Kirby G5 Bagged Upright Vacuum\015 I was given this machine but it doesn't have the manual with it.\015
How to Identify and Fix Common Vacuum Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :
The Kirby G5 is one of Kirby`s most popular color by its dark maroon color and sleek design. The most unique feature of the G5 was its “Lexan” fan blade that was redesigned with the help of NASA to increase the overall suction power.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
Can’t find my manual and I need to use the shop vac for water in basement, do I have to change the filter or what
lost my user manual never used it to pick up water. need to know how to puit it in wet mode i want to clean the dirty water out of my pool.
.1. When picking up small amounts of liquid
.the filter may be left in place.
.2. When picking up large amounts of liquid
.we recommend that the filter be
.removed. If the filter is not removed, it
.will become saturated and misting
.may appear in the exhaust.
.3. After using the vac to pick up liquids,
.the filter must be dried to reduce the
.risk of possible mildew and damage to
.4. When the liquid in the drum reaches a
.predetermined level, the float mechanism
.will rise automatically to cut off
.airflow. When this happens, turn off
.the vac, unplug the power cord, and
.empty the drum. You will know that the
.float has risen because vac airflow
.ceases and the motor noise will
.become higher in pitch, due to
.increased motor speed.
.IMPORTANT: To reduce the risk of damage
.to the vac do not run motor with float
.in raised position
.On the front page under Customer Service click on User’s Guides and enter the model number of your unit.
.User Guide will be displayed as a PDF file.
Remove the hose from the front cover and pull the electric cord out 2 or 3 feet. Remove the paper bag. Place the vacuum upside down on a work bench with some kind of pad underneath. Open the bag door and pull the end of the soft plastic rail cover out slightly (on both sides) to expose the rigid plastic side rails underneath. If you look directly at the side rails from the front you will see that the ‘T’ shaped part of each rail slides into a channel that locks the top and bottom halves of the machine together. The rails have notches or barbs on the last half inch or so which keep the rails from sliding out. You will need to get these notches away from the channel by sliding a narrow flat blade screw driver in between the top of the ‘T’ and the channel. Just tap it in and leave it there while you pull the rails out with a pair of needle nose pliers. Next, take a look at the bag door hinges. They have a square hole in the center through which a small tab from the bag compartment pokes through. Take a larger flat blade screwdriver and carefully pry the edge of the hinge away from the tab. This will release the bottom section (which is really on top now of course).
.If you remembered to pull out the two or three feet of cord before you started then you should now have enough slack so that you can lay the bottom section aside.
If you plan to do any electrical work be sure to mark the locations of the wire connections. Electrolux Service Centers are the only source of wiring diagrams and they don’t like to share.
. Be very careful working on the cordwinder. The spring could release and fly out. You might get lucky and discover that the cord is just stuck.If so, just wind the spring so as to get it to take up the cord. If the spring has come loose you will need to replace the entir cord reel