Euro-Pro Shark Steam Mop – Gray/ Purple Vacuum

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

The Cleaning Nozzle is clogged

Calcium and other minerals may build up in the nozzle, so you may need to clean the nozzle in order to produce steam. To do this, either use the nozzle cleaner provided with the Steam Pocket Mop, or use a straightened-out paper clip.

Heating Element. A common cause to your cleaner not producing steam can be a failed heating element. As the heater is used to heat up the water, if that has ruptured or burnt out your steam cleaner will not produce any steam. With the water tank filled and switched on the steamer should sound like a boiling kettle.
Too Much Water:

Your steam cleaner producing more water than steam is likely to be caused by one of three things: 1) The water tank being overfilled. 2) The controller not being set to steam mode. 3) The steam cleaner not reaching its required temperature.

The symptoms are that the steam mop is hot and makes a buzzing noise but no steam is produced. The fault is due to a small one way water valve in the body of the mop becoming stuck closed. The video show you how to dismantle the steam mop, remove the valve, repair the valve and then reassemble the steam mop.
Tap the mop firmly on the floor a few times to get it steaming again. My mop is still not steaming. Try running a bit of vinegar through your mop. There may be a mineral build-up from your tap water.
Pull the wound-up power cord out of the mop and plug it into a 120-volt outlet. The on/standby button will start flashing blue. The mop only takes about 30 seconds to fully heat up.
We have had some customers who have had their steam cleaners for 5-8 years and are still going strong. For less expensive models like the steam mops or handhelds, you should probably expect more like 3-6 years of consistent use.
Yes. I only use water in the steam tank. The mop does come with a separate handle that attaches to the mop head so you can use the same head without any steam. There is a refillable spray bottle that comes with a cleaning solution to use on hard floors with the no steam version of the mop.
Using the Shark Steam Mop is pretty straightforward. First, attach the mop pad to the mophead, then fill the reservoir with water using the filling flask. Once the steam mop is plugged in, it takes about 20 seconds for the steam to build up, and you`ll hear the mop hissing.
check the cap of the water tank to make sure it is correctly and securely attached to the water tank. check your water tank to make sure it is securely and correctly fitted in to the body of the garment steamer – incorrect placement of the water tank can block water from feeding in to the body and boiler of the steamer.
check the cap of the water tank to make sure it is correctly and securely attached to the water tank. check your water tank to make sure it is securely and correctly fitted in to the body of the garment steamer – incorrect placement of the water tank can block water from feeding in to the body and boiler of the steamer.
After use, unplug your steam mop and let it cool before removing the Dirt Grip pads. Empty the water tank before storing. Wait until it has fully cooled and all the steam has been released. Machine wash your Dirt Grip pads separately, with warm water, using liquid detergent.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

For some reason, our shark steam mop stop working. Usually after I plug the steam mop, the power light would light up then you would hear & see steam coming out of the mop’s head but all of
ANSWER : HEATING ELEMENTS BURNT OUT. WILL COST OVER $100. TOFIX. SHARK NOW HAS A NEW MODEL “SHARK 3” MUCH BETTER

After plugging in the steam mop, waiting for the 30 sec, pumping 12-15 times – no steam comes out. the tank is full and if i take off the bottom attachment the steam sprays everywhere. but the steam will not come out when mop head is on. thanks
ANSWER :

Hi,

Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it may not be getting steam to the head…

Euro-Pro Shark Steam Mop Problem

Here also is a link to get any of the Shark Manuals that you need.

heatman101

,..,..,,

Kenwood Steam mop
ANSWER : The Manufacturer suggests you clean the hose by removing the water tank dammed if u can get it off though.

Streaks on porcelein tile from shark steam mop
ANSWER : I have the same problem!!! its driving me nuts, i think its the microfibe pads that do it. I used the kenwood steam mop and it didnt have a microfibe cleaning pad on the bottom of it and it cleaned it perfectly, no streaks! because that blew up i have the monster mop and it streaks every time, i ended up wraping a bath towl around the base and mopping with that on it, dont know what else to do?

My euro steam mop is not getting steam to the head, it gets hot but no steam comes out. looks like an ongoing problem with these mops/ can you help?
ANSWER : Hi,

Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head…

Euro-Pro Shark Steam Mop Problem

Here also is a link to get any of the Shark Manuals that you need.

heatman101

My steam mop doesn’t have steam coming out of it do you know what’s the problem?
ANSWER :

Hi,

Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it may not be getting steam to the head…

Euro-Pro Shark Steam Mop Problem

Here also is a link to get any of the Shark Manuals that you need.

heatman101

,,,,,,,,,,,/

I loved my Shark Steam Pocket Mop, but it suddenly stopped producing steam through the mop heads. The water is heating and I can see and hear steam coming out of the actually body of the mop, but it will not go through to the head. I have thought of running white vinegar through it. Do you have any suggestions?
ANSWER : Hi,

Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head…

Euro-Pro Shark Steam Mop Problem

Here also is a link to get any of the Shark Manuals that you need.

heatman101

Shark Steam Mop – Gray/ Purple Vacuum: I left water in the steam mop and now the steam is…
ANSWER : Hi,

Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head…

Euro-Pro Shark Steam Mop Problem

Here also is a link to get any of the Shark Manuals that you need.

heatman101

k