Vacuums\015 How to remove mop head to wash\015

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

Always rinse wet and sponge mop heads well after use, using warm water. Be sure to dry handle when done. Always use available swivel hanger cap when storing.
Always rinse wet and sponge mop heads well after use, using warm water. Be sure to dry handle when done. Always use available swivel hanger cap when storing.
Always rinse wet and sponge mop heads well after use, using warm water. Be sure to dry handle when done. Always use available swivel hanger cap when storing.
If you cannot remove your mop`s head, fill a bucket with equal parts water and bleach. Then dunk your mop into the solution and let it sit for at least 15 minutes. After the soak, rinse the mop until the water runs clear to make sure to neutralize all the bleach.
With proper maintenance and cleaning, mop heads can last between 15 – 30 washes. In domestic environments, mop heads will need to be changed less regularly still. However, it`s still recommended that you clean your mop heads after every use to ensure bacteria doesn`t multiply.
Recycled Towel Mop Head. Fold old used towel in half lengthwise, make a straight stitch about three inches from the top of the fold. Feed a shoestring through the casing, cut bottom into strips then tie around an old mop head. Use, remove and throw in the washer!!
Always rinse wet and sponge mop heads well after use, using warm water. Be sure to dry handle when done. Always use available swivel hanger cap when storing.
Always rinse wet and sponge mop heads well after use, using warm water. Be sure to dry handle when done. Always use available swivel hanger cap when storing.
Always rinse wet and sponge mop heads well after use, using warm water. Be sure to dry handle when done. Always use available swivel hanger cap when storing.
Always rinse wet and sponge mop heads well after use, using warm water. Be sure to dry handle when done. Always use available swivel hanger cap when storing.
Always rinse wet and sponge mop heads well after use, using warm water. Be sure to dry handle when done. Always use available swivel hanger cap when storing.
Always rinse wet and sponge mop heads well after use, using warm water. Be sure to dry handle when done. Always use available swivel hanger cap when storing.
Always rinse wet and sponge mop heads well after use, using warm water. Be sure to dry handle when done. Always use available swivel hanger cap when storing.
Dust mop heads should only be laundered after they have become soiled or very dirty. Wash them on a gentle cycle using hot water and a mild detergent. Then, squeeze out any excess water and hang them up on a line or rack to dry completely before reusing them.
Microfiber is a synthetic material that is made up of tiny fibers that are woven together to form an effective cleaning surface. Much finer than cotton, the microfiber strands can get into all the nooks and crannies of a floor that a cotton mop can`t.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

For some reason, our shark steam mop stop working. Usually after I plug the steam mop, the power light would light up then you would hear & see steam coming out of the mop’s head but all of
ANSWER : HEATING ELEMENTS BURNT OUT. WILL COST OVER $100. TOFIX. SHARK NOW HAS A NEW MODEL “SHARK 3” MUCH BETTER

Read Full Q/A … : Vacuums

Kenwood Steam mop
ANSWER : The Manufacturer suggests you clean the hose by removing the water tank dammed if u can get it off though.

Read Full Q/A … : Vacuums

My older Dyson DC14 (the purple one) early model with a clutch on the beater bar belt needs a clutch replacement. The bar has been cleaned and there are no worn or damaged parts so I conclude that the clutch at the motor end of the belt needs to be replaced. I can find the part online but no instructions on how to disassemble the vacuum to get to and replace it. Dysons only advice is to give me the address and phone of the nearest service center. Can you help me?
ANSWER : Have a look at www.dysonmedic.com which has some very useful info on dismantling and repairing Dysons.
.
.Although this site doesnt actually cover the DC14 yet, the DC14 is very similar to the DC07 so as regards dissassembling the machine, and replacing the clutch, my experience is that the DC07 info will enable you to do the job.

Read Full Q/A … : Vacuums

I loved my Shark Steam Pocket Mop, but it suddenly stopped producing steam through the mop heads. The water is heating and I can see and hear steam coming out of the actually body of the mop, but it will not go through to the head. I have thought of running white vinegar through it. Do you have any suggestions?
ANSWER : Hi,

Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head…

Euro-Pro Shark Steam Mop Problem

Here also is a link to get any of the Shark Manuals that you need.

heatman101

Read Full Q/A … : Vacuums

When i attached the mop head and begin to mop, water comes leaking out of the unit. I have tried different mop heads and it is doing the same with all. is this a common problem with the shark? i’ve owned it less than a year.
ANSWER :

.
.
.

Hi,

Here.is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it.may not be getting steam to the head…

Euro-Pro.Shark Steam Mop Problem

Here.also is a link to get any of the Shark.Manuals.that you need.

heatman101

Read Full Q/A … : Vacuums

I HAVE LOST MY INSTRUCTION BOOK FOR THE STEAM VAC SPIN AND SCRUB. I WANT TO USE THE STAIR ATTACHMENT, BUT I CAN’T FIGURE OUT HOW TO HOOK IT UP, OR OPERATE IT. I SEE WHERE THE PLUG IN PART GOES IN THE FRONT OF THE MACHINE, BUT I CAN’T GET THE OTHER PART TO SLIDE INTO PLACE ON THE FRONT OF THE RESOVIOR TANK AFTER I REMOVE THE FRONT PANEL, AS THE DIRECTIONS ON THE FRONT OF THE RECOVERY TANK SAY TO DO. THE FIT IS JUST TOO TIGHT. WHAT AM I DON’T WRONG- OR HOW COULD I GET A REPLACEMENT INSTRUCTION BOO
ANSWER : You can download a PDF version of the manual at the link below. I believe you can contact Hoover as well and they might mail you one.

http://www.hoover.com/CustomerService/Manuals/Default.aspx

Good Luck!

Read Full Q/A … : Vacuums

Replace belt i need to replace the belt on an upright dirt devil 086310 vaccume but do not have a manual and can not find how to open the assy to replace the belt
ANSWER : On the bottom, there should be a few screws to remove to remove the plate covering the brush roll. However some may have screws on the top housing to remove the top.

Read Full Q/A … : Vacuums

I bought a Bissell Poweredge Pet vacuum from target. There were no boxed products so I took it off the shelf. The instructions are in the clear filter, but I can’t get the vacuum to release and let me get the instructions. How do I ge the instruction pamphlet out of the clear filter portion of the vacuum?
ANSWER : Hi,

If you go to this website, http://www.bissell.com/poweredge-hard-floor-vacuum/
you can download a manual for you vacuum. Look on the right side of page for “downloadable documents and click on the manual.
This will give you instructions so you can take the filter apart.

Hope this helps,

Handie Andie

Read Full Q/A … : Vacuums