Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

Check the Circuit

Check the vacuum cleaner to see if it tripped a circuit breaker or blew a fuse. Check the circuit breakers, or fuses and, if it has tripped a circuit breaker or blown a fuse, simply re-set the breaker, or replace the fuse, and switch the vacuum on again.

The most common cause of no power is the machine overheating and cutting out. In this case once the vacuum cleaner loses power leave it for at least half an hour and then try turning it back on again. If it comes back on again after an hour then clean your filters and check for blockages.
3 cleaning modes Power button Press the power button to start cleaning. Lean to clean Lean handle back to start a clean. Leave upright to direct suction to the wand.
Our machines are engineered with six layers of advanced whole machine filtration, which means that we capture 99.97% of particles as small as 0.3 microns. Our fully sealed system keeps dust in the machine, drawing the airflow through all six layers of filtration, expelling cleaner air into your home.
To reset the Brush bar press the Brush bar control button twice or switch the machine off and back on.
If your Dyson vacuum`s suction motor isn`t working, first check that the machine receives power from the wall socket or its battery pack. If the motor still doesn`t work, it`s likely an airflow problem. Blockages will cause the vacuum to overheat, so the suction motor stops or pulsates to protect itself from damage.
Vacuum Cleaner: Why doesn`t my vacuum cleaner`s brush roll spin? A broken drive belt, damaged brush roll, jammed brush roll bearings, tripped brush roll motor overload, failed brush roll motor or a wiring failure in the wand or nozzle can prevent the brush roll from spinning.
When your Dyson no longer powers on even after charging the most likely cause is a damaged battery. This means the battery will no longer hold a charge and will need to be replaced. Once a new battery is purchased you can learn how to replace it by visiting our battery replacement page here.
A Dyson vacuum cleaner has a lifespan of around 10 years. This is considerably longer than most other vacuums. So, if you`re looking for a high-quality vacuum cleaner that will last you for a long time, a Dyson could be a good choice. However, remember that Dyson vacuums are expensive.
Hold the red trigger down with one hand and with the other, firmly push the MAX power button in.
Dyson vacuum cleaners use their characterizing cyclone technology which enables air to circulate at high speeds inside the vacuum cleaner. To remove dust, allergens and other particles, the Dyson collects all dirt through a filtration system.
The suction motor creates vacuum pressure and suction by rotating a motor fan. The impeller rotates at an incredibly high speed of about 30,000 to 35,000 RPM. A suction motor`s power is measured by multiplying the rate of air flow and the vacuum pressure, which induces air flow from the brush through the hose.
If you find that your machine is turning off intermittently, the filter in your vacuum is most likely full and covering the ventilation system. Remove the filter, then empty and wash it. Allow the filter to dry for at least 24 hours, or until it is completely dry.
If there is a strong burning smell coming from the motor area of your Dyson DC14 or DC07 then it is most likely that your motor has burnt out.
You may visit a Dyson Service Center to have your Dyson machine serviced and/or repaired. If you are unable to visit a Dyson Service Center, you may ship your Dyson machine to Dyson for service and/or repair.
The most common problems found in vacuum cleaners are low suction force, excessive noise, burning smell, vacuum not turn on, and overheating. These issues can be fixed by either cleaning the device or replacing some parts of the device. At times, it is best to seek a professional to fix the cleaner effectively.
Some vacuums have an in-line thermal fuse (often located between the switch lead and the motor coil). If the fuse is blown it will need to be replaced. – Check your home circuit breaker – it may have tripped. – Some vacuums have a brushroll on/off control.
If all you hear from the vacuum unit is a click at the when you try to start the vacuum motor from inside the house, then the motor in the unit is dead and has to be replaced. A strong odor from the shellac, which coats the copper coil windings, is an indicator that the motor is about to or has burnt out.
Over time, all batteries are subject to degradation. So if your run time has declined when the machine is not in Max / Boost mode, it might be time to buy a new battery. All our machines come with a 2-year initial warranty that includes the battery.
In many cases, you probably can repair a Dyson yourself, especially when it comes to common issues (see below). However, even if your machine needs some extra TLC by a Dyson expert, it can be worth getting it repaired.
It`s possible there`s a power consumption issue, with there just not being enough residual charge to run the machine. A new battery should fix this. My other thought is that it`s overheating. If too much power is pushed through the motor, which MAX power does, it could stop after a few seconds if it become hot.
If you`re looking for a complete rebuild, you can expect to pay $100 or more. However, you may be able to get your Dyson repaired for free if the service is covered by the product`s warranty. According to Dyson, cordless vacuums have a two-year warranty while corded models have a five-year warranty.
One of the first things to do when your Dyson vacuum cleaner keeps starting and stopping is to empty the bin. It may be full, or the machine may simply perceive it as too full to continue working. Dyson vacuum cleaners require constant airflow through them to work, and a full bin can stop this from happening.
Yes you do still have to hold the trigger down. I am sure this is an energy management thing to make the battery last longer by not running constantly.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

For a dyson manual for the floor model dc24 – Dyson DC14 All floors Bagless Upright Cyclonic Vacuum
ANSWER : User manuals can be downloaded from www.dyson.com but Dyson service manuals are apparently unavailable anywhere.

Dirt devil vacuum cleaner–trouble vacuuming dirt and pet hair on carpeting –is the problem with the spinning brush which contacts the floor,  not contacting the carpeting??  I thought (when I bought this vacuum) that the aforementioned brush was adjustable to various heights of carpeting.  Sometimes, it seems like nothing is being vacuumed up –unless I have just put a new bag on the vacuum… Do I need or can I replace the spinning brush on the bottom of the vacuum so it kicks up and vacuums
ANSWER : Try replacing the belt. Rubber belts stretch out after about a year.

Replacing clutch drive belt dyson dc14 – Dyson DC14 Animal Bagless Upright Cyclonic Vacuum
ANSWER : Chris,
.I am just trying to find an owners manual, but I can not find one anywhere. Your link did not work. Can you help with another link?

Not vacuuming from the wand like it should – Dyson DC14 All floors Bagless Upright Cyclonic Vacuum
ANSWER : Possible hose blockage. try pushing through hose with a length of dry garden hose and try suction again.

How do I replace the brush on my dyson dc14 – Dyson DC14 Animal Bagless Upright Cyclonic Vacuum
ANSWER : Hi its Darran at Dyson.

If your DC14 has a brush control, we would only recommend that a suitably trained person attempts to replace the brush bar.

We can arrange a repair so that one of our engineers can replace this for you, and as part of the repair they would be able to look at any other issues you may be having with your machine.

If you would like to discuss your options, please contact us on 0800 298 0298 (UK) or 1866MYDYSON (US).

Kind regards
Darran
Dyson Customer Service

How to put new cable on dyson dc07 upright – Dyson DC07 All Floors Bagless Upright Cyclonic Vacuum
ANSWER : Have a look at www.dysonmedic.com which has some excellent info on your machine.

Belt won't turn on my dyson – Dyson DC14 All floors Bagless Upright Cyclonic Vacuum
ANSWER : Either the belt is burnt stretched! broken or the roller has debrise’ around the bearing ends and got it stuck

I have no power to my dyson – Dyson DC14 All floors Bagless Upright Cyclonic Vacuum
ANSWER : DC14 CARBON BRUSHES HAVE WORN DOWN AND POSSIBLY SHORT CIRCUTING MOTOR CAUSING MAINS FUSE TO BLOW
.
.GET MOTOR REPLACED AVERAGE COST £45 TO £69