Euro-Pro Shark Steam Mop – Gray/ Purple Vacuum

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

Check to see if there is water in the water tank. If there isn`t, unscrew the water tank cap and use the filling flask to pour distilled water into the tank until it reaches the fill line. Replace the water tank cap and tighten. Power the device on, wait about 30 seconds for the water to heat up, and then try again.
To prolong the life of your steam mop, we recommend using distilled water in the tank. Make sure you only add water to the tank – chemicals or cleaning solutions (including vinegar) may damage the steam mop and could be unsafe. For best results, sweep or vacuum your floors prior to cleaning with your steam mop.
Heating Element. A common cause to your cleaner not producing steam can be a failed heating element. As the heater is used to heat up the water, if that has ruptured or burnt out your steam cleaner will not produce any steam. With the water tank filled and switched on the steamer should sound like a boiling kettle.
The S7005 Shark Steam and Scrub includes: Steam & Scrub Mop, 4 Dirt Grip® Soft Scrub washable pads, 2 washable dusting pads, and filling flask.
Our testing has found that all steam mops remove stains fairly well, with marginal differences, and are likely slightly better than a regular mop and bucket due to the heat and vapour produced by the steam.
– Can be used as a detergent additive to your water or as a ready to use in place of water. Simply fill your water container on the steam mop or Mix 50ml simply steam detergent with 200ml water or 1 part simply steam with 4 parts water.
A: No,because the water is heated up till it becomes Steam!,So You cannot use any type of Cleaners,it must only be water! A: We can assist you with your request. Our Steam Mops are designed for use on all sealed hard-floor surfaces.
The Shark Floor Steamer, also known as the Euro-Pro Shark Steam Mop, is a device for cleaning tile, wood and other hard surface floors that uses heat to lift off stains. It can also be used on carpet with an extra attachment.
We have had some customers who have had their steam cleaners for 5-8 years and are still going strong. For less expensive models like the steam mops or handhelds, you should probably expect more like 3-6 years of consistent use.
Steam mopping over a painted surface is risky, even if the paint layer is sealed. The heat from the steam can cause bubbles beneath the paint, which may then peel. Best to avoid steam mopping on all painted floor surfaces.
check the cap of the water tank to make sure it is correctly and securely attached to the water tank. check your water tank to make sure it is securely and correctly fitted in to the body of the garment steamer – incorrect placement of the water tank can block water from feeding in to the body and boiler of the steamer.
We would like to let you know that you would need to use water with our steam mops. If the unit is used without water it can damage the unit.
Customer Reviews – Shark Steam & Scrub Automatic S6002UK Steam Mop with up to 15 Minutes Run Time – Blue.
It is safe to use on many different types of flooring

The mop heats up fast and is easy to handle. I used this Shark steam mop on my ceramic kitchen floors, but it is also rated for use on sealed hardwood floors, marble, and stone tile.

Mop heads. Mopping the floor is a great way to keep your home looking clean, but it will mean that the mop head will collect bacteria over time. While you should rinse the head after every use, it`s also recommend you replace it every two months.
A selection of attachments is available for every Shark vacuum cleaner, each purposefully designed to fit a specific model, so please check the accessory is compatible with your model before purchase.
The S7005 Shark Steam and Scrub includes: Steam & Scrub Mop, 4 Dirt Grip® Soft Scrub washable pads, 2 washable dusting pads, and filling flask.
The S7005 Shark Steam and Scrub includes: Steam & Scrub Mop, 4 Dirt Grip® Soft Scrub washable pads, 2 washable dusting pads, and filling flask.
Fill the Tank With Vinegar

Fill the tank with distilled white vinegar or cleaning vinegar. Avoid using other types of vinegar because they may have sediment that interferes with the cleaning process.

Do you use a steam mop to clean your floors? If so, adding a few drops of orange, lemon or lavender essential oil on the steam mop cover will not only disinfect the floors, but make your house smell great in the process!!!
If you have hard floors and want a time-saving, deep cleaning solution, a vacuum mop may be worth the investment. If you prefer a more eco-friendly, versatile, and budget-friendly option, a steam mop may be the way to go. Always check customer reviews and warranty information before making a final decision.
Only Use Water in the Reservoir

With the exception of a few models that have dual functions, steam mops are typically designed to be used with water and nothing else. The steam alone does a great job of cleaning the floor. Always read the manual on your mop model thoroughly for complete use guidelines.

But common pantry essentials that are often used for cleaning — like baking soda and vinegar — shouldn`t be mixed either. Unlike the bleach-ammonia mixture, combining soda and vinegar won`t hurt anyone — but don`t expect the mixture to do a good job cleaning, either.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

For some reason, our shark steam mop stop working. Usually after I plug the steam mop, the power light would light up then you would hear & see steam coming out of the mop’s head but all of
ANSWER : HEATING ELEMENTS BURNT OUT. WILL COST OVER $100. TOFIX. SHARK NOW HAS A NEW MODEL “SHARK 3” MUCH BETTER

Shark Steam Mop – Gray/ Purple Vacuum: shark steam mop has water, but there is no steam….
ANSWER : I tried running vinegar through as you would a coffee pot to get rid of hard water scales. This did not work. Then I noticed that the light behind the shark decal on the front of the machine was going off and on. And sure enough as I moved the cord around the light would come off and on. Looking closer I could see the the heat had melted thru some of the cord.I bought mine at Target before xmas last year, throwing away the sales slip after several months so I guess there is nothing I can do about it.

Shark steam mop gets hot but does not steam – Euro-Pro Shark Steam Mop – Gray/ Purple Vacuum
ANSWER : Normal. 0. . . . . . . MicrosoftInternetExplorer4. ...... /* Style Definitions */. table.MsoNormalTable.\011{mso-style-name:”Table Normal”;.\011mso-tstyle-rowband-size:0;.\011mso-tstyle-colband-size:0;.\011mso-style-noshow:yes;.\011mso-style-parent:””;.\011mso-padding-alt:0in 5.4pt 0in 5.4pt;.\011mso-para-margin:0in;.\011mso-para-margin-bottom:.0001pt;.\011mso-pagination:widow-orphan;.\011font-size:10.0pt;.\011font-family:”Times New Roman”;}....
..Hi,
..
.Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it may.not be getting steam to the head…
.
.Euro-Pro Shark Steam Mop Problem
.
.heatman101
.
.
.

Parts replacement We have a Hoover Steam Vac that has a broken part #10 in your picture or Part # 37271035. Does this part cover the whole top section of the Vac? Is it hard to replace? Where can you get the best prices on Hoover parts? I have been on Hoovers website and they don’t even recognize this Steam Vac. which is hard to believe they don’t even recognize their own unit? Thanks Ray
ANSWER : This the hood or top cover. There some screws on the bottom as well as on the top, then it comes off.

My Europro shark steam mop won’t steam, light on but no steam.
ANSWER : Hard water deposits. I ran some white vinegar through mine, like a coffee maker, and it worked for a while, but clogged again. So I unplugged it, let it cool and turned it over in the bathtub and squirted a small amount of Lime-Away into the hole where the steam comes out. Let it soak for 5- 10 minutes and it is working like is is brand new.

Streaks on porcelein tile from shark steam mop
ANSWER : I have the same problem!!! its driving me nuts, i think its the microfibe pads that do it. I used the kenwood steam mop and it didnt have a microfibe cleaning pad on the bottom of it and it cleaned it perfectly, no streaks! because that blew up i have the monster mop and it streaks every time, i ended up wraping a bath towl around the base and mopping with that on it, dont know what else to do?

Shark Steam Mop – Gray/ Purple Vacuum: I left water in the steam mop and now the steam is…
ANSWER : Hi,

Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head…

Euro-Pro Shark Steam Mop Problem

Here also is a link to get any of the Shark Manuals that you need.

heatman101

k

Shark Steam Mop – Gray/ Purple Vacuum: When washing the shark steam mop pads, can I use a…
ANSWER : Normal. 0. . . . . . . MicrosoftInternetExplorer4. ...... /* Style Definitions */. table.MsoNormalTable.\011{mso-style-name:”Table Normal”;.\011mso-tstyle-rowband-size:0;.\011mso-tstyle-colband-size:0;.\011mso-style-noshow:yes;.\011mso-style-parent:””;.\011mso-padding-alt:0in 5.4pt 0in 5.4pt;.\011mso-para-margin:0in;.\011mso-para-margin-bottom:.0001pt;.\011mso-pagination:widow-orphan;.\011font-size:10.0pt;.\011font-family:”Times New Roman”;}....
..Hi,
..

Yes, ammonia should not hurt anything as all of the parts are plastic and there is nothing to corrode…
.
.
.Euro-Pro Shark Steam Mop Problem
.
.heatman101
.
.