Dyson DC07 Bagless Upright Cyclonic Vacuum
How to Identify and Fix Common Vacuum Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :
If it is, turn it off and see if your brush rolls work. Many Dyson units have this feature. Many Dyson units also have a switch which prevents the brush roll from spinning when the vacuum is in the upright position.
Vacuum cleaners specifically designed to clean carpeted floors have motor or turbine driven revolving brush rolls with rows of bristles and sometimes beater bars as well. These brush rolls revolve at a very high speed, agitating the carpet fibers in the process.
Check to make sure the vacuum is switched to the correct mode. The switch should be in the Power and Brushroll mode to make the roller spin. If it is in just the power mode the roller will not move. The brushroll indicator light should be green when working.
While you might feel that this is the reason their products are expensive, you`re highly mistaken. This investment was mainly to accommodate a centre for their 1,200 employees, 22 laboratories, prototyping space, and areas for collaborative work.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
Assuming if you leave it for an hour and come back to it that it works again you have an airflow issue. This machine will cut out if the motor gets too hot. The likely causes are 1. Filters – take them out and give a good clean once dry you can try them again. 2. Blockage – Remove your u-bend and the blockage removal access check for an obstruction.3. Radix assembly is blocked. I will post a link to a YouTube video showing how to address this as it is a bit more difficult.
If your machine wont turn back on after a rest then your options are 1. Cord problem (most likely)2. Switch (unlikely)3. Motor
I have a video for just about all these problems on my youtube channel under VacuumSpot or VacuumSmart. If this is a step in the right direction please lay a thumbs up on the videos 🙂
If you need parts for your dyson in Australia check out VacuumSpot
If you are experiencing a drop in performance, please follow the full diagnostics outlined in the support section on our website at www.dyson.com.
If this does not resolve the issue, please contact our Helpline on 0800 298 0298 (UK) or 1866MYDYSON (US).
Kind regards
Darran
Dyson Customer Service
.
.http://www.dysonmedic.com/DC07%20Folder/DC07%20Motor%20change.html
.
.Reassemble by reversing dissassembly instructions.
Remove the bin and cyclone assembyl by pressing the release button above the word Dyson on the carrying handle towards the machine.
Then hold the bin and cyclone assembly over a dustbin and pull the trigger located underneath the carrying handle which will release the bin base to empty the dust and debris from the bin.
I hope this information is useful to you and should you need any further help or advice, please contact our Helpline on 0800 298 0298 (UK) or 1866MYDYSON (US).
Kind regards
Darran
Dyson Customer Service
I suspect the belt you are to refering to is the one from the clutch to the brush bar. Unfortuenately the other belt is hidden under a plastic cover, so you cant see if it is okay or not without some dismantling. This cover is not easy to remove and requires a Torx driver to under the securing screws.
Have a look at www.dysonmedic.com, but unless you have access to such a tool, probably time to call Dyson or a Vacuum repairer.