My steam mop no longer produces steam - Euro-Pro Shark Steam Mop

Euro-Pro Shark Steam Mop – Gray/ Purple Vacuum

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

The Cleaning Nozzle is clogged

Calcium and other minerals may build up in the nozzle, so you may need to clean the nozzle in order to produce steam. To do this, either use the nozzle cleaner provided with the Steam Pocket Mop, or use a straightened-out paper clip.

First, check to make sure the unit is plugged in and is in a working outlet. Next, check to make sure there is water in the tank. It is very important to make sure you are ONLY using water to fill the tank. Other solutions may cause breakdown of the gasket and/or other parts of the machine.

Tap the mop firmly on the floor a few times to get it steaming again. My mop is still not steaming. Try running a bit of vinegar through your mop. There may be a mineral build-up from your tap water.

Too Much Water:

Your steam cleaner producing more water than steam is likely to be caused by one of three things: 1) The water tank being overfilled. 2) The controller not being set to steam mode. 3) The steam cleaner not reaching its required temperature.

Check for a clogged hose or filter; unclog the hose and replace the filter. Wait 45 minutes for the vacuum to cool; then plug in the vacuum. Turn the power switch to the “I-On” position to start the vacuum. If the vacuum still does not start, contact Customer Service at 1-800-798-7398.

check the cap of the water tank to make sure it is correctly and securely attached to the water tank. check your water tank to make sure it is securely and correctly fitted in to the body of the garment steamer – incorrect placement of the water tank can block water from feeding in to the body and boiler of the steamer.

Just as you`d regularly descale a kettle or iron, you need to descale your steam mop. A few times a year, you`ll need to use a mild acid to get rid of the limescale. Always check the instructions for your steam mop before you clean it.

To prolong the life of your steam mop, we recommend using distilled water in the tank. Make sure you only add water to the tank – chemicals or cleaning solutions (including vinegar) may damage the steam mop and could be unsafe. For best results, sweep or vacuum your floors prior to cleaning with your steam mop.

The manual recommends distilled water. Water contaminants will clog the steam nozzle, which is applicable to the question about additives. Spray cleaners like 409, etc. on the extreme dirt areas of the floor or surface before steaming.

If there is an odd-looking substance on the pad, the streaking is likely being caused by dirt or residual cleaning products. If you have used floor polishes or wax on your floor, use of any steam product may decrease the glossiness and you could refer to the manufacturer of the wax or polish for removal.

Removing limescale stains with a steam cleaner

If lime deposits are not yet very thick, they can be removed quite easily with the steam cleaner – without the need for tiresome manual scrubbing.

If you have checked for airway blockages and have cleared your filters, a damaged or deteriorating hose may be causing your vacuum`s loss of suction. On most Shark vacuums, there are two hoses to check, the short hose between the main vacuum head and the base, and the hose between the handle and the wand.

If your Shark vac has a hose, feel along the length for any lumps. That indicates a clog that`s causing your suction issues. See if you can break the clog by applying gentle pressure with your hands, or gently move it to the end of the hose to remove it.

Only Use Water in the Reservoir

With the exception of a few models that have dual functions, steam mops are typically designed to be used with water and nothing else. The steam alone does a great job of cleaning the floor. Always read the manual on your mop model thoroughly for complete use guidelines.

Not Plugged In

You will notice a blinking blue light on the front of the device when plugged in correctly. If the light fails to come on then try to plug into a different outlet.

To prolong the life of your steam mop, we recommend using distilled water in the tank. Make sure you only add water to the tank – chemicals or cleaning solutions (including vinegar) may damage the steam mop and could be unsafe.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

For some reason, our shark steam mop stop working. Usually after I plug the steam mop, the power light would light up then you would hear & see steam coming out of the mop’s head but all of

ANSWER : HEATING ELEMENTS BURNT OUT. WILL COST OVER $100. TOFIX. SHARK NOW HAS A NEW MODEL “SHARK 3” MUCH BETTER

Read Full Q/A … : Euro-Pro Shark Steam Mop – Gray/ Purple Vacuum

Shark Steam Mop – Gray/ Purple Vacuum: shark steam mop has water, but there is no steam….

ANSWER : I tried running vinegar through as you would a coffee pot to get rid of hard water scales. This did not work. Then I noticed that the light behind the shark decal on the front of the machine was going off and on. And sure enough as I moved the cord around the light would come off and on. Looking closer I could see the the heat had melted thru some of the cord.I bought mine at Target before xmas last year, throwing away the sales slip after several months so I guess there is nothing I can do about it.

Read Full Q/A … : Euro-Pro Shark Steam Mop – Gray/ Purple Vacuum

My steam mop no longer produces steam – Euro-Pro Shark Steam Mop – Gray/ Purple Vacuum

ANSWER : Hi,

Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head…

Euro-Pro Shark Steam Mop Problem

Here also is a link to get any of the Shark Manuals that you need.

heatman101

Read Full Q/A … : Euro-Pro Shark Steam Mop – Gray/ Purple Vacuum

Shark steam mop is no longer making steam – Euro-Pro Shark Steam Mop – Gray/ Purple Vacuum

ANSWER : Normal. 0. . . . . . . MicrosoftInternetExplorer4. ...... /* Style Definitions */. table.MsoNormalTable.\011{mso-style-name:”Table Normal”;.\011mso-tstyle-rowband-size:0;.\011mso-tstyle-colband-size:0;.\011mso-style-noshow:yes;.\011mso-style-parent:””;.\011mso-padding-alt:0in 5.4pt 0in 5.4pt;.\011mso-para-margin:0in;.\011mso-para-margin-bottom:.0001pt;.\011mso-pagination:widow-orphan;.\011font-size:10.0pt;.\011font-family:”Times New Roman”;}....
..Hi,
.
.Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it may.not be getting steam to the head…
.
.Euro-Pro Shark Steam Mop Problem
.
.Here also is a link to get any of the Shark Manuals that you need.
.
.heatman101
.
.
.

Read Full Q/A … : Euro-Pro Shark Steam Mop – Gray/ Purple Vacuum

Steam mop no longer produces steam – Euro-Pro Shark Steam Mop – Gray/ Purple Vacuum

ANSWER : Hi,

Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head…

Euro-Pro Shark Steam Mop Problem

Here also is a link to get any of the Shark Manuals that you need.

heatman101

Read Full Q/A … : Euro-Pro Shark Steam Mop – Gray/ Purple Vacuum

Shark Steam Mop – Gray/ Purple Vacuum: When washing the shark steam mop pads, can I use a…

ANSWER : Normal. 0. . . . . . . MicrosoftInternetExplorer4. ...... /* Style Definitions */. table.MsoNormalTable.\011{mso-style-name:”Table Normal”;.\011mso-tstyle-rowband-size:0;.\011mso-tstyle-colband-size:0;.\011mso-style-noshow:yes;.\011mso-style-parent:””;.\011mso-padding-alt:0in 5.4pt 0in 5.4pt;.\011mso-para-margin:0in;.\011mso-para-margin-bottom:.0001pt;.\011mso-pagination:widow-orphan;.\011font-size:10.0pt;.\011font-family:”Times New Roman”;}....
..Hi,
..

Yes, ammonia should not hurt anything as all of the parts are plastic and there is nothing to corrode…
.
.
.Euro-Pro Shark Steam Mop Problem
.
.heatman101
.
.

Read Full Q/A … : Euro-Pro Shark Steam Mop – Gray/ Purple Vacuum

Shark Steam Mop – Gray/ Purple Vacuum: I left water in the steam mop and now the steam is…

ANSWER : Hi,

Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head…

Euro-Pro Shark Steam Mop Problem

Here also is a link to get any of the Shark Manuals that you need.

heatman101

Read Full Q/A … : Euro-Pro Shark Steam Mop – Gray/ Purple Vacuum

My shark steam mop does not steam – Euro-Pro Shark Steam Mop – Gray/ Purple Vacuum

ANSWER : Try cleaning the heating elements of lime deposits or adding a small amount of salt to the water.

Read Full Q/A … : Euro-Pro Shark Steam Mop – Gray/ Purple Vacuum