Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum\015 Replaced filters, dust bag and attached bounce sheet behind fliter sears part no. 20-86884, for good smell. It runs for a while then I heard a deep roars and the suctions stops. Is the motor dead or just the on/off swtich part no. 4368653 needs replacement. The protector springs is okay. Thanks. Ed [email protected]\015

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

How long do Kenmore vacuums last? A. It`s suggested that the typical vacuum can last up to an average of eight years. With proper maintenance, a Kenmore vacuum could last that long or longer.
Check service panel for tripped breakers/blown fuses. If breaker is tripped, reset it. If fuse is blown, replace it. If vacuum cleaner is plugged in, be sure power button is in the off position before resetting breaker/changing fuse.
Over time and extended use, a very fine layer of particles will start to line the inside of a vacuum bag, remaining in place even after the bag is emptied. This means that the bag will lose the proper airflow required to let the incoming air escape. As the airflow is restricted, the suction dies down too.
The average life expectancy of a mid-range vacuum cleaner is about six years. You can fix or replace things like blocked filters, jammed brush rolls, frayed hoses, worn-out stick vac batteries and broken accessories yourself.
Vacuum cleaners are fairly simple machines. They need power to be transmitted to the vacuum to create a suction force that lifts debris. So, the usual areas that cause suction loss include the wrong height setting, stuck rollers, a faulty gasket, a broken vacuum belt, a filled bag, or a clogged hose.
One caveat: Handling this vacuum`s 23 pounds takes some muscle. In our member survey, Kenmore canisters earned a very good score for predicted reliability and an average rating for owner satisfaction.
At only 14lbs, the 2-motor vacuum cleaner provides 10ft of extended reach for cleaning above floors, stairs and other hard-to-access areas. The versatile 3-in-1 combination tool includes a crevice tool, dusting brush and an upholstery tool to lift pet hair from couches to curtains to baseboards.
CFM is the the speed of the air flow. CFM equates to a car`s top speed. Suction Lift is the measurement of the vacuum`s ultimate power. This can be compares to a car`s horsepower.
Commercial vacuum cleaners are mostly larger in size, with greater suction power but less energy consumption. They are heavier as well because of the more sturdy materials used to manufacture them. Regular vacuum cleaners are usually lightweight, so it is easy for the users to carry them around the house.
If the motor filter (located below the bag) is dirty, hand wash with soapy water. Rinse with clear water, squeeze out excess water, and allow it to dry completely before returning it to the vacuum. Insert a new dust bag and close the cover.
The most common cause of loss of suction is that the filters have become blocked. They may require cleaning or replacing. Another cause could be that the vacuum cleaner hose is blocked.
One of the easiest ways to increase vacuum cleaner suction is to empty the dust bag or container. Dust containers need to have enough space for airflow, otherwise, they could get clogged and have less suction power. Regularly check your dust compartment and empty or change it when it`s already 70-80% full.
It`s Losing Suction

A vacuum cleaner that is in good working order should have excellent suction and be able to clean up everyday dust and debris from around your home with ease. If you notice that your vacuum is starting to lose suction, it could be a sign that you are due for a replacement.

The bottom line. Many vacuum brands recommend changing the bag before it becomes full, at least every three months. The purpose of changing the vacuum bag when you need to is so that your vacuum cleaner is working at an optimal level.
Boil old suction cups to revive them.

Take the pot off of heat and drop your suction cups in for about 30 seconds. Take them out with a pair of tongs and pat them dry on a lint-free towel. Try to use the suction cups right after you dry so they`re still warm and flexible.

Kenmore is a recognized brand in the appliance industry and has been around over 100 years. Kenmore offers high-quality refrigerators in a wide range of sizes and models at affordable prices. Variety: Kenmore offers a huge selection of appliances, from mini-refrigerators to giant, commercial appliances.
As of 2017, Kenmore products are produced by manufacturers including Whirlpool, Samsung, LG, Electrolux, Panasonic, Cleva North America, and Winia Electronics. Today, the majority of the brand`s portfolio is sold at Sears, Kmart, and Amazon.
Several things cause a burning smell, such as a motor part is that broken or worn out, the motor is running too hot, you suck up a burning cigarette, or the rubber belt has snapped. The belt helps turn the brush roller that helps guide dirt and debris into the vacuum.
A perfect vacuum, if measured in absolute terms is zero (0 inches Hg) but is 29.92 in-Hg V (-29.92 in-Hg G) if the measured units are deemed relative (vacuum or gauge).
Upright vacuums can weigh 20 lbs or more. That might not sound like too heavy given that you don`t have to fully lift them off the ground very often. But their weight becomes more and more noticeable the longer you vacuum. However, there are some lightweight upright models weighing just 10 pounds.
Suction pressure should be kept at less than 200 mmHg in adults. It should be set at 80 mmHg to 120 mmHg in neonates.
The suction is 22Kpa which is very powerful, easily to pick up the hair, dust and sand in a short time.
Bagged Vacuums

A benefit of vacuum cleaner bags is that there is minimal contact with the dust and allergens. Just slip out the old bag and throw it away. No-fuss and no mess. Bagged vacuum cleaners also tend to hold a couple of pounds of dirt and debris and tend to better at deep cleaning.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

Dirt devil vacuum cleaner–trouble vacuuming dirt and pet hair on carpeting –is the problem with the spinning brush which contacts the floor,  not contacting the carpeting??  I thought (when I bought this vacuum) that the aforementioned brush was adjustable to various heights of carpeting.  Sometimes, it seems like nothing is being vacuumed up –unless I have just put a new bag on the vacuum… Do I need or can I replace the spinning brush on the bottom of the vacuum so it kicks up and vacuums
ANSWER : Try replacing the belt. Rubber belts stretch out after about a year.

I purchased a brand new Eureka Pet vacuum, sorry don’t know exact name but it the one that has the self cleaning duster on it. Last night I used the vacuum on my carpet, it was working fine until I accidently sucked up the corner of a scarf that was hanging off a couch. I shut the vacuum off, pulled out the scarf and and resumed vacuuming. Much to my dismay the suction on the vacuum had ceased. Can you tell me if there is a reset button on the vacuum? The vacuum does not appear to be damage
ANSWER : If the motor is running, there should be suction. Possible problems depend on whether it’s a canister or upright and are:
.A clog in the hose, UR or canister. Detach hose. Drop small coin in one end and lift hose causing it to roll out the other. If it does, no clog in hose. Drop same coin into hose opening on power head. If it rolls out, no clog in PN.
.Broken fan blades, UR. Needs to be taken to shop for repair/replacement.
.
.A reset button is for use if the motor isn’t running, so won’t have anything to do with the suction.

I have a Kirby G4 Vacuum Cleaner – MOdel G4 D. I have never had any problems or repairs done to it in the past ten plus years that I’ve had it. This is an upright vacuum. I was vacuuming the carpet floor and was not having any trouble at all. I switched the vacuum off and moved it into a different room. When I tried to turn on the vacuum, it would not turn on. I checked with different outlets, used both front attachment and hose attachment. Checked the front part of the motor/ spiral case. This
ANSWER : Hello,
.My educated guess is that it’s either the switch or the power cord. Here are a couple of guides to help with diagnosis and repair…
.
.http://reviews.ebay.com/COMMON-PROBLEMS-WITH-THE-KIRBY-VACUUM-TROUBLESHOOTING_W0QQugidZ10000000003800312
.
.http://reviews.ebay.com/REPLACING-THE-POWER-SWITCH-ON-ANY-KIRBY-G-SERIES-VACUUM_W0QQugidZ10000000003752018
.
.Hope this helps!!
.Marci

Need Kirby Generation 3 Vacuum cleaner manual. Vacuum is not picking up dirt from floor. Seems to have enough suction to inflate the bag, but when you check the suction under the vacuum, there seems to be extremely litle suction.
ANSWER : If your brush roll is turning and your bag is not overly full, then the only other thing it can be is a clog where the bag connects to the vacuum. Turn the plastic part out away from vacuum and lift off to see if you have something clogging it. It would have to be something big, but not so big that it could not get past the fan. As a rule of thumb, KIRBY never clogs. I suspect that your belt is stretched out and your brush roll is not turning while on the carpet so the brush roll is just in the way rather than brushing your carpet to pick up dirt.

NO SUCTION My Electrolux Z2274 upright vacuum cleaner has lost it’s suction and is very noisy. Have checked and rechecked there is no blockage. Have cleaned the filters. In fact done everything I can think of. Any one know why and how to fix this??
ANSWER : If you have no suction, there are only a couple of things that could cause it. As you have checked for blockage, and changed your filters, you may have a vacuum motor with bad bearings, or broken fan blades (inside/on the vacuum motor). Either symptom points towards a vacuum motor being bad and needing replaced.

I have a Kenmore canister vacuum – model 25614506. Some time ago, I was not able to turn the vacuum off with the on/off switch, but could still use the vacuum. Turned if off/on by pulling the plug. The other day when I went to plug it in, I heard a pop. Now the sweeper runs but the vacuum cleaner does not **** – no air flow. What could be the problem. The cleaner is only 4 years old.
ANSWER : The motor has an inline fuse

Suction problem I have a Hoover Widepath Fold Away, 12 amp motor vacuum cleaner and the problem I am having is every time I vacuum, the vacuum gets clogged up with carpet. I am probably only able to do one stroke then it gets clogged and I have to stop and unclog it or it spits it out on the carpet. This is very frustrating and I don’t get much vacuuming done. Please can you help me. Thank you. Gwen email is [email protected]
ANSWER : Get rid of the carpet its shredding and falling apart.no sence in vacuuming old rotten carpet.or try using a vacuum without a brush roller and just suction

No Suction I have very little or no suction on the cleaner. It suctions o.k. with the hand tool, but not the upright cleaner.
ANSWER : Between the top edge of the clear noozle and the lip of the tank that sits on it, there should be a black oblong gasket, if missing, you will have no suction there. The other is the filter on the tank lid, is it clean?