust -Dirt Sensor detects levels of contamination in server racks, under raised floors, and distributed equipment rooms. Remote from anywhere makes this device is ideal for harsh environments. Designed to monitor levels of debris levels in real-time, provides risk mitigation of equipment failures over time.
Gravity and friction are the two main forces that make vacuum suction work. While gravity pulls molecules in the air toward the earth, creating an atmospheric pressure, the suction cup and vacuum pump cause a pressure difference, attaching both surfaces.
All vacuum cleaners operate based on air flowing from the opening at the cleaning head or tool, through the vacuum cleaner and the bag and/or filter system and then out the exhaust port. This airflow is created by the vacuum motor, which also may be referred to as the suction motor.
If there is a clog in the vacuum, you won`t have good suction and the vacuum won`t work. The clog can be in the vacuum head, the hose or where the hose meets the actual vacuum.
NOTE: The reset button is located on the upper left-hand side of the unit where the low voltage wires connect to the unit. It is most noticeable when popped out after the breaker has been tripped.
I would buy this product again.

I use this filter in my Dirt Devil stick vacuum and love that it is washable.

How do Dust Devils Form? s the air rises, it cools and eventually will descend back through the center of the vortex. Under optimal conditions, a balance between the hot air rising along the outer wall of the vortex and the cooler air sinking in the vortex occurs.
Vacuum Cleaner: Why doesn`t my vacuum cleaner`s brush roll spin? A broken drive belt, damaged brush roll, jammed brush roll bearings, tripped brush roll motor overload, failed brush roll motor or a wiring failure in the wand or nozzle can prevent the brush roll from spinning.
If your Dirt Devil Gator (Model Number: BD10100) isn`t starting or staying on for more than 15 seconds, you may need to replace the battery. Follow this guide to replace the battery to keep your Dirt Devil Gator in use! However before using this guide, you may not need to full replace the battery, just charge it!
Remove the filter and gently tap it on the inside of the dirt canister to remove the loose dirt and debris. The filter should be replaced at least once a year.
The average life expectancy of a mid-range vacuum cleaner is about six years. You can fix or replace things like blocked filters, jammed brush rolls, frayed hoses, worn-out stick vac batteries and broken accessories yourself.
Dust before vacuuming

We recommend dusting before vacuuming, this is because dust particles usually get moved around the room when you dust, meaning all your hard work will go to waste. A top tip is to wait at least 2 hours after dusting to get the vacuum out.

The answer is that you should always dust first and vacuum later. The reason is simple. When you dust, you`ll find that some of the particles wipe away onto your cloth or duster, but you`ll never get all of the particles.
A strong odor from the shellac that coats the copper coil windings is an indicator that the motor is about to or has burnt out. If the motor is still running, even if it turns on and off by itself as it is heating and cooling, you can still run the motor until it gives up for good.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

Poor Suction Heya! So I just picked up a used Dyson, but when I vacuum with it, the suction is pretty weak and it spits all kinds of stuff out the back and into my feet. When I pull the hose I have good suction, but in regular mode it hardly picks up anything. The brushes are spinning, and it eventually will clean an area if I go over it again and again. Maybe a clog somewhere? Please tell me that Dysons have better suction than my $50 Dirt Devil! Thanks!
ANSWER : I recently bought a second hand Dyson DC07. Its suction was poor. I removed all the un-clipable pipe bits and to remove any blockage but it all looked clear. The Final Sponge and hepper filter did have a lot of dust in it and the rotating brush was full of hair but nothing bad.
.
.I eventual gave in to curiosity and removed the three screws in the top or the yellow removable dust collection tube and cyclone bit to see what was in there. The mechanism to release the flap at the bottom of the collection tube does not allow you to remove the lid completely but it does open far enough to get inside. I found the whole top section of the yellow plastic bit blocked by a big plug of compacted dust and a champagne cork. If you are willing to take the risk and have a torx 15 screwdriver handy it that part may be blocked. It did get a bit messy.
.
.If I was going to attempt the same procedure I’d remove the dust collection unit from the vacuum cleaner as I did before, but leave the clear tube attached and the emptying flap firmly closed to reduce the mess from the dust falling out the bottom while cleaning the top part.

Read Full Q/A … : dirt devil jaguar pet

It has no suction. It was fine yesterday. I washed the dirt container and the filter, let it dry and put it back in the vacuum. Today my vacuum isnt picking up any dirt and has no suction. When I took the hose out of the back, it started blowing dust and dirt out but still no suction.
ANSWER : Look for a place where the vacuum line has to turn in a near 90 degree turn. It’s easy for it to get stopped up there.

Read Full Q/A … : dirt devil jaguar pet

Hoover Windtunnel My Hoover Windtunnel is 3 years old. It worked great until yesterday when it lost all suction. I have followed the manual to trouble shoot any possible clogs and could find none. Then I noticed that when I remove the dirt collection cup and held my hand over the vent the suction is fine and strong. So… I replaced the hepa filter thinking that might be the problem. That didnt’ work. The motor runs fine. The suction without the dirt cup inserted is strong. As soon as you insert
ANSWER : Mine does the same thing. There is no suction. I found that there is a door that opens when you tilt the handle in the down possition. I think there should be a spring in place so it can open. Until I find a replacement spring I have to open the door manually throught the opening under the light.

Read Full Q/A … : dirt devil jaguar pet

Vacuum Problem My dirt devil vacuum is losing suction and keeps clogging. All the dirt keeps sticking to the screen by the filter and then it would stop working. Also the hose does not have a strong suction power either. So what can I do?
ANSWER : The Bissell can have several filters in it, depending on the model. Some have a round hepa filter that is covered with a foam sleeve. This filter is located at the bottom of the dirt cup. Others have a foam filter that is located under the dirt cup in a pull out drawer. Also, they can have a cylindrical separator above the dirt cup which can be removed and washed. They are usually a blue plastic and you reach in and turn it a 1/4 turn counter-clockwise to remove. If your machine has the hepa filter, when you remove the dirt cup, the filter is at the bottom and you turn the bottom 1/4 turn and the clear housing will come off to access the filter. You should also check the small filter on the machine just below where the cup sits. This will only be there if your machine has the hepa filter on it.

Read Full Q/A … : dirt devil jaguar pet

Suction my new dirt devil has no suction when switched to normal hoover mode however the hose funtion has suction , is there a switch to changeover ,
ANSWER : Make sure the brush roller is turning.if not the belt ie either broke or it might have come off the motor shaft.feel free to call me at 314-628-9153

Read Full Q/A … : dirt devil jaguar pet

Hoover Windtunnel My Hoover Windtunnel is 3 years old. It worked great until yesterday when it lost all suction. I have followed the manual to trouble shoot any possible clogs and could find none. Then I noticed that when I remove the dirt collection cup and held my hand over the vent the suction is fine and strong. So… I replaced the hepa filter thinking that might be the problem. That didnt’ work. The motor runs fine. The suction without the dirt cup inserted is strong. As soon as you insert
ANSWER : Either the hose has a clog, or the inlet down by the belt is clogged. Is there suction at the end of the hose, if not then it is clogged. If there is suction, then it has to be clogged down below by the brush roll, check that inlet. There also is a filter at the bottom where the dirt cup (and bag) is, check it also.

Read Full Q/A … : dirt devil jaguar pet

Dirt Devil upright doesn’t have suction. I changed the belt and the bag. The suction is so slight it won’t pick up a small piece of paper. The accessory wand also does not have much suction.
ANSWER : Try cleaning chute that fills bag.may be obstruction blocking the flow of air

Read Full Q/A … : dirt devil jaguar pet

No suction My dirt devil featherlight vacuum has no suction. I have checked all hoses and they are clear. I did replace the belt which had broken and since I did that the suction is gone.
ANSWER : Take the cone filter out of the dirt cup and start it up if you have suction the filter is the problem,if still no suction the you have a clogged hose or a clogged intake hose which is at the bottom it will be a clear hose coming up the backside from the bottom

Read Full Q/A … : dirt devil jaguar pet