Miele S371 Bagged Canister Vacuum

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

To do this, turn on the vacuum and press the reset button. The service indicator light will turn off and then be reset to its original position. This will only work if the indicator light has already come on, not if the reset button has been pushed between filter changes.
There are three main causes for your Miele to not power on: The power switch has failed. The cord reel is damaged. Your motor has gone bad.
Overheated Motor

If your vacuum was working fine and then suddenly shut off, it may have overheated. Most vacuums are equipped with a thermal protector safety switch that won`t allow the motor to run when it becomes overheated. You will need to wait for 30 minutes to 2 hours, depending on your machine, to try again.

Alternatively called the reset switch, the reset button allows devices that utilize it, such as a computer or peripheral to be rebooted. Usually, the button is on the front of the device, next to or near the power button.
Durability & Warranty – If you`re looking for a vacuum cleaner with durability and longevity, look no further than Miele. Miele vacuum cleaners are designed and tested to last for 20 years. Miele vacuum cleaners come with a 7-year warranty on the motor and a 1-year warranty on parts and labor.
If your Roomba® i Series Robot Vacuum is not turning on or is not able to charge, rebooting your robot tends to solve most related issues. To reboot your Roomba: Press and hold the CLEAN button for 20 seconds. After you release the button, the light ring will show a white clockwise swirl while it reboots.
Some vacuums have an in-line thermal fuse (often located between the switch lead and the motor coil). If the fuse is blown it will need to be replaced. – Check your home circuit breaker – it may have tripped. – Some vacuums have a brushroll on/off control.
If all you hear from the vacuum unit is a click at the when you try to start the vacuum motor from inside the house, then the motor in the unit is dead and has to be replaced. A strong odor from the shellac, which coats the copper coil windings, is an indicator that the motor is about to or has burnt out.
The problem may lie in your vacuum cleaner`s adapter, charging dock, or battery and the electrical outlet. Try plugging your vacuum cleaner in to another outlet. If it is now working, the problem was in the first outlet that you have used. You should contact a certified electrician if you need to fix that outlet.
Factory reset on a Wi-Fi Connected Roomba® and Braava jet®

e Series Robots: Press and Hold the Home and Spot Clean and CLEAN button down for 20 seconds then release. 900 Series Robots: Press and Hold the Dock and Spot Clean and CLEAN button down until all LEDs illuminate.

Reliable protection against overheating

A temperature limiter protects all Miele stick vacuum cleaners from overheating. Should the air passage become blocked – for instance by vacuuming up bulky particles – the motor will automatically shut off for safety`s sake.

Durability & Warranty – If you`re looking for a vacuum cleaner with durability and longevity, look no further than Miele. Miele vacuum cleaners are designed and tested to last for 20 years. Miele vacuum cleaners come with a 7-year warranty on the motor and a 1-year warranty on parts and labor.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

Reset button The drive belt on my machine broke. They sent me a new one and I installed it, I think, correctly. It still won’t engage and rotate the brushes. I can’t find a reset button, but I suspect it needs to be reset. Where is the button? Theresa
ANSWER : Do the brush rolls turn ok? The brush roll motor may be bad.
.
.c2531b4.jpg

I have a miele S712 (2 yrs old worked fine yesterday) – I had been doing some diy work inside and had the vac on just to reduce some of the dust in the air – after a while the vacuum fizzled out. I guessed it had overheated and took it outside to cool down – when I tried to turn it back on pressing the power button gives it power and it starts to **** but it won’t STAY on, soon as you release the power button it stops, and the orange bag indicator is showing full. As I have a compressor I took
ANSWER : You have got dust in the micro switch and it is not latching on, if you look at this and clean it, that will solve your problem, however blowing the motir has probably wrecked the motor bearings.

Our Electrolux canister vacuum just stopped working when we were vacuuming the floor. The power does come on when the power head is attached but as soon as the power head is removed the power shuts off. I tried pressing the reset button but that doesn’t help. Is there a solution that I can try at home?
ANSWER : Sound like you problem is in the connection going to the power head you will see a small screw on the power nozzel where it joins to the handle take out the screw and take it a part you will see where one of the bars have been disconnect from the power.

When i hit the power button on my miele carina, it doesnt lock and stay on. i have to hold down the power button for the power to stay on. Please advise
ANSWER : Try a little WD-40 sprayed sparingly on the button. work the button a few times- may be sticky spring or contact. if that doesn’t work, check with retailer where you purchased it- see if you can get a replacement switch! if you’re handy, or have a handy friend, you can prob. replace it yourself!
good luck!

Roomba discovery on full charge power up and it will run 5 sec power button then flashes red and roomba quits. I have tried removing battery and holding power button for 30 sec then charging same result
ANSWER : Unfortunately the batteries on the roombas can go bad and not hold a charge and need to be replaced, also you should check all the brushes and wheels on the bottom, if they are bound up it would stop the roomba from working. the two brush rollers can be removed by pushing on the two tabs just above them, try and clean any hair from them. if its real bad you should buy the maintance kit from them witch gives you both brushes and filters as well.

Ive got a miele revolution 5000 power plus and its just cut out the green power button on the handle is on but the orange button on the body does not come on it just flickers unless i open it up, any ideas?????
ANSWER : Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=640910
.Generic problem for all Vacuums
.I’ve got a Miele revolution
.Posted by rowler on Jun 02, 2008
.I’ve got a Miele Revolution 5000 power plus and it’s just cut out the green power button on the handle is on but the orange button on the body does not come on it just flickers unless i open it up, any ideas?????
.
.Hello,
I would advise you to ALWAYS to FIRST UNPLUG YOUR VACUUM before beginning any service procedure. I am not familiar with the light system on the Miele Revolution 5000 Power Plus

.But it has something to do with the electronic hose assm or the circuitry in the vacuum itself. I have listed the factory phone # listed below for your further information. So if you need further assistance, please feel free to contact your local vacuum cleaner dealer in your area or in the yellow pages, or contact the factory phone number or website to further assist you with your questions.
.http://miele.com/ Customer Service, Repairs, Parts 1-888-785-2828
.Mailing address listed below:
.Miele, Inc
.9 Independence Way
.Princeton, NJ 08540
.http://www.a-1vacuum.com/ 1-800-657-1874 Customer Service
.Thanks, Don the Vac Man
Go Ahead. Use Us.

Our Miele vacuum is only 2/3 years old and seems to have given up the gost, our previous one lasted 15 yrs. The machine starts ok and within 4/5 minutes the power drops down and the hoover comes to a stop and it may re-power itself again within minutes, as of today their is no power when the on button is pressed. What do you think the problem is Thank you.
ANSWER : There is a circut board that is going bad and not providing the power to run the motor. You will need to contact a Miele dealer for that part. It is the only board that is in this machine so they should just need a model number in order to get it for you.

I need to know if it has a reset button. we had a power outage and it has stopped working since than. cant find a button to reset it.
ANSWER : Vacuum cleaners do not have reset buttons instead it would have a thermal protection breaker integrated within the motor if the motor overloads it will shut off but will start again as it cools down.Check to make sure the outlet has power in it first. Vacuum cleaners are usually reliable since they are not subjected to prolonged use unless it is used in commercial environment, but a common problem with it is a bad internal connection usually around the motor area due to vibration.