– a mesh of cords being in the way. I knoe you’re not supposed to empty them but for econpmy’s sake I do. Can you still buy the old non Hyclean type?
Miele S4210 Sirius Bagged Canister Vacuum

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

A senior test project leader stated that one of his top tips for lengthening a vacuum`s lifespan is “Don`t let the bag or bin get filled to the brim, which can clog the machine.” In addition to the extra work, dust escaping from a reused bag tends to go right back into the motor, causing damage.
You can remove the plastic strip on the bottom to quickly empty the dust bag. After emptying, slide the plastic strip back onto the dust bag and place the dust bag back into the appliance.
This bag fits all pull along with Miele vacuum cleaners; it`s washable and reusable. Simply slide the plastic bag slide to empty it and use it again.
If your vacuum has a disposable bag, remove and discard it. For vacuums that use a plastic canister, remove the bin and dump the contents in the trash. Disassemble as much of the dust cup as possible for easier and more thorough cleaning.
With average use, a Miele vacuum cleaner bag should last for around three months. However, this can vary depending on your home and how often you vacuum. If you have a large home or wall-to-wall carpets, budget to replace your bag every month.
Yes, You Can Reuse Zip-Top Bags!

You can absolutely use zip-top bags more than once as long as you wash them properly. One easy way to do that is by sticking them in the dishwasher. Just make sure they are turned inside out so that the soap and water clean the dirty side.

The Full Dust Bag Indicator in On

It is often recommended, however, that dust bags are replaced when they`re around two thirds full or once a month. Daily and extensive use of vacuum cleaners will create a need to replace dust bags more frequently.

A full vacuum bag can also cause the motor to overheat and eventually fail, resulting in costly repair expenses or the replacement of a new vacuum. If you are using an upright vac with a belt-driven system, a full bag will increase the amount of force required to spin the brushroll, which can damage the belt.
The Carpet and Rug Institute recommends replacing or emptying vacuum bags when they are half to two-thirds full. This may seem like a waste of a good bag if you use disposable bags, but it does make a difference and can make your vacuum last longer.
Miele`s vacuum bags should last you between two and three months. Combining the powerful suction of Miele`s bagged vacuum cleaners and a host of effective attachments, you`ll notice a huge difference in your cleaning abilities.
I used drawstring kitchen bags, but large black garbage bags would work very well, as they are less prone to tearing.
Using vacuum sealed storage bags saves you tons of space and protects your items from dust and mildew. It`s the perfect storage solution for anyone. However, to avoid ruining your clothes, you can`t use this solution for long-term storage.
An ill-fitting bag can let dust into your machine and damage the motor. Make sure the bag fits well and that it`s the correct size – a bag that`s too big or small or a different thickness from the branded one can affect suction.
How Often Should I Service my Vacuum? The recommended amount of time you should give your vacuum cleaner a little TLC is every 12 months.
To open the bag, you simply pull the zip apart. You don`t let the air in via the valve. All vacuum storage bags will leak in air over time – Neusu vacuum bags have been tested to keep out most of the air, with only minimal leakage, after over four months.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

My Miele bags for S241 vacuum cleaner have just been replaced by the new HyClean bag. There are less in the box and you can’t empty them either – a mesh of cords being in the way. I knoe you’re not supposed to empty them but for econpmy’s sake I do. Can you still buy the old non Hyclean type?
ANSWER : The old style bags are not available any longer. The new HyClean bags have a larger capacity then the original style. You get the same amount of capacity out a box of the new bags as you did the box of the old. I know they are still expensive. I would recommend calling an internet company and trying to buy a quantity of bags at a time to see if you can get a little better price.

Unbeknownst to me, someone took the bag out of my Kenmore Progressive vacuum and failed to replace it. I have been vacuuming without a bag for months, and today the vacuum stopped sucking. When I opened up the front to replace the bag, tons of dirt and dust came pouring out. I thoroughly cleaned the vacuum, put in a new bag, but still no sucking power. Just dust coming from the rear vents where one of the filters is. Is the vacuum ruined, or is it a simple solution of buying a new filter?
ANSWER : Sounds like you need to buy a new motor. All that grit and dust will ruin a motor and I’m surprised it lasted as long as it did.
.This is where a vacuum that won’t run without a bag would have been nice. (Aerus for one)

Electrolux Epic 6500SR Full Bag sensor working, Does not Reset properly
ANSWER : The problem was a sticking switch that was not being reset. The vacuum on/off switch mechanism is comprised of two switches. One is the main switch that turns the vacuum on and off. The second is a shut off switch that gets tripped when the full bag sensor is engaged. This second switch is supposed to get reset when you push the on/off switch on the outside of the machine. The full bag shutoff switch was stiff and it, therefore, was taking a couple of presses of the on/off switch to move the shutoff switch back into the running position.

Dirt devil vacuum cleaner–trouble vacuuming dirt and pet hair on carpeting –is the problem with the spinning brush which contacts the floor,  not contacting the carpeting??  I thought (when I bought this vacuum) that the aforementioned brush was adjustable to various heights of carpeting.  Sometimes, it seems like nothing is being vacuumed up –unless I have just put a new bag on the vacuum… Do I need or can I replace the spinning brush on the bottom of the vacuum so it kicks up and vacuums
ANSWER : Try replacing the belt. Rubber belts stretch out after about a year.

While vacuuming the red light for the bag of the vacuum came on and the vacuum stopped. The bag was no where near full so I replaced it with a new bag – same problem. It vaccumes for a minute or then stops with bag light on. It is the correct bag for the machine – so what’s the problem?
ANSWER : I’m assuming this is the Epic 6500 or similar model.
.Detach the hose, turn vacuum on. If it runs, place palm of hand against inport hole. If it shuts off the problem is with either the control valve setting or the control valve assembly itself.
.For cvs, turn dial on top of vacuum all the way to the largest dot, and try above test again. If that doesn’t work, then it’s the CVA. It needs to be cleaned or replaced, which is an in shop job. Fro repair, take it to the nearest Aerus Electrolux store. I recommend a full clean and service to remove any dust/dirt from the motor, fan assembly, and other internal parts.
.
.Another problem, which relates to the dial setting, is that fine dust will quickly clog the pores of the bag, resulting in the machine “thinking” the bag is full. Turning the dial to the proper setting helps get the bag fuller. The middle setting is the normal setting, and is for areas without fine dust and sand.

The original belt on my upright Kenmore Progressive broke and I replaced it with the spare that was in the vacuum. The vacuum and spare belt are about 10 years old. Then the spare broke after one vacuuming session and there was a burning smell coming from the vacuum. I ordered new belts and replaced it with the new belt. It seems to be working fine with no smell. I checked the belt after I vacuumed the family room and although it was in tact, the belt was very hot. Is that normal? Should t
ANSWER : The belt heats up due to the friction, as well as being in contact with the shaft of a hot motor. It is normal.

I have 2 Hoover Wind Tunnel-self propelled bagged vacuums-U6433-900 model.The roller bar does not agitate, the self propelled feature does not work and, in general, the vacuum is not performing well. I have replaced the roller bar, the v belt and the wide belt. The filters have been replaced and it has a new bag. I have had both of these since 2004 and they were fairly expensive $200 each) but if the repairs are prohibitive, I might as well get new vacuums. Suggestions? I just spent $100 for bel
ANSWER : The Hoover WindTunnel self propelled is a machine that we see in our retail stores (Vacuums Unlimited) constantly. The benefit of having a supposed “self-propelled” machine wears of quickly after the numerous time you will need to take this machine in for repair.

It’s unfortunate you’ve had to spend so much money already on repairing this machine. I know you’ve said you’ve already replace the belts and filters, but if you want you can check out a video we made on repairing the Hoover Windtunnel.

http://www.youtube.com/watch?v=meX8lgZo7DY

If you are looking for a reliable upright, at GoVacuum we’d recommend the Sebo X4 upright (http://www.govacuum.com/seauxseupvac.html). The machine is incredibly reliable and easy to maintain. Thus far, we haven’t had one warranty repairs come through our doors. The machine itself has a lifelong warranty on the belt because the machine automatically shuts off the motor if an obstruction is detected, preventing any undue stress on the motor or belt.

I was vacuuming and noticed that the bag needed changing. the red light with the ! inside the triangle also came on. When the bag was changed, the vacuum would not restart. The red light came on. Tried the reset button but nothing happened. Tried unplugging and re-plugging in and nothing happened. Replaced all the filters and still it wouldh’t start. So I brought it downstairs and tried one more time to get it to start. it worked! Is there something wrong with the vacuum cleaner? Was it overheat
ANSWER : It was overheated that is why it worked downstairs after cooling off.