ins
Dyson DC31 Animal Bagless Handheld Cyclonic Vacuum

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

If you find that your machine is turning off intermittently, the filter in your vacuum is most likely full and covering the ventilation system. Remove the filter, then empty and wash it. Allow the filter to dry for at least 24 hours, or until it is completely dry.
If your vacuum cleaner keeps turning off, this could be due to the following reasons: Blockages – check the hose and head for any obstructions. Filter – always check your filters, if these are clogged this could be causing the vacuum cleaner to work harder and lose suction power.
One of the first things to do when your Dyson vacuum cleaner keeps starting and stopping is to empty the bin. It may be full, or the machine may simply perceive it as too full to continue working. Dyson vacuum cleaners require constant airflow through them to work, and a full bin can stop this from happening.
The superficial causes for your VAX vacuum shutting off during use can be from blockages along the hose and body of the model. There can also be a blockage caused by a build-up of dust, dirt, hair and debris across the models` brush bar.
Check For Clogs or Blocks In The Vacuum

Check the hoses, the filters, and throughout the vacuum, and clean out any blockages or clogs. Vacuums will likely also have a recommended cooldown time to ensure that the vacuum won`t overheat. You will need to wait for that time before you turn the vacuum back on.

This usually happens because the filters need washing or your machine is blocked. If your machine continues to overheat, please refrain from using it until it has cooled down sufficiently and then carry out the performance checks.
A vacuum cleaner can run continuously for 30 – 60 min each time. The vacuum cleaner has no suction power. For example, a hair cannot be sucked up.
If the filter bag or canister is too full, it cannot pick up any additional particles and will simply jam or the motor will overheat and shut down. So, when you suspect your unit is about 75 per cent full, empty it! Don`t wait until it`s packed to the brim, clean it out and prevent the breakdown.
There are many reasons why your Dyson Airwrap may be overheating and shutting off. This could include excessive use, a clogged filter, or blocked air vents. Fixing this issue is relatively straightforward. First, make sure to give your device a break in between uses.
To reset, remove the Powered Head from the reach wand/handheld and clear any obstruction. Wait 1 minute before refitting the Powered Head, switch the slim vac on and press the brushbar on/off button.
A damaged vacuum hose, clogged motor air filter or bad suction motor can cause the vacuum cleaner to shut off during use. A tripped overload on the vacuum suction motor can shut off the vacuum cleaner during use. If your vacuum has a reset button, push it; if the vacuum seems hot, let it cool off first.
The most common problems found in vacuum cleaners are low suction force, excessive noise, burning smell, vacuum not turn on, and overheating. These issues can be fixed by either cleaning the device or replacing some parts of the device. At times, it is best to seek a professional to fix the cleaner effectively.
Over time, all batteries are subject to degradation. So if your run time has declined when the machine is not in Max / Boost mode, it might be time to buy a new battery.
Thermal Cut Out

Common causes of the machine overheating are because the filter needs washing or the machine is blocked. In addition, if the Dyson vacuum turns off while in use, unplug the machine and let it cool down for about an hour before plugging in again.

Introduction. Is your Shark ION Robot S87 battery draining quickly or not charging? This is because batteries have a life span which decreases with every charge. If that is the case, you may need to replace the battery.
If the vacuum is not plugged into its power outlet correctly, it will not turn on. Check to make sure that the vacuum`s electrical cord is completely plugged into the outlet. Additionally, the power outlet could be a problem.
Vacuuming every day, or even a few times a day, is not going to create any long term problems. `But,` you might be thinking, `doesn`t the brushes spinning over the carpet on a beater bar wear it out? ` Sure, but a very small amount.
The average life expectancy of a mid-range vacuum cleaner is about six years. You can fix or replace things like blocked filters, jammed brush rolls, frayed hoses, worn-out stick vac batteries and broken accessories yourself.
Problems can occur when overused or clogged filters cause the vacuum motor to overheat. This not only shortens the motor life but causes a loss of suction. In some cases, total motor burn out can occur.
Clog located in the vacuum hose

Turn the unit on and feel the suction at the end of the hose handle. If there is no or low suction, then the clog is in the hose. You can remove the clog by running a long, stiff object through the hose, such as a butter knife, starting at the wall end.

When your Dyson no longer powers on even after charging the most likely cause is a damaged battery. This means the battery will no longer hold a charge and will need to be replaced. Once a new battery is purchased you can learn how to replace it by visiting our battery replacement page here.
If your dyson vacuum isn`t turning on, don`t panic – there are a couple possible causes. It could simply be that the vacuum overheated and shut itself off. If that is the case, wait 24 hours and turn it back on. However, another problem with dysons are failed power switches.
Summary. Dyson batteries should last around 2-6 years before needing to be replaced. This wide range reflects the fact that how you care for and maintain the battery will affect how long it lasts. If you want your vacuum`s battery to last longer, make sure it`s stored at room temperature.
Check Your Battery & Charger:

Also, make sure the charger is plugged in correctly too. Batteries don`t last forever depending on age and use. You may need to buy a new battery if your Dyson vacuum is turning on and off after only a few minutes of use.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

My vacum keeps sutting itsself off after a few mins of use. I need to vacum the whole house and dont have tinme for it to cool down every 10 mins
ANSWER : Something is plugged. What you describe sounds like the motors’ thermal limiter is opening the circuit to prevent the motor from overheating. You need to open and verify that evey air passageway is clear and the unit has good air flow. I bet you find a blockage, and with one, cleaning ability would be severly diminshed.

Need to find the belt for the brush. Every sight leads me to drive belts and I dont need that. I need a model number prefferably
ANSWER : Unscrew both bolts that are in plain sight on top of vac above the brush, then remove housing and belt is right there

Will be using my dc07 for about 10 mins then it cuts out i leave it to cool then it goes for about 5 mins and carries on like this
ANSWER : There is a thermal cutout on the motor causing this problem because it is overheating. Either it needs the filter replacing and a good blowout with compressed air or the thermal switch is faulty. Try replacing the filters first and if the problem persists it is probably a faulty thermal cutout. Dyson can either replace under warranty or an engineer will call and do a home refurb for a fixed price of £60

Need instructions for use of dirt devil spot scrubber; have borrowed one to use to get some serious spots off of carpet; no instructions with it; need to know how to fill the container and how much solution to use for cleaning.
ANSWER : To have a manual mailed to you at no charge, please contact our customer service department at 1-800-321-1134.

Hello, my names Travis. I was contacting you in concern of my Kenmore Quick Clean 12AMP Vacum Cleaner. My girlfriend took the bottom off the vacum and removed the belt because the vacum wasnt picking up. I know have a new belt i just dont know where to put it on the vacum to reinstall it
ANSWER : Look for grooves on the motor shaft and on the brush shaft.

My Fantom Cyclone keeps turning off after 10 minutes of use. I will then let it sit for a few hours and then I can use it again for 10 mintues.
ANSWER : You may need to clean some internal filters. The one above the motor, just below the dust cup and maybe the exhaust filter

We have a Kenmore Progressive Model 116 Upright bagged vacuum with Hepa filter. It’s at least a couple years old. For quite some time now when ever we use the vacuum the vacuum motor will shut off nafter about 5 min. of use. We then need to let it sit for awhile and then we can run it again for another 5 min. The bag has been change. Any one have any ideas how to fix this?
ANSWER : I suspect that you have a restriction. The motor sounds like the thermal break is stopping the motor before damage, due to heat.
.You must witness that the entire suction and discharge side are clear. This is not always very easy, but necessary. I bet that you find something blocking somewhere…

I have a Hoover SteamVac F5914-900 SpinScrub… The last time I used the hand tool attachment, it worked fine. Just tried to use it again, and now I only drips of water will come out of the hand sprayer, if that. I have tried prepping it for up to 15 seconds like the manual says… no luck with that. Also it is making a big puddle on the floor, probably because the brushes on the main unit keep spinning when I am trying to use the hand tool which I dont think they are supposed to do? Can a
ANSWER : The brushes can be turned off on most of them via a switch on the hood. There shouldn’t be water coming out onto the floor unless you are pulling the trigger at that top. You probably broke this when attempting to use the tools.

http://www.vacuummedic.com/product.php?id=231

Good luck!