Euro-Pro Shark SC-505 Handheld Steam Vacuum\015 Need a part, concentrator nozzle,Euro-pro for steam blaster, Jr\015
How to Identify and Fix Common Vacuum Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced Vacuum Technicians :
A: Hey A. McStyle, As a precaution and to extend the life of your steam mop, we do recommend using distilled water in all of our steam products, especially for folks with naturally hard water, but if you have soft water at home, that should be fine as well.
To prolong the life of your steam mop, we recommend using distilled water in the tank. Make sure you only add water to the tank – chemicals or cleaning solutions (including vinegar) may damage the steam mop and could be unsafe. For best results, sweep or vacuum your floors prior to cleaning with your steam mop.
Simply soak them in a mixture of laundry detergent, baking soda, and hot water, then scrub them clean and rinse. Don`t clean your floors with a dirty mop head!
What Should I Use? Good quality tap water. If you don`t have issues with hard water stains and buildup, your tap water is good.
Filtered Water
Of course, not all chemicals and unwanted materials are filtered out because the process isn`t the same or effective as the one that distilled water goes through. Because of this, you should avoid putting filtered water in your steamer.
Shark Pocket will not make steam
Check that your water tank is full, if you find it is empty, add water. Also check that the tank is free of any cracks or holes that could cause water to leak, and that the tank is properly seated in the device`s housing.
Applicable on SC505, SC505a & SC505N — The Shark Professional Portable Steam Cleaner takes approximately 6 minutes to reach its working temperature and is ready for use when the red light on the side of the unit turns green.
How does a steamer work? Steamers work by heating up water until it becomes steam. The hot steam is then applied through a steam nozzle to a wrinkled fabric to eliminate wrinkles and creases. There are two main types of steamers: upright steamers and handheld steamers.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
The female part of the catch which holds the lid to the accessories compartment closed has broken. This forms part of the handle to the vacuum cleaner.We’ve had the vacuum for less than a year but cant find the receipt so i think i will just have to pay for the parts. What is the part called that i need or the part number and where can i get it from. Many thanks
ANSWER : Even if you do not have the receipt you are still entitled to one or two year warranty.
Since appliance sales are recorded after-sale by manufacturer, you need to contact the manufacturer to validate the warranty and get the replacement.
Since appliance sales are recorded after-sale by manufacturer, you need to contact the manufacturer to validate the warranty and get the replacement.
Here is the website, click on your location and see Contact Us or After Sale Service on website.
Please let me know how it goes.
Read Full Q/A … : Euro-Pro Shark SC-505 Handheld Steam Vacuum
Parts replacement We have a Hoover Steam Vac that has a broken part #10 in your picture or Part # 37271035. Does this part cover the whole top section of the Vac? Is it hard to replace? Where can you get the best prices on Hoover parts? I have been on Hoovers website and they don’t even recognize this Steam Vac. which is hard to believe they don’t even recognize their own unit? Thanks Ray
ANSWER : This the hood or top cover. There some screws on the bottom as well as on the top, then it comes off.
Read Full Q/A … : Euro-Pro Shark SC-505 Handheld Steam Vacuum
Lost Part I have a 6.5 hp 18 gallon shop vac ultra pro. There is a part that goes into the inside of the tank and screws into the collection hose that attaches it to the tank. This part accidentally got thrown away when someone dumped it and now I cannot attach the hose to use the vacuum. Can this part be purchased separately?
ANSWER : I found a manual online for the shop vac and found the part number. Did locate part online.
.Thanks,
.Thanks,
Read Full Q/A … : Euro-Pro Shark SC-505 Handheld Steam Vacuum
Looking for a part for a deli meat slicer model:FS04. The brand name is Savoureux Pro Line. I have not been able to get an address for this company, but I do have a parts list. The part I need is a worm gear. Thank You
ANSWER : Hi, did you ever get the worm gear? I need one for the same machine.
Read Full Q/A … : Euro-Pro Shark SC-505 Handheld Steam Vacuum
My older Dyson DC14 (the purple one) early model with a clutch on the beater bar belt needs a clutch replacement. The bar has been cleaned and there are no worn or damaged parts so I conclude that the clutch at the motor end of the belt needs to be replaced. I can find the part online but no instructions on how to disassemble the vacuum to get to and replace it. Dysons only advice is to give me the address and phone of the nearest service center. Can you help me?
ANSWER : Have a look at www.dysonmedic.com which has some very useful info on dismantling and repairing Dysons.
.
.Although this site doesnt actually cover the DC14 yet, the DC14 is very similar to the DC07 so as regards dissassembling the machine, and replacing the clutch, my experience is that the DC07 info will enable you to do the job.
.
.Although this site doesnt actually cover the DC14 yet, the DC14 is very similar to the DC07 so as regards dissassembling the machine, and replacing the clutch, my experience is that the DC07 info will enable you to do the job.
Read Full Q/A … : Euro-Pro Shark SC-505 Handheld Steam Vacuum
Parts Hi I have the Eurkea steam cleaner model 2450 and was wondering how do you take the front part off where you can see the water sucking up from carpet so this can be cleaned. Also I think the spring in the part that holds the water has come off another part is this able to be fixed or can I just purchase a new water holding tank and if so where?
Thanks
Thanks
ANSWER : Click this link for spare parts
http://www.vacpartswarehouse.com/Eureka-2450-extractor-s/1802.htm
http://www.vacpartswarehouse.com/Eureka-2450-extractor-s/1802.htm
Read Full Q/A … : Euro-Pro Shark SC-505 Handheld Steam Vacuum
Need parts Anyone know where I may find replacement parts for this cleaner? I also need a manual. Thanks
ANSWER : Go to this site they have the schematic and replacement parts..http://www.hescoinc.com/vacuum_cleaner_parts/bissell.html
Read Full Q/A … : Euro-Pro Shark SC-505 Handheld Steam Vacuum
Part needed Need part 22 accessory adapter for Shark Model S 3325 Steam blaster
ANSWER : We need this part , too. If anyone knows the actual part number (as opposed to the manual reference #) I’d love to know. Euro-Pro DOES carry this part, as part of an accessory kit for $20 plus who-knows-what for shipping. It’s highway robbery! They want to gather all your personal info BEFORE they answer your question and then the try to sell you other stuff. I DO NOT want to order anything from them. Any other possibilities? I’m still looking.
Read Full Q/A … : Euro-Pro Shark SC-505 Handheld Steam Vacuum
