Rainbow E series Canister Wet/Dry Vacuum
How to Identify and Fix Common Vacuum Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :
Louder sounds, like knocking or banging, should be looked at immediately. In most cases, this is often caused by something clogged in the hose or an attachment, but may be a motor issue.
To power on the unit, press down on the main power button. The Rainbow will always start in high speed. To power off the unit, press down on the main power button.
If your Roomba® i Series Robot Vacuum is not turning on or is not able to charge, rebooting your robot tends to solve most related issues. To reboot your Roomba: Press and hold the CLEAN button for 20 seconds. After you release the button, the light ring will show a white clockwise swirl while it reboots.
If you follow these basic guidelines, expect your Rainbow to last some 20 to 30 years because it is a very robust machine. Let`s go through them one by one. Here are some basic maintenance tips from what to do after you throw water away to cleaning the brush roll…
We repair more Rainbows than any other company in the world. Our factory-authorized repair technicians have the expert knowledge and experience needed to keep your vacuum running like new. There are no gimmicks or empty promises, only reliable repair services from a name you can trust.
Clog located in the vacuum hose
Turn the unit on and feel the suction at the end of the hose handle. If there is no or low suction, then the clog is in the hose. You can remove the clog by running a long, stiff object through the hose, such as a butter knife, starting at the wall end.
If the SRX Rainbow experiences a fault, a red light will flash. As the owner`s manual explains, a solid red light means it`s a problem with the blower motor. A steady blinking red light means there`s a problem with the accessory attached to the Rainbow.
They use them in their firing room and to protect their historic artifacts. The clean room and the elaborate steps taken before entering it are vital to the success of every Hubble mission.
It is the only vacuum that is a certified air purifier and is designed to run 24/7 on a lower speed to purify the air in the home. The unique difference is the water. All dirt and dust is trapped in a basin of water so that no debris can re-enter the home atmosphere.
On average, a well-maintained robotic vacuum cleaner can last up to 4-6 years, but some models may last even longer.
With proper care, your robot`s battery should last at least 2-3 years before it needs to be replaced.
Factory reset on a Wi-Fi Connected Roomba® and Braava jet®
e Series Robots: Press and Hold the Home and Spot Clean and CLEAN button down for 20 seconds then release. 900 Series Robots: Press and Hold the Dock and Spot Clean and CLEAN button down until all LEDs illuminate.
With a high and low speed, you can run your Rainbow 24/7 to clean the air without disturbing your home in the process. The low speed is quiet and unnoticeable when standing right… The Rainbow water filtration is something you must see to believe. Once dust and dirt get wet, they can`t go back into the air.
The Birth of the Rainbow
1955 brought about a dramatically improved Rexair Cleaner. With a sleek, streamlined design and a motor twice as powerful as its predecessor, Rexair executives decided to rechristen it the “Rainbow.”
Upholstery. Loosens and eliminates hairs, dead skin, bed bugs, crumbs and other particles.
The Rainbow E2 Wet/Dry Canister Vacuum features Rexair`s popular air/water filtration system.
The Rainbow uses Mother Nature`s most powerful element, water, to trap dirt and odors, returning only naturally clean, water-washed air to your home environment.
The vacuum drying process often involves multiple steps of applying heat and vacuum. Reducing the pressure (applying vacuum) at the surface of a liquid (such as water) will allow the liquid to evaporate without elevating the temperature.
Vacuum means the absence of all matter including air. As there is no air in the vacuum, air pressure will be zero.
Common signs include poor fuel efficiency, difficulty pressing the brake pedal, oil leaking under the engine, and the AC not working.
Vacuum emissions include salmonella and other bacteria that “have potential to spread infectious or sensitizing aerosols,” they concluded.
What should I do? If your vacuum cleaner whistles, this is usually a sign that your device can`t suck in sufficient air. Often, it`s the dust container or bag that`s full. Check these first and exchange them if necessary.
The vibrating of the cleaner`s body – noise happens as air moves around inside the machine and hits various parts of the cleaner. This creates vibrations, which are the sounds you can hear. Many cleaners are made with plastic bodies, which make loud noises when they vibrate.
The water is the fluid which traps every dust and dirt particles that come into the Rainbow, Running your Rainbow without water allows all these particles pass into the Rainbow internal parts, and also clogging your HEPA filter, which is designed to be a backup filter to work together with the water.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
My rainbow wont start. When I try to turn it on it makes a beeping nose and then nothing. How do I fix this? Or what could the problem be?
ANSWER : Most likely your controller is bad. Give us a call and we can see if you are still covered under the warranty.
RainVac
www.rainvac.com
800-523-0510
RainVac
www.rainvac.com
800-523-0510
Read Full Q/A … : Rainbow E series Canister Wet/Dry Vacuum
My rainbow wont start. When I try to turn it on it makes a beeping nose and then nothing. How do I fix this? Or what could the problem be?
ANSWER : I am having the same issue did you ever get an answer of what the problem was?
Read Full Q/A … : Rainbow E series Canister Wet/Dry Vacuum
Henry hoover Hi all,
I bought a spares/ repairs Henry on ebay having been told there was no cable rewind and believing that since I had a spare one in the shed it would be an easy fix. However, poor Henry had his cable replaced to find when plugged in, he tries to start but nothing happens. The motor turns once and just cuts out. If you turn it on and off again it happens again. One whir and turn of the motor, then nothing. It blew the fuses out in the kitchen first time too, so could it be a re
I bought a spares/ repairs Henry on ebay having been told there was no cable rewind and believing that since I had a spare one in the shed it would be an easy fix. However, poor Henry had his cable replaced to find when plugged in, he tries to start but nothing happens. The motor turns once and just cuts out. If you turn it on and off again it happens again. One whir and turn of the motor, then nothing. It blew the fuses out in the kitchen first time too, so could it be a re
ANSWER : Hi it can be the connector at the end of the Henry cable inside the cable rewind unit happened to us!
Read Full Q/A … : Rainbow E series Canister Wet/Dry Vacuum
Stopped running My mother’s Oreck vacuum sound as if there was something bogging the rotating brush down. I pulled the bottom cover off and found nothing wrapped around or restricting the brush. I tried to finish vacuuming with the problem then I turned it off to move a chair and turned it back on it would do nothing. Any suggestions as to what could be causing the vacuum to sound as if the rotating brush is being restricted from turning. There was not odor of burning as if the motor was in a bi
ANSWER : Orecks have a plastic fan inside and everything you pick up hits it, sometimes things can get stuck in there or break the fan locking up the motor. With the machine off, poke around where the dirt goes into the motor, behind the roller and see if you can pull anything out.
Read Full Q/A … : Rainbow E series Canister Wet/Dry Vacuum
Had my dyson root cyclone for about 4 years now, and in the last year it’s had a few problems. About 4 months ago it started to make this awful grinding sound when the roller bar was engaged and I took it to a repair shop and they said it was the roller bar itself. The shop replaced the part and it worked fine for a couple of months and then it started to make the grinding noise again. I tried the clutch reset suggestion (turn it on its side and turn the carpet/bare floor switch slowly back and
ANSWER : Bdepends how much thay charged you for a roller brush because you can buy a good vac for about 100 pounds with a 12 month guarentee so its up to you
Read Full Q/A … : Rainbow E series Canister Wet/Dry Vacuum
I have a dyson canniter stow away vacuum. i’ve had it for 2 years and it just started having a problem. when i turn it on the motor starts just fine but the vacuum head does not turn on. Yet when i push it forward it trys to start and turns on for a second and turn off – almost like the connector isn’t connecting the hose to the head very well anymore.
ANSWER : Hi, After reading you’re problem, the symptom’s are just like you said. Its just a matter of checking the connections. The connection where it plugs into the head it self. When you push forward the forward motion and down pressure makes the connection for a few seconds. Anywhere you have a power connection double check it to see if it is loose. I wouldn’t think it is a serious problem, just a matter of looking it over very good. You should have no problem in finding the solution.When you first turn it on is when the head should also turn on, so, that’s where I would check first where the hose connects to the motor. Move the hose and head around to see if it trys to start and see if you can locate the problem. Keep me posted on what you have found and we can go from there.
Sincerely, Shastalaker7
Sincerely, Shastalaker7
Read Full Q/A … : Rainbow E series Canister Wet/Dry Vacuum
When I turned on the sweeper it would not start. I put a different power cord on it and it worked fine. now it won’t start but the light on the brush and the bag full will flash when i turn it on and off but it wont start. i have 2 of these doing the same thing. do you have any idea what could be wrong. I have checked for clogs but have found none. Bob
ANSWER : Its sounds to me like the computer board inside the machine has gone bad. Keep in mind that the filters in these machine do need to be replaced regularly to keep the vacuum working correctly. Any good vacuum shop should be able to fix your problem. Reguardless of what they might tell you there these really are one of the best machines on the market and definatly worth having repaired.
Read Full Q/A … : Rainbow E series Canister Wet/Dry Vacuum
Infinity Vaccum by Shark, model number NV31COS, will not start. The vacuum was running just fine until it grabbed the edge of a curtain. Turned it off to release the suction. Turned it back on and was working fine. About a minute later the vacuum was making an odd noise. Every 2 seconds or so it would “heave” (lack of a better word) then go away, then come back and so on. Turned the vacuum off and checked for blockage, none that could be seen or felt, and now the vacuum won’t turn. Any suggestio
ANSWER : Carpet brush won’t turn when vac on
Read Full Q/A … : Rainbow E series Canister Wet/Dry Vacuum
