Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

How to Identify and Fix Common Vacuum Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :

First, check to make sure the clean tank has water and/or the water & formula mixture in the tank. If your tank is empty, this could be the reason your machine is not spraying. You will need to fill your clean tank again. Reseat the tank and ensure it sits snug on the machine.
Your dirty water tank may not be secured tightly. Check the rubber tab on the dirty water tank and press firmly on all edges to secure it tightly. The accessory hose door also needs to be closed securely. Check the door and make sure it is locked in place.
Naturally, all carpet cleaners will leave some moisture, which will dry out in the hours following the cleaning process. However, if the carpet remains wet long after cleaning, it`s because the final step of that process was insufficient.
To start, first make sure your machine is off and unplugged. Next, remove your dirty water tank by pressing down on the colored tank handle. To empty the tank pull up on the rubber tab and pour out the dirty water. Fill the dirty tank with clean water and shake gently to rinse the inside.
Check the suction inlet on the body of the vacuum and clear it of debris if needed. Remove the hose from the base of the machine and remove any debris as needed. If necessary, you may use a broom handle to unclog the hose by pushing through both openings.
Check the suction inlet on the body of the vacuum and clear it of debris if needed. Remove the hose from the base of the machine and remove any debris as needed. If necessary, you may use a broom handle to unclog the hose by pushing through both openings.
Check the suction inlet on the body of the vacuum and clear it of debris if needed. Remove the hose from the base of the machine and remove any debris as needed. If necessary, you may use a broom handle to unclog the hose by pushing through both openings.
These filters can be hand washed in warm water. A mild detergent may also be used. Close the lid and return the tank back to the vacuum. Press firmly until you hear a “click”.
Bissell Crosswave Pet Pro All in One Wet Dry Vacuum Cleaner

A: Yes, you can leave clean formula/water in the tank when not in use.

Check the suction inlet on the body of the vacuum and clear it of debris if needed. Remove the hose from the base of the machine and remove any debris as needed. If necessary, you may use a broom handle to unclog the hose by pushing through both openings.
Check the suction inlet on the body of the vacuum and clear it of debris if needed. Remove the hose from the base of the machine and remove any debris as needed. If necessary, you may use a broom handle to unclog the hose by pushing through both openings.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

Bissell 9500 ProHeat 2X does not spray water – Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
ANSWER : Hi,

Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem.

Bissell Proheat Upright Wet/Dry Vacuum Problems

heatman101

Read Full Q/A … : Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell proheat 2x not spraying water – Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
ANSWER : Please check the following with liquid in both tanks..

.

– Check to see if the machine will spray through the hose with the setting on tools. If it does, the pump is fine. Continue troubleshooting.
.

– Check for debris on spray tips. Clean them with a soft brush (on old tooth brush works well). The spray tips may be lifted out for easier access.
.

– Ensure the tank lid is properly attached to the bottom of the tank. To attach this properly, remove the Water Tank from the machine. Hook the front window onto the lip of the bottom container and then allow the window with lid to cover the complete tank. Secure the latch on the back of the bottom tank to the back of the tank lid. THE TANK LID CANNOT BE ATTACHED PROPERLY IF THE BOTTOM TANK IS ALREADY INSTALLED IN THE MACHINE.
– Check the bottom of the Water Tank and the Formula Tank to make sure each has a red auto-load gasket attached. Make sure the Water Tank and the Formula Tank are seated properly. Depress the x on this gasket to ensure this depresses and release back out. Liquid from the tank should dispense.
.

– Remove the handle completely and re-attach. Once the handle is re-attached, re-attempt to spray.
.

.

If the machine continues to not spray, check the following:
.

REMOVE THE COLLECTION TANK:
• Make sure the unit is set to water rinse
• Remove the smart mix bottle and fill it with water only
• Place the smart mix bottle into the collection tank reservoir
• Run the unit and try to spray. If the machine sprays, you will be able to see the water level decreasing in the smart mix bottle and you will need to replace the bottom tank. It is possibly warped.
.

Read Full Q/A … : Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum: I have a Bissell proheat 2x deepcleaner 9200 model…
ANSWER : Hi,

Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.

Bissell Proheat Upright Wet/Dry Vacuum Problems

heatman101.
.
.fkj

Read Full Q/A … : Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

How to fix bissell deep cleaner water pump – Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
ANSWER : Hi,

Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.

Bissell Proheat Upright Wet/Dry Vacuum Problems

heatman101 .
.
.fjljkf

Read Full Q/A … : Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissel pro heat 2x wont spray any water – Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
ANSWER : I had the exact same problem with my ProHeat 2. It would spray only through the hose attachment but not on the floor. Cleaning of the spray endings on the floor unit fixed my problem. Either soap deposits or dirt was clogging the spray endings. Here is what to do to clean up the spray endings:
.
.1. Remove the water container from the bottom unit
.2. Look up for two red plastic endings on the bottom unit
.3. Using your fingers to clip sides of an ending, carefully remove it from its slot
.4. Using pliers, release the clamp from plastic ending and remove the red plastic ending from the hose
.5. Clean the ending
.6. Put the ending back on the hose, slide clamp back on the ending
.7. Insert the ending back in its slot
.8. Repeat 3-7 for the other ending
.
.That solved the problem for me!

Read Full Q/A … : Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My bissell proheat 2x isnt letting water out – Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
ANSWER : Hi,

Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.

Bissell Proheat Upright Wet/Dry Vacuum Problems

heatman101 .
.
.hhl

Read Full Q/A … : Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell proheat 2x manual – Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
ANSWER : Hi,

You can download and print the instruction manual in PDF format by clicking this link.

Please note: Adobe PDF Reader is required to view this manual. Click here to download the latest version of Adobe Reader.

Hope this solves your problem. Thanks for using FixYa.

Read Full Q/A … : Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Wont spray water bissell x2 – Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
ANSWER : Does any water comes out maybe it is clagged

Read Full Q/A … : Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Hi, my name is Mea Archer, owner of the vacuum cleaner blog, the niche website that I have developed to provide the most up-to-date news, reviews and the latest advice and information for all things vacuum cleaner related.