Shark Euro-Pro cordless vacuum won't start

Vacuums\015 Vacuum quit working. Three lights flashing on it. Will not start again.I also can’t get my Shark to start. I replaced the battery and charged it overnight, but it made no difference. I get only the three flashing lights. It is Model V1917.\015

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

Check for a clogged hose or filter; unclog the hose and replace the filter, Wait 45 minutes for the vacuum to cool; then plug in the vacuum, Turn the power switch to the `I-On` position to start the vacuum. If the vacuum still does not start, contact Customer Service at 1-800-798-7398.

Check that the vacuum cleaner is plugged into a working power outlet and that fuses and breakers don`t need resetting. An activated thermal cut-out due to a blockage is the next most likely cause of the problem. Check for blockages in the hose and filters, and remove any obstructions that you find.

Besides getting jammed with dirt and debris, the major problem that cordless vacuums face is a weak battery or failing recharger. Some cordless vacuum batteries are easily replaced while others are not and require that the entire unit be replaced.

The vacuum has a safety feature that turns off the vacuum when the vacuum gets to a certain high temperature or overheats. This happens because the vacuum has a motor protective thermostat. If the vacuum turns off due to overheating, the thermostat has to be reset before you can use it again.

To reset your shark vacuum, put the Power button in the On-Off position and keep the vacuum unplugged. If necessary, clear the hose. Once it has cooled completely, plug the vacuum back in again. Our virtual experts can diagnose your issue and resolve simple problems.

Overheated Motor

If your vacuum was working fine and then suddenly shut off, it may have overheated. Most vacuums are equipped with a thermal protector safety switch that won`t allow the motor to run when it becomes overheated. You will need to wait for 30 minutes to 2 hours, depending on your machine, to try again.

Sometimes the battery may have gotten dirty or slipped away from its contacts inside the Shark robot vacuum. Cleaning and repositioning it may fix your problem. But if it`s an old battery or there are clear signs of damage, you should order a replacement battery that matches your model.

Check both ends of the tube for any debris that may clog the machine. Make sure to empty dirt bin and clean the filters if they are dirty. If you experience no suction when using a tool, remove the tool and check each opening for clogging.

All cordless vacuums have limited battery life and need to be recharged. On average, you can expect a cordless vacuums` battery to last between 15 to 40 minutes, which is hopefully all it takes to clean your floors or furniture. Once the battery dies, expect to charge it anywhere from 2 to 16 hours.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

Won’t start. My son was using the vacuum & Didn’t change the bag. The vacuum was making the full bag smell, but the light was’t on & it didn’t stop. I stopped him, changed the bag, checked the filter, closed the compartments & turned on the vacuum. Nothing happened. I checked to be sure that it was plugged in, that wasn’t the problem. I’ve let the vacuum “rest” for several days, It still won’t start. Any suggestions?

ANSWER : There is a reset button at the back of the powerhead. The user manual can be downloaded from the electrolux website, although I didn’t find it very useful. There was some info on how to change the powerhead drive belt.

Read Full Q/A … : Vacuums

Dirt devil vacuum cleaner–trouble vacuuming dirt and pet hair on carpeting –is the problem with the spinning brush which contacts the floor, not contacting the carpeting?? I thought (when I bought this vacuum) that the aforementioned brush was adjustable to various heights of carpeting. Sometimes, it seems like nothing is being vacuumed up –unless I have just put a new bag on the vacuum… Do I need or can I replace the spinning brush on the bottom of the vacuum so it kicks up and vacuums

ANSWER : Try replacing the belt. Rubber belts stretch out after about a year.

Read Full Q/A … : Vacuums

Infinity Vaccum by Shark, model number NV31COS, will not start. The vacuum was running just fine until it grabbed the edge of a curtain. Turned it off to release the suction. Turned it back on and was working fine. About a minute later the vacuum was making an odd noise. Every 2 seconds or so it would “heave” (lack of a better word) then go away, then come back and so on. Turned the vacuum off and checked for blockage, none that could be seen or felt, and now the vacuum won’t turn. Any suggestio

ANSWER : Carpet brush won’t turn when vac on

Read Full Q/A … : Vacuums

I purchased a brand new Eureka Pet vacuum, sorry don’t know exact name but it the one that has the self cleaning duster on it. Last night I used the vacuum on my carpet, it was working fine until I accidently sucked up the corner of a scarf that was hanging off a couch. I shut the vacuum off, pulled out the scarf and and resumed vacuuming. Much to my dismay the suction on the vacuum had ceased. Can you tell me if there is a reset button on the vacuum? The vacuum does not appear to be damage

ANSWER : If the motor is running, there should be suction. Possible problems depend on whether it’s a canister or upright and are:
.A clog in the hose, UR or canister. Detach hose. Drop small coin in one end and lift hose causing it to roll out the other. If it does, no clog in hose. Drop same coin into hose opening on power head. If it rolls out, no clog in PN.
.Broken fan blades, UR. Needs to be taken to shop for repair/replacement.
.
.A reset button is for use if the motor isn’t running, so won’t have anything to do with the suction.

Read Full Q/A … : Vacuums

Shark Euro-Pro cordless vacuum won’t start

ANSWER : Sounds like it needs to be serviced. Call customer service here to help you. .
.
.
.Tel: 1 866 98SHARK (1 866 987-4275)
.
.Is it still under the 1 year warranty.
.
.Good Luck and Please Rate FixYa!
.

Read Full Q/A … : Vacuums

Electrolux Epic 6500SR Full Bag sensor working, Does not Reset properly

ANSWER : The problem was a sticking switch that was not being reset. The vacuum on/off switch mechanism is comprised of two switches. One is the main switch that turns the vacuum on and off. The second is a shut off switch that gets tripped when the full bag sensor is engaged. This second switch is supposed to get reset when you push the on/off switch on the outside of the machine. The full bag shutoff switch was stiff and it, therefore, was taking a couple of presses of the on/off switch to move the shutoff switch back into the running position.

Read Full Q/A … : Vacuums

Clogged vacuum Rather stupidly, my boyfriend 1) were vacuuming without a bag and 2) vacuumed up a big piece of cotton from a sofa cushion. And now it’s making a horrible noise and I see it vibrating where the tube connects to the machine. When you look inside there’s a white thing sticking out but it looks like it’s part of the vacuum. If it’s a clog, how do you fix it? I tried unscrewing the tray the bag sits in but it won’t budge.

ANSWER : You can start by taking off the bottom plate or top cover, which ever comes off, that is where the inlet starts going in and hopefully the clog is there. Could be in the hose also. But without the complete model number I can’t look it up to see a picture of it.

Read Full Q/A … : Vacuums

Hi folks,
my beam vacuum makes a very loud roaring noise quite often.
the problem started when i was vacuuming up a quantity of vermiculite from my chimney.
i think i overloaded the vacuum i think and it made this loud roaring noise.
the vacuum tends to make thos noise when i am hoovering after 5 minutes or so.
any ideas?.
thanks in advance Tom….

ANSWER : If the filter bag is bad and didn’t trap all of the dust, then it got into your motor, so you may have a problem with your motor now.

Read Full Q/A … : Vacuums