Bissell Upright Vacuum – The Pet Hair Eraser 1 ea Vacuum

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

Recharge the batteries according to the charging instructions. The spray tip may be clogged. Rinse the tip with clean water. If needed a paperclip may be inserted into the spray tip to unclog.
Locate the brush reset button on the lower back right of the vacuum. Press the button to reset the brushroll To ensure the brush has been reset, plug the vacuum back into the electrical outlet.
The battery lasts about 20 minutes, which is good enough for most tasks and should be enough to clean your car with.
The TurboBrush® Tool has a rotating brush that easily connects to most vacuum hoses and is recommended for cleaning stairs, upholstery, rugs and other difficult to reach areas in your home while vacuuming. The TurboBrush® Tool stores on board most BISSELL vacuums for easy and convenient above floor cleaning.
A turbo brush has rotating brushes that make the vacuum suck dirt out of high-pile carpets better or pick up pet hair from the ground better. If you have pets, high-pile carpet, or coarse rugs, a vacuum with turbo brush is the best choice for you. Or, you can order a separate turbo brush for your vacuum.
The Pet Hair Eraser comes with a unique set of tools. The Pet TurboEraser Tool provides portability for help with different areas of your home. Attach the tool to the handle to pick up pet hair on your stairs. For couches and pillows, this tool also has you covered.
These filters can be hand washed in warm water. A mild detergent may also be used. Close the lid and return the tank back to the vacuum. Press firmly until you hear a “click”.
Long Lasting 30 Minute Battery

The powerful 36V Li-Ion battery gives 30 minutes of cordless cleaning time, without being tied to a plug socket or getting tangled in the cord.

Overall, Bissell is a popular vacuum brand for a reason – these vacuums are dependable and last up to two years without issue. However, some models are better than others when it comes to cleaning different surfaces.
Turbobrush vs. Powerbrush – A turbobrush is air-driven, while a powerbrush is electrically-driven. Though turbobrushes work well for low to medium pile carpet, if your home has high pile carpet or wall-to-wall carpet, you`ll probably want a powerbrush.
A possible cause might be that the tank is not properly seated. To assure the tank is seated properly, pick it up and re-seat is so it sits snugly on the unit. If this doesn`t fix the problem, make sure the tank is assembled properly. To make sure they are both latched properly, pick the tank up by its handle.
A possible cause might be that the tank is not properly seated. To assure the tank is seated properly, pick it up and re-seat is so it sits snugly on the unit. If this doesn`t fix the problem, make sure the tank is assembled properly. To make sure they are both latched properly, pick the tank up by its handle.
The battery lasts about 20 minutes, which is good enough for most tasks and should be enough to clean your car with.
The battery lasts about 20 minutes, which is good enough for most tasks and should be enough to clean your car with.
Your vacuum`s roller is clogged

To check your machine`s roller, you need to unplug or turn off the vacuum first and then turn the vacuum upside down and open it. Now that you can see the roller of your vacuum, you can pull out the dog hair or the dirt that accumulated in the roller.

The battery lasts about 20 minutes, which is good enough for most tasks and should be enough to clean your car with.
A possible cause might be that the tank is not properly seated. To assure the tank is seated properly, pick it up and re-seat is so it sits snugly on the unit. If this doesn`t fix the problem, make sure the tank is assembled properly. To make sure they are both latched properly, pick the tank up by its handle.
The battery lasts about 20 minutes, which is good enough for most tasks and should be enough to clean your car with.
A possible cause might be that the tank is not properly seated. To assure the tank is seated properly, pick it up and re-seat is so it sits snugly on the unit. If this doesn`t fix the problem, make sure the tank is assembled properly. To make sure they are both latched properly, pick the tank up by its handle.
A possible cause might be that the tank is not properly seated. To assure the tank is seated properly, pick it up and re-seat is so it sits snugly on the unit. If this doesn`t fix the problem, make sure the tank is assembled properly. To make sure they are both latched properly, pick the tank up by its handle.
A possible cause might be that the tank is not properly seated. To assure the tank is seated properly, pick it up and re-seat is so it sits snugly on the unit. If this doesn`t fix the problem, make sure the tank is assembled properly. To make sure they are both latched properly, pick the tank up by its handle.
A possible cause might be that the tank is not properly seated. To assure the tank is seated properly, pick it up and re-seat is so it sits snugly on the unit. If this doesn`t fix the problem, make sure the tank is assembled properly. To make sure they are both latched properly, pick the tank up by its handle.
Rinse the filter

Any fine dust remaining in the filter can usually be removed with a gentle rinse under a cold tap – hold the filter under the running water until the water runs clear. You shouldn`t need to use any detergent – just water.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

Making a loud jet engine sound – Bissell Upright Vacuum – The Pet Hair Eraser 1 ea Vacuum
ANSWER : We had this problem also, the easy fix for us was taking out the soil container, then reach in and grab the gray cylinder and twist left to unlock it. pull it out, sometimes pet hair clogs the ports that make the cyclone action. Once you clean it out, put it back in and twist to lock position. There is a little lock/unlock indicator on that gray cylinder. Hope this helps, it fixed our “jet engine.”

I purchased a brand new Eureka Pet vacuum, sorry don’t know exact name but it the one that has the self cleaning duster on it. Last night I used the vacuum on my carpet, it was working fine until I accidently sucked up the corner of a scarf that was hanging off a couch. I shut the vacuum off, pulled out the scarf and and resumed vacuuming. Much to my dismay the suction on the vacuum had ceased. Can you tell me if there is a reset button on the vacuum? The vacuum does not appear to be damage
ANSWER : If the motor is running, there should be suction. Possible problems depend on whether it’s a canister or upright and are:
.A clog in the hose, UR or canister. Detach hose. Drop small coin in one end and lift hose causing it to roll out the other. If it does, no clog in hose. Drop same coin into hose opening on power head. If it rolls out, no clog in PN.
.Broken fan blades, UR. Needs to be taken to shop for repair/replacement.
.
.A reset button is for use if the motor isn’t running, so won’t have anything to do with the suction.

No suction and is not clogged – Bissell Upright Vacuum – The Pet Hair Eraser 1 ea Vacuum
ANSWER : The motor is bad, when these type of electrical motors go bad the power of the vaccum dies but the motor can still sound like it is running. One way to tell the motor is shot, is the motor while running will be a might louder than it was originally.

Dirt devil vacuum cleaner–trouble vacuuming dirt and pet hair on carpeting –is the problem with the spinning brush which contacts the floor,  not contacting the carpeting??  I thought (when I bought this vacuum) that the aforementioned brush was adjustable to various heights of carpeting.  Sometimes, it seems like nothing is being vacuumed up –unless I have just put a new bag on the vacuum… Do I need or can I replace the spinning brush on the bottom of the vacuum so it kicks up and vacuums
ANSWER : Try replacing the belt. Rubber belts stretch out after about a year.

Bissell Pet Hair Erase does not vacuum.
ANSWER : It is because the belt is worn or stretched and needs to be replaced. Here are the belts you need and the manual which has instructions:

Bissell Pet Hair Eraser Belts and Manual

Bissell Lift OfF Brush Roller Stops Rotating
ANSWER : They make the worst machines, the rollers are cheap and they make it so you cant take them apart to clean them. You don’t want a dyson either, they aren’t any better for pets. With all that hardwood floors you should get a good canister vacuum, sebo and miele are the best.

My Bissell will not **** up pet hair or dirt – Bissell 37604 Lift-Off Pet Bagless Upright / Canister Vacuum CleanerVacuum
ANSWER : Hello,
.Dirt hair and such will build up in the hoses of that vacum. Take them apart stretch them out and run something through them to make sure they are clean.
.The other problem is the filter in the bottom of the cup. At least on some models there is a filter that gets totally pligged with dirt and dust. Take it apart, wash it out and them put everything back together.
.
.Heatman101

Suction Problem I was vacuuming and stopped to empty the cannister. When I started vacuuming again – the suction wasn’t working properly. The vacuum was just pushing stuff around the floor. I cleaned the hair out the brush on the bottom and it still isn’t working. It was working fine before I emptied the tube 🙁 I can’t figure out what happened.Help!
ANSWER : Greetings from GoVacuum,
.
.I believe what may have happened is that your vacuum cleaner belt has either broken, or been stretched so far that ithe brushes are no longer spinning fast enough.
.
.Here’s what you should do to diagnose this problem.
.
.1. Take the suction hose out of the back of the vacuum (assuming that your vacuum has on-board tools), and see if you have any suction coming from the hose. If you do, this indicates your belt is bad.
.
.2. If you don’t have suction coming from the hose, then it may be something as simple as replacing the filters, to a clog in the vacuum, or to your motor going bad.
.
.In my professional opinion though I would say from what you stated that the belt is mostly likely going to be your issue. If you can provide me the model number of your vacuum cleaner, I can walk you through step by step on ow to replace the belt.
.
.I have posted a short YouTube video on a vacuum belt change, this is not for all vacuums, but it will give you some idea of how to change a belt;
.
.
.
.

Thanks, and if you have questions about your particular model, please feel free to contact me at
.
.[email protected]
.1-866-468-2288